DOI QR코드

DOI QR Code

재생 합성수지 투수블록의 표면온도 저감효과에 관한 실험적 연구

Experimental Study on Reducing Effect for Surface Temperature of Recycled Synthetic-Resin Permeable Block

  • Lee, Chul-Hee (Dept. of Civil and Environmental Engineering, Incheon National University) ;
  • Lee, Arum (Dept. of Civil and Environmental Engineering, Incheon National University) ;
  • Shin, Eun-Chul (Dept. of Civil and Environmental Engineering, Incheon National University) ;
  • Ryu, Byung-Hyun (Korea Institute of Civil Engineering and Building Technology)
  • 투고 : 2018.10.25
  • 심사 : 2019.03.20
  • 발행 : 2019.03.30

초록

본 연구는 기존의 콘크리트 투수블록이 아닌 재활용 합성수지를 활용하여 제작된 투수블록의 열섬현상 완화의 기능성 측면인 표면온도의 저감효과를 확인하고자 야외계측과 실내실험을 진행하였다. 야외계측은 건조한 상태와 습윤상태를 고려하여 3일 동안 계측하였고, 실내실험은 건조 조건, 강우 모사 조건, 표층 습윤 조건 등으로 구분하여 온도의 변화와 실험 후 함수율의 증발비율을 확인하였다. 야외계측 결과, 가뭄이 지속되거나 일정수준의 수분이 표층에 없는 건조한 상태에서는 수분의 증발에 의한 기화잠열로 냉각효과가 발휘되기 보다는 투수블록 표면의 알베도에 의한 차이로 표면의 온도가 감소하는 것을 확인하였다. 실내실험 결과, 재생 합성수지 투수블록(RS 투수블록)은 콘크리트 투수블록보다 건조한 상태일때는 더 높은 표면온도를 기록하였으나 강우 모사조건에서는 공극내 수분의 증발이 모세관력에 의해 지속적으로 유지되어 더 높은 온도 저감율 보이는 것으로 나타났다. 실내실험 후 증발율을 측정한 결과 수분의 증발율이 높을수록 온도의 저감효과는 증가하는 것을 확인하였다. 이 결과를 바탕으로 증발율과 온도의 저감율에 대한 상관관계식을 도출하였다.

The field measurement and laboratory experiment were conducted to investigate the effect of reducing the surface temperature of the functional aspect of the heat island phenomenon of the permeable block which is made the recycled synthetic resin rather than the existing concrete permeable block. Field measurement was taken for 3 days in consideration of dry condition and wet condition and laboratory experiment was divided into dry condition, rainfall simulating condition, and wetting condition. The variations of temperature and the evaporation rate of water moisture content after experiment were confirmed. As a result of field measurement, it is confirmed that the surface temperature decreases due to the difference in albedo of the pore block surface rather than the cooling effect due to the latent heat of vaporization. The evaporation of moisture in a dry state where drought persisted or a certain level of moisture was not maintained in the surface layer. As a result of laboratory experiment, resin permeable block gives higher surface temperature when it is dry condition than concrete permeable block, but the evaporation of water in the pore is kept constant by capillary force in rainfall simulation condition, and higher temperature reduction rate. As a result of measuring the evaporation rate after laboratory experiment, it is confirmed that the effect of reducing temperature is increased as the evaporation rate of water is higher. Based on these results, correlation formula for evaporation rate and temperature reduction rate is derived.

키워드

HKTHB3_2019_v18n1_79_f0001.png 이미지

Fig. 1. Permeability test for RS permeable block

HKTHB3_2019_v18n1_79_f0002.png 이미지

Fig. 2. Stable layer of concrete permeable block

HKTHB3_2019_v18n1_79_f0003.png 이미지

Fig. 3. Location of temperature measurement in the field for various blocks

HKTHB3_2019_v18n1_79_f0004.png 이미지

Fig. 4. Results of field measurement temperature of Case 1 specimens

HKTHB3_2019_v18n1_79_f0005.png 이미지

Fig. 5. Field measurement of temperature after rain

HKTHB3_2019_v18n1_79_f0006.png 이미지

Fig. 7. Indoor temperature measurement test

HKTHB3_2019_v18n1_79_f0007.png 이미지

Fig. 6. Variations of temperature changes depending on condition

HKTHB3_2019_v18n1_79_f0008.png 이미지

Fig. 8. Various cases of indoor temperature measurement test

HKTHB3_2019_v18n1_79_f0009.png 이미지

Fig. 9. Results of measurement temperature on concrete permeable block

HKTHB3_2019_v18n1_79_f0010.png 이미지

Fig. 10. Results of measurement temperature on RS permeable block

HKTHB3_2019_v18n1_79_f0011.png 이미지

Fig. 11. Results of maximum temperature

HKTHB3_2019_v18n1_79_f0012.png 이미지

Fig. 12. Temperature reduction against dry condition

HKTHB3_2019_v18n1_79_f0013.png 이미지

Fig. 13. Difference between center and under block of temperature in various cases

HKTHB3_2019_v18n1_79_f0014.png 이미지

Fig. 14. Temperature reduction by vaporization

HKTHB3_2019_v18n1_79_f0015.png 이미지

Fig. 15. Increasing temperature difference with vaporization

HKTHB3_2019_v18n1_79_f0016.png 이미지

Fig. 16. Correlation between decreasing temperature andvaporization

Table 1. Result of porosity test

HKTHB3_2019_v18n1_79_t0001.png 이미지

Table 2. Result of temperature measurement on the surface of block

HKTHB3_2019_v18n1_79_t0002.png 이미지

참고문헌

  1. Ban, S. S. (1999), An Experimental Study on the Permeability and Engineering Properties of Porous Concrete, Master Degree Thesis, Chungnam National University.
  2. Hong, C. W. (2013), "Properties of Temperature Reduction of Cooling Asphalt Pavements Using High-Reflectivity Paints", Journal of the korean Society of Civil Engineers, Vol.33, No.1, pp.317-327. https://doi.org/10.12652/Ksce.2013.33.1.317
  3. Japan Concrete Institute (1995), Technical committee in ECO concrete, Japan Concrete Institute, pp.56-58, Japan.
  4. Jung, H. S. (2010), Development of Environmental-friendly Water permeability Block and Performance Evaluation, Master Degree Thesis, Hanbat National University.
  5. Kim, C. M. (2011), "Cool Pavement System for Decrease urban Heat Island Effect in the USA", Monthly KOTI Magazine on Transport, Vol.8, pp.85-88.
  6. Kim, I. S., Han, E. S., Park, D. G. and Cho, S. H. (2006), "A Study on the Surface Temperature Reduction of Thermal Insulation Ahphalt Pavement", Korean Society of Road Engineers, pp.71-74.
  7. Lee, D. W., Yun, J. M., Kim, N. S. and Kang, Y. M. (2011), "The Mechanics Properties of Porous Concrete using Recycled Asphalt Aggregate", Journal of Korean Geosynthetics Society, Vol.10, No.1, pp.37-42. https://doi.org/10.12814/JKGSS.2011.10.1.037
  8. Lee, S. W. (2009), A Study to Mitigate Urban Heat Island According to the Improvement of Pavement of Road, Ph.D Thesis, Keimyung University.
  9. Park, D. G., Jung, W. K., Jung, D. W., Baek, J. E and Lee, J. W., (2016), "Evaluation of Field Permeability and Material Characteristics of Permeable Block for Roadway Pavement", Korean Society of Ecology and Infrastructure Engineering, Vol.3, No.2, pp.110-116.
  10. Park, T. S., Jeon, M. S., Cheon J. Y. and Chung, P. G. (2009), "Evaluation of Solar Light Reflective Coating", Korean Society of Road Engineers, pp.29-34.
  11. Ryu, B. H. and Kim, T. H. (2018), "Evaluation of Permeable block using Recycle Synthetic Resin", Korean Geosynthetics Society, Vol.17, No.1, pp.13-19.
  12. Seo, D. W. and Yun, T. S. (2016), "Effect of Bedding Layer and Clogging on Drainage Capacity of Pervious Sidewalk Block in Unsaturated Condition", Journal of the Korean Geotechnical Society, Vol.32, No.5, pp.37-48. https://doi.org/10.7843/KGS.2016.32.5.37
  13. SMG. (2013), Standard for Design, Construction, and Maintenance of Pavement Using Permeable Block. Seoul Metropolitan Government, Seoul, Korea.
  14. So, K. R. (2011), Performance Evaluation of Solar Radiation Pavement Using Acryl Resin, Master Degree Thesis, Sejong University.
  15. You. S. K., Yu, N. J., Cho, S. M. and Shim, N. B. (2007), "Mechanics Characteristics of Porous Concrete using Recycled-Aggregate", Journal of Korean Geosynthetics Society, Vol.6, No.2, pp.17-20.