한국기계가공학회지 (Journal of the Korean Society of Manufacturing Process Engineers)

한국기계가공학회 (The Korean Society of Manufacturing Process Engineers)
권호 표지
DOI QR코드

DOI QR Code

U자형 배관 내 결빙에 대한 해석적 연구

Numerical Analysis of Freezing Phenomena of Water in a U-Type Tube

  • 박용석 (경상대학교 융합기계공학과) ;
  • 서정세 (경상대학교 기계공학부, ReCAPT)
  • Park, Yong-Seok (School of Convergence Mechanical Engineering, Gyeongsang National University) ;
  • Suh, Jeong-Se (School of Mechanical Engineering, Gyeongsang National UNIV.)
  • 투고 : 2019.09.19
  • 심사 : 2019.10.20
  • 발행 : 2019.12.31
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

This study numerically analyzed the icing process in a U-shaped pipe exposed to the outside by considering the mushy zone of freezing water. Numerical results showed that the flow was pulled outward due to the U-shaped bend in the freezing section exposed to the outside, which resulted in the ice wave formation on the wall of the bended pipe behind. At the same time, the formation of a corrugated ice layer became apparent due to the venturi effect caused by the ice. The factors affecting the freezing were investigated, including the change of the pipe wall temperature, the water inflow velocity, and the pipe bend spacing. It was found that, as a whole, the thickness of the freezing layer increased as the pipe wall temperature decreased. It was also found that the freezing layer became relatively thin when the inflow rate of water was increased, and that the spacing of the pipe bends did not significantly impact the change in the freezing layer.

키워드

참고문헌

  1. EPRI, "A Guide for Nuclear Power Plant Maintenance Personnel," Freeze Sealing of Piping, 1989.
  2. Flaman, M. T. and Shah, N. N., "Structural Integrity Investigation of Ice Plugging Procedure on Feeder Pipe," Ontario Hydro Research Division, 1985.
  3. Suh, J.-S., Ro, S. T., “Analysis of Ice - Formation Phenomena for Fully Developed Laminar Water Flow in Concentric Circular - Tube Annuli,” Transaction of Korean Sociey of Mechanical Engineering, Vol. 21, No. 11, pp. 1552-1561, 1997.
  4. Suh, J,-S., "Analysis of Ice - Formation Phenomena for Laminar Water Flow in a Concentric Tube," Proceeding of Air-Conditioning and Refrigeration Engineering, pp.185-190, 1996.
  5. Suh, J.-S., Kim, M. G., Ro, S. T., Lim, C. S., “Ice - Formation Phenomena for Laminar Water Flow in a Stenotic Tube,” Korean Journal of Air-Conditioning and Refrigeration Engineering, Vol. 10, No. 1, pp. 11-21, 1998.
  6. Jeong, G, Ahn, B.,, Choi, B., Kim, K., "Numerical Analysis of Phase Change and Natural Convection Phenomena during Pipe Freezing Process," Proceeding of Korean Sociey of Mechanical Engineering, pp.1263-1269, 2002.
  7. Ohm, K.-C., "Freezing of Water and Generating Pressure of Fluid in Pipe," Journal of College Education, Vol. 2, No. 4, pp. 497-504, 2001.
  8. Yun, J.-H., Kim, J.-H., Jeong, S.-Y., Yang, Y.-S., Kim, S.-H. and Song, D.-Y., "An Experimental Study on the Freezing Protection Valve Using Phase Change Material (PCM) for the Heat Exchanger," Journal of the Korean Solar Energy Society, Vol. 32, No. 6, pp. 127-133, 2012. https://doi.org/10.7836/kses.2012.32.6.127
  9. Choi, M.-Y., Lee, D.-W. and Choi, H.-G., “Numerical Analysis of Unsteady Heat Transfer for the Location Selection of Anti-freeze for the Fire Protection Piping with Electrical Heat Trace,” Journal of Korean Institute of Fire Science and Engineering, Vol. 28, No. 1, pp. 52-57, 2014.
  10. Choi, M.-Y. and Choi, H.-G., "Numerical Analysis of Unsteady Heat Transfer for Location Selection of CPVC Piping.", Journal of Korean Institute of Fire Science and Engineering, Vol. 29, No. 6, pp. 33-39, 2015. https://doi.org/10.7731/KIFSE.2015.29.6.033
  11. Galic, I., Tonkovic, Z. and Vuckovic, K., "Experimental and Numerical Investigation of Collapse and Burst Pressures for a Valve Housing," International Journal for Experimental Mechanics, Vol. 47, pp. 519-524, 2011.
  12. CD-ADAPCO, STARCCM+ User's Manual Version 10.6, Siemens Inc., pp. 5326-5333, 2015.
  13. Kikuchi, Y., Shigemasa, Y., Oe, A. and Ogata, T., "Steady-State Freezing of Liquids in Laminar Flow between Two Parallel Plates," Journal of Nuclear Science and Technology, Vol. 23, pp. 979-991, 1986. https://doi.org/10.1080/18811248.1986.9735086
  14. Lee, C. H. and Suh, J. S., "Numerical Analysis on the Freezing Process of Internal Water Flow in a L-Shape Pipe, Journal of the Korean Society of Manufacturing Process Engineers, Vol. 17, No. 6, pp.144-150, 2018. https://doi.org/10.14775/ksmpe.2018.17.6.144

피인용 문헌

  1. An Analytical Study on the Heat Transfer Characteristics of MF Evaporation Tubes Attached with a Fin vol.20, pp.1, 2021, https://doi.org/10.14775/ksmpe.2021.20.01.048