DOI QR코드

DOI QR Code

Effects of rock-support and inclined-layer conditions on load carrying behavior of piled rafts

  • Roh, Yanghoon (School of Civil and Environmental Engineering, Yonsei University) ;
  • Kim, Garam (School of Civil and Environmental Engineering, Yonsei University) ;
  • Kim, Incheol (School of Civil and Environmental Engineering, Yonsei University) ;
  • Lee, Junhwan (School of Civil and Environmental Engineering, Yonsei University)
  • 투고 : 2018.07.05
  • 심사 : 2019.06.15
  • 발행 : 2019.07.20

초록

In this study, the load carrying behavior of piled rafts installed in inclined bearing rock layer was investigated for rock-mounted and -socketed conditions. It was found that settlements induced for an inclined bearing rock layer are larger than for a horizontal layer condition. The load capacity of piled rafts for the rock-mounted condition decreased as rock-layer inclination angle (${\theta}$) increased, while vice versa for the rock-socketed condition. The load capacities of raft and piles both decreased with increasing ${\theta}$ for the rock-mounted condition. When bearing rock layer was inclined, loads carried by uphill-side piles were greater than those by downhill-side piles. The values of differential settlements of rock-mounted and -socketed conditions were not significantly different whereas slightly higher for the rock-socketed condition. The values of load sharing ratio (${\alpha}_p$) and its variation with settlement were not markedly changed by the inclination of bedrock. It was shown that ${\alpha}_p$ for piled rafts installed in rock layer was not affected by ${\theta}$ whereas actual loads carried by raft and piles may vary depending on the pile installation and rock-layer inclination conditions.

키워드

과제정보

연구 과제 주관 기관 : Korea Institute of Energy Technology Evaluation and Planning (KETEP), National Research Foundation of Korea (NRF)

참고문헌

  1. AASHTO (1989), Standard Specifications for Highway Bridges, American Association of State Highway and Transportation Officials, Washington, U.S.A.
  2. Al-Omari, R.R., Al-Azzawi, A.A. and Al-Abbas, K.A. (2016), "Behavior of piled rafts overlying a tunnel in sandy soil", Geomech. Eng., 10(5), 599-615. http://dx.doi.org/10.12989/gae.2016.10.5.599.
  3. Basarkar, S.S. and Dewaikar, D.M. (2006), "Load transfer characteristics of socketed piles in Mumbai region", Soils Found., 46(2), 247-257. https://doi.org/10.3208/sandf.46.247.
  4. Bieniawski, Z.T. (1973), "Engineering classification of jointed rock masses", Civ. Eng. South Africa, 15(12), 335-343.
  5. Bieniawski, Z.T. (1978), "Determining rock mass deformabilityexperiences from case histories", Int. J. Rock Mech. Min. Sci. Geomech. Abstr., 15(5), 237-247. https://doi.org/10.1016/0148-9062(78)90956-7.
  6. Carrubba, P. (1997), "Skin friction on large-diameter piles socketed into rock", Can. Geotech. J., 34(2), 230-240. https://doi.org/10.1139/t96-104.
  7. Carter, J.P. and Kulhawy, F.H. (1988), "Analysis and design of drilled shaft foundations socketed into rock", Report No. EL-5918, Electric Power Research Institute, Palo Alto, California, U.S.A.
  8. Chaudhary, M.T.A. (2007), "FEM modelling of a large piled raft for settlement control in weak rock", Eng. Struct., 29(11), 2901-2907. https://doi.org/10.1016/j.engstruct.2007.02.001.
  9. Crapps, D.K. and Schmertmann, J.H. (2002), "Compression top load reaching shaft bottom-theory vs. tests", Proceedings of the International Deep Foundations Congress 2002, Orlando, Florida, U.S.A., February.
  10. Eid, H.T. and Shehada, A.A. (2015), "Estimating the elastic settlement of piled foundations in rock", Int. J. Geomech., 15(3), 04014059. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000376.
  11. Han, J. and Jiang, G. (2011), "Influence of inclined bedrock on undrained bearing capacity of shallow strip foundations", Proceedings of the Geo-Frontiers Congress 2011, Dallas, Texas, U.S.A., March.
  12. Hanna, A.M. and Nguyen, T.Q. (2002), "An axisymmetric model for ultimate capacity of a single pile in sand", Soils Found., 42(2), 47-58. https://doi.org/10.3208/sandf.42.2_47.
  13. Hardin, B.O. and Black, W.L. (1966), "Sand stiffness under various triaxial stresses", J. Soil Mech. Found. Div., 92(2), 27-42. https://doi.org/10.1061/JSFEAQ.0000865
  14. Horvath, R.G. (1982), "Drilled piers socketed into weak shale: methods of improving performance", Ph.D. Dissertation, University of Toronto, Toronto, Canada.
  15. Horvath, R.G. and Chae, K.J. (1989), "Long-term settlement of model rock-socketed piers", Can. Geotech. J., 26(3), 348-358. https://doi.org/10.1139/t89-049.
  16. Horvath, R.G., Kenny, T.C. and Trow, W.A. (1980), "Results of tests to determine shaft resistance of rock-socketed drilled piers", Proceedings of the International Conference on Structural Foundations on Rock, Sydney, Australia, May.
  17. Khanmohammadi, M. and Fakharian, K. (2018), "Evaluation of performance of piled-raft foundations on soft clay: A case study", Geomech. Eng., 14(1), 43-50. https://doi.org/10.12989/gae.2018.14.1.043.
  18. Leong, E.C. and Randolph, M.F. (1994), "Finite element modelling of rock-socketed piles", Int. J. Numer. Anal. Meth. Geomech., 18(1), 25-47. https://doi.org/10.1002/nag.1610180103.
  19. NAVFAC (1982), Foundations and Earth Structures Design Manual 7.2, Navy Facilities Engineering Command; Alexandria, Virginia, U.S.A.
  20. Ng, C.W.W., Yau, T.L.Y., Li, J.H.M. and Tang, W.H. (2001), "Side resistance of large diameter bored piles socketed into decomposed rocks", J. Geotech. Geoenviron. Eng., 127(8), 642-657. https://doi.org/10.1061/(ASCE)1090-0241(2001)127:8(642)
  21. Oweis, I. and Hwang, J. (2010), "Load transfer to micro pile rock socket", Proceedings of GeoFlorida 2010, Orlando, Florida, U.S.A., February.
  22. Park, D. and Lee, J. (2015), "Comparative analysis of various interaction effects for piled rafts in sands using centrifuge tests", J. Geotech. Geoenviron. Eng., 141(1), 04014082. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001183.
  23. PLAXIS (2008), PLAXIS 3D Foundation Version 2.0 Manual, Plaxis BV, Netherlands.
  24. Reese, L.C., Hudson, W.R. and Vijayvergiya, V.N. (1969), "An investigation of the interaction between bored pile and soil", Proceedings of 7th International Conference on Soil Mechanics and Foundation Engineering, Mexico City, Mexico.
  25. Roh, Y., Kim, G., Kim, I., Kim, J., Jeong, S. and Lee, J. (2019), "Lessons learned from field monitoring of instrumented piled raft bearing in rock layer", J. Geotech. Geoenviron. Eng., 145(8), 05019005. https://doi.org/10.1061/(ASCE)GT.1943-5606.0002078.
  26. Rowe, R.K. and Armitage, H.H. (1987), "A design method for drilled piers in soft rock", Can. Geotech. J., 24(1), 126-142. https://doi.org/10.1139/t87-011.
  27. Salgado, R., Bandini, P. and Karim, A. (2000), "Shear strength and stiffness of silty sand", J. Geotech. Geoenviron. Eng., 126(5), 451-462. https://doi.org/10.1061/(ASCE)1090-0241(2000)126:5(451)
  28. Seo, H., Prezzi, M. and Salgado, R. (2013), "Instrumented static load test on rock-socketed micropile", J. Geotech. Geoenviron. Eng., 139(12), 2037-2047. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000946.
  29. Seol, H., Jeong, S. and Cho, S. (2009), "Analytical method for load-transfer characteristics of rock-socketed drilled shafts", J. Geotech. Geoenviron. Eng., 135(6), 778-789. https://doi.org/10.1061/(ASCE)1090-0241(2009)135:6(778).
  30. Serafim, J.L. and Pereira, J.P. (1983), "Consideration of the geomechanical classification of Bieniawski", Proceedings of the International Symposium on Engineering Geology and Underground Constructions, Lisbon, Portugal.
  31. Sinha, A. and Hanna, A.M. (2917), "3D numerical model for piled raft foundation", Int. J. Geomech., 17(2), 04016055. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000674.
  32. Xing, H., Zhang, Z., Meng, M., Luo, Y. and Ye, G. (2014), "Centrifuge tests of superlarge-diameter rock-socketed piles and their bearing characteristics", J. Bridge Eng., 19(6), 04014010. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000582.
  33. Zhang, L. and Einstein, H. (1998), "End bearing capacity of drilled shafts in rock", J. Geotech. Geoenviron. Eng., 124(7), 57-58. https://doi.org/10.1061/(ASCE)1090-0241(1998)124:7(574).
  34. Zhang, L. and Xu, J. (2009), "Axial load transfer behavior of rocksocketed shafts", Proceedings of the International Foundation Congress and Equipment Expo 2009, Orlando, Florida, U.S.A., March.

피인용 문헌

  1. Effect of slope with overburden layer on the bearing behavior of large-diameter rock-socketed piles vol.24, pp.4, 2021, https://doi.org/10.12989/gae.2021.24.4.389