Journal of the Korean Geosynthetics Society (한국지반신소재학회논문집)

Korean Geosynthetics Society (한국지반신소재학회)
권호 표지
DOI QR코드

DOI QR Code

Applicability of Bearing Capacity for Single Drilled Shaft Using Empirical equation based on Ground Condition

토질특성에 따른 현장타설말뚝 지지력 산정 경험식의 적용성

  • Kim, Daehyeon (Department of Civil Engineering, Chosun Univ.) ;
  • Jeong, Sangguk (Department of Disaster Prevention Safety Civil Engineering, Songwon Univ.)
  • Received : 2019.10.29
  • Accepted : 2019.12.06
  • Published : 2019.12.30
Download PDF
⟨ Previous Next ⟩

Abstract

Friction piles are being constructed in Southeast Asia (Myanmar, Cambodia, Vietnam, etc.) where the soft ground is deep, and many cases of friction piles are accumulated in terms of experience. In this study, we used the results of four static load test and load transfer test conducted in Myanmar sites to analyze the skin friction of soil layer. In addition, we proposed a relationship chart with skin friction measured in the N-value of Standard Penetration Test (SPT) and the load transfer test result of the single drilled shaft. In the case of Myanmar sites, the range of soil layers was deeper than domestic sites, so the conventional formula of skin friction using the N-value of SPT is different from domestic sites. In sandy layer, fs = 0.096 N in Myanmar sites showed a similar result of the domestic fs = 0.106 N. In clayey layer, fs = 0.315 N, in Myanmar sites showed about 5.0 times higher than the domestic fs = 0.062 N. The results of this study are based on limited data. Therefore, if we analyze the results of more load transfer tests, we can suggest a conventional formula for skin friction according to the N-value. It is expected to be used as important basic data in the future.

마찰말뚝의 경우 연약지반이 깊은 동남아 지역(캄보디아, 미얀마, 베트남 등)의 많은 건설현장에서 시공되고 있으며, 경험적인 측면에서도 마찰말뚝에 대한 시공사례가 많이 축적되어 있다. 본 연구에서는 토사층에서 발휘되는 주면마찰력을 비교분석하기 위하여 미얀마 현장에서 시행된 4개소의 정재하시험과 하중전이시험 결과를 이용하였다. 현장타설말뚝의 정재하시험 및 하중전이시험에서 얻어진 주면마찰력과 해당 위치에서의 각각의 표준관입시험(SPT) N치와의 상관관계식을 제안하였다. 미얀마지역은 토사층의 범위가 폭넓게 분포하여 국내 지반조건과 상이한 특성으로 인해 SPT-N값에 의한 각각의 주면마찰력 산정결과가 달라지는 경향을 나타냈다. 사질토 지반에서는 미얀마 지역의 fs=0.096N, 국내에서의 fs=0.106N으로 유사한 결과를 나타냈으나, 점성토 지반조건에서는는 미얀마 지역의 fs=0.315N, 국내에서의 fs=0.062N으로 미얀마 지역의 주면마찰력이 약 5배 정도 높은 값이 얻어졌다. 본 연구의 비교분석자료는 국내·외의 제한된 Data를 통하여 분석한 결과이므로 향후 보다 많은 하중전이시험 결과가 축적된다면, 현장 토질 특성이 반영된 N치에 따른 주면마찰력 산정식을 제안할 수 있을 것이며, 금회 분석한 결과는 이에 대한 선행연구로서 중요한 기초자료로 활용될 수 있을 것으로 판단된다.

Keywords

References

  1. Choi, Y. K., Lee, W. J., Lee, C. U. and Kwon, O. K. (2019), "Study(I) on Development of Charts and Formulae Predicting Allowable Axial Bearing Capacity for Prebored PHC Pile Socketed into Weathered Rock through Sandy Soil Layer", Journal of The Korean Geotechnical Society, Vol.35, No.8, pp.17-30. https://doi.org/10.7843/KGS.2019.35.8.17
  2. Hansen, B. (1957), "Earth Pressure Calculation", Danish Technical Press, Copenhagen, Denmark.
  3. Hong, S. T., Lee, J. I., Shin, Y. W. and Lee, S. H. (2011), "A Study on Skin Friction Estimation of Drilled Shaft Socketed in Weathered Granite by IGM's Theory", Journal of Korean Society of Civil Engineering, Vol.31, No.6, pp.241-250.
  4. Hsiung, Y. M. (2003), "Theoretical Elastic-Plastic Solution for Laterally Loaded Piles", Journal of Geotechnical and Geo-environmental Engineering, Vol.129, No.5, pp.475-480. https://doi.org/10.1061/(ASCE)1090-0241(2003)129:6(475)
  5. Kim, D. H. (2013), Evaluation of Bearing Capacity of Drilled Shaft Socketed in Domestic Layers, Inje University, Master Thesis.
  6. Kim, S. H., Lee, S. C., Lee, J. H. and Kim, M. H. (2001), "Study on The Behavior of Opened Steel Pipe Pile End-beared at Lower Transported Soil Layer", 仁濟論叢, Vol.16, No.1, pp.641-679.
  7. Kim, S. I., Jeong, S. S. and Jung, S. Y. (1994), "A Simplified Method for the Calculation of Skin Friction on Piles in Soft Clay", Journal of Korean Society of Civil Engineering, Vol.14, No.1, pp.171-178.
  8. Kwon, O. K. (2015), "Bearing Behavior Characteristics of Pressure Penetrating Steel Pipe Pile Under Compression Load", Journal of Korean Geo-Environmental Society, Vol.16, No.7, pp.5-13. https://doi.org/10.14481/jkges.2015.16.7.5
  9. Lee, J. H. (2018), Analysis of Influence Factors on The Bearing Capacity of Drilled Shafts in Cohesionless Soil, Chungang University, Master Thesis.
  10. Lee, J. S., Jang, Y. C. and Kim, Y. K. (2002), " A Study on the Allowable Bearing Capacity of Pile by Driving Formulas", Journal of Korean Navigation and Port Research, Vol.26, No.1, pp.106-111. https://doi.org/10.5394/KINPR.2002.26.1.106
  11. Na, Y. S. and Lee, S. D. (2019), "Experimental Study on the End Bearing Capacity of the Pile in a Group Pile", Journal of The Korean Geotechnical Society, Vol.35, No.6, pp.27-38. https://doi.org/10.7843/KGS.2019.35.6.27
  12. Lee, S. J. (2013), "Analysis of Diameter Effects on Skin Friction of Drilled Shaft in Sand", Journal of The Korean Geotechnical Society, Vol.29, No.1, pp.161-170. https://doi.org/10.7843/kgs.2013.29.1.161
  13. Osterberg, J. O. (1998), "The Osterberg Load Test Method for Bored and Driven Piles The First Ten Years", Proceedings of the 7th International Conference on Piling and Deep Foundations, Vienna, Vol.1, No.28, pp.1-11.
  14. Paik, J. Y., Cho, J. Y., Jeong, S. S. and Hwang, T. J. (2012), "Shaft Group Efficiency of Friction Pile Groups in Deeps Soft Clay", Journal of Korean Society of Civil Engineering, Vol.32, No.2, pp.49-60.
  15. Park, J. B. (2017), "A Comparative Study on the Bearing Capacity of Dynamic Load Test and Static Load Test of PHC Bored Pile", Journal of Korean Geo-Environmental Society, Vol.18, No.9, pp.19-31.
  16. Park, J. S., Park, D. H., Jee, S. H. and Kim, D. J. (2015), "Evaluation of Vertical Bearing Capacity for Bucket and Shallow Foundations Installed in Sand", Journal of Korean Geo-Environmental Society, Vol.16, No.9, pp.33-41.
  17. Park, M. C., Kwon, O. K., Kim, C. M., Yun, D. K. and Choi, Y. G. (2019), "Study(V) on Development of Charts and Equations Predicting Allowable Compressive Bearing Capacity for Prebored PHC Piles Socketed into Weathered Rock through Sandy Soil Layers - Analysis of Results and Data by Parametric Numerical Analysis", Journal of The Korean Geotechnical Society, Vol.35, No.10, pp.47-66.
  18. Reese, L. C. (1978), "Analysis of Laterally Loaded Pile in Sand", Proceedings of The VI Annual Offshore Technology Conference, Houston, Texas, (OTC 2080), pp.473-485.
  19. Reese, L. C., Cox, W. R. and Koop, F. D. (1975), "Field Testing and Analysis of Laterally Loaded Pile in Stiff Clay", Proceedings of The VII Annual Offshore Technology Conference, Houston, Texas, (OTC 2312), pp.672-690.
  20. Sagong, M, and Paik, K. H. (2004), "Side Resistance of Rock Socketed Drilled Shafts in Consideration of the Shaft Size Effects", Journal of The Korean Geotechnical Society, Vol.20, No.9, pp.106-115.
  21. Seo, Y. J. (2015), Characteristic of Side Resistance through Bi-directional Pile Load Test in Domestic and Foreign Sites, Inje University, Master Thesis.
  22. Song, M. J., Park, Y. H. and Kim, M. M. (2013), "Skin Friction and End Bearing Resistances of Rock-socketed Piles Observed in Bi-directional Pile Load Tests", Journal of The Korean Geotechnical Society, Vol.29, No.7, pp.17-36. https://doi.org/10.7843/kgs.2013.29.7.17
  23. Yea, G. G., Yun, D. H., Yun, D. K. and Choi, Y. G. (2019), "Study(II) on Development of Charts and Formulae Predicting Allowable Axial Bearing Capacity for Prebored PHC Pile Socketed into Weathered Rock through Sandy Soil Layer - Improvement Measures of Current Design Method by Analyzing Current Design Data for Prebored PHC Piles", Journal of The Korean Geotechnical Society, Vol.35, No.8, pp.31-42. https://doi.org/10.7843/KGS.2019.35.8.31
  24. Yoon, M. S., Lee, C. K. and Kim, M. H. (2013), "Evaluation of Unit Side Resistance of Drilled Shafts by Revised SPT N Value", Journal of The Korean Geotechnical Society, Vol.29, No.12, pp.5-10. https://doi.org/10.7843/kgs.2013.29.12.5
  25. Yoon, S. H., Joo, Y. Y., Kim, D. I. and Kim, M. H. (2002), "A Study on the Comparison and Evaluation of Bearing Capacity for the Open-ended Steel Pipe Pile", 仁濟論叢, Vol.17, No.1, pp.597-616.