DOI QR코드

DOI QR Code

Reinforced concrete core-walls connected by a bridge with buckling restrained braces subjected to seismic loads

  • Beiraghi, Hamid (Department of Civil Engineering, Mahdishahr Branch, Islamic Azad University)
  • 투고 : 2018.02.20
  • 심사 : 2018.05.17
  • 발행 : 2018.08.25

초록

Deflection control in tall buildings is a challenging issue. Connecting of the towers is an interesting idea for architects as well as structural engineers. In this paper, two reinforced concrete core-wall towers are connected by a truss bridge with buckling restrained braces. The buildings are 40 and 60-story. The effect of the location of the bridge is investigated. Response spectrum analysis of the linear models is used to obtain the design demands and the systems are designed according to the reliable codes. Then, nonlinear time history analysis at maximum considered earthquake is performed to assess the seismic responses of the systems subjected to far-field and near-field record sets. Fiber elements are used for the reinforced concrete walls. On average, the inter-story drift ratio demand will be minimized when the bridge is approximately located at a height equal to 0.825 times the total height of the building. Besides, because of whipping effects, maximum roof acceleration demand is approximately two times the peak ground acceleration. Plasticity extends near the base and also in major areas of the walls subjected to the seismic loads.

키워드

참고문헌

  1. ACI 318-11 (2011), Building Code Requirements for Structural Concrete and Commentary, ACI Committee 318, Farmington Hills.
  2. AISC (2010), Seismic Provision for Structural Steel Buildings, American Institute of Steel Construction: Chicago.
  3. Applied Technology Council (2010), ATC-72: Modeling and Acceptance Criteria for Seismic Design and Analysis of Tall Buildings, ATC, Redwood City, CA.
  4. ASCE/SEI 41-13 (2014), Seismic Evaluation and Retrofi t of Existing Buildings. American Society of Civil Engineers, Reston, VA.
  5. ASCE/SEI 7-2010 (2010), Minimum Design Loads for Buildings and Other Structures, American Society of Civil Engineers, Reston, VA.
  6. Asgarian, B. and Amirhesari, N. (2008), "A comparison of dynamic nonlinear behavior of ordinary and buckling restrained braced frames subjected to strong ground motion", Struct. Des. Tall Spec. Build., 17, 367-86. https://doi.org/10.1002/tal.358
  7. Beiraghi, H. (2016), "Fundamental period of masonry infilled moment-resisting steel frame buildings", Struct. Des. Tall Spec. Build., 26(5), e1342.
  8. Beiraghi, H. (2017a), "Earthquake effects on the energy demand of tall reinforced concrete walls with buckling-restrained brace outriggers", Struct. Eng. Mech., 63(4), 521-536. https://doi.org/10.12989/SEM.2017.63.4.521
  9. Beiraghi, H. (2017b), "Forward directivity near-fault and far-fault ground motion effects on the responses of tall reinforced concrete walls with buckling-restrained brace outriggers", Scientia Iranica, 25(11), 519-539.
  10. Beiraghi, H. and Siahpolo, N. (2016b), "Seismic assessment of RC core-wall building capable of three plastic hinges with outrigger", Struct. Des. Tall Spec. Build., 26(2), e1306.
  11. Beiraghi, H., Kheyroddin, A. and Kafi, M.A. (2015), "Nonlinear fiber element analysis of a reinforced concrete shear wall subjected to earthquake records", Tran. Civil Eng., 39(C2+), 409-422.
  12. Beiraghi, H., Kheyroddin, A. and Kafi, M.A. (2016a), "Forward directivity near-fault and far-fault ground motion effects on the behavior of reinforced concrete wall tall buildings with one and more plastic hinges", Struct. Des. Tall Spec. Build., 25(11), 519-539. https://doi.org/10.1002/tal.1270
  13. Beiraghi, H., Kheyroddin, A. and Kafi, M.A. (2016c), "Effect of record scaling on the behavior of reinforced concrete core-wall buildings subjected to near-fault and far-fault earthquakes", Scientia Iranica, 24(3), 884.
  14. Beiraghi, H., Kheyroddin, A. and Kafi, M.A. (2016d), "Energy dissipation of tall core-wall structures with multi-plastic hinges subjected to forward directivity near-fault and far-fault earthquakes", Struct. Des. Tall Spec. Build., 25(15), 801-820. https://doi.org/10.1002/tal.1284
  15. Black, C., Makris, N. and Aiken, I. (2002), "Component testing, stability analysis and characterization of buckling-restrained braces", Report No. PEER-2002/08, Pacific Earthquake Engineering Research Center, University of California, Berkeley, CA, USA.
  16. Bosco, M. and Marino, E.M. (2013), "Design method and behavior factor for steel frames with buckling restrained braces", Earthq. Eng. Struct. Dyn., 42, 1243-1263. https://doi.org/10.1002/eqe.2269
  17. Chen, X. and Han, X. (2010), "Research summary on long-span connected tall building structure with viscous dampers", Struct. Des. Tall Spec. Build., 19, 439-456. https://doi.org/10.1002/tal.582
  18. FEMA P695 (2009), Quantification of Building Seismic Performance Factors (ATC-63 Project), Federal Emergency Management Agency, Washington D.C.
  19. Gerami, M. and Siahpolo, N. (2016), "Proposition of a new method for quick assessment of maximum beam ductility in steel moment frame under higher mode effects", Scientia Iranica A, 23(3), 769-787. https://doi.org/10.24200/sci.2016.2158
  20. Guneyisi, E.M. and Ameen, N. (2014), "Structural behavior of conventional and buckling restrained braced frames subjected to near-field ground motions", Earthq. Struct., 7(4), 553-570. https://doi.org/10.12989/eas.2014.7.4.553
  21. Jiang, J.J., Lu, X.Z. and Ye, L.P. (2004), Finite Element Analysis of Concrete Structures, Tsinghua University Press.
  22. LATBSDC (2014), An Alternative Procedure For Seismic Analysis and Design of Tall Buildings Located in the Los Angeles Region, Los Angeles Tall Buildings Structural Design Council, Los Angeles.
  23. Lim, J. (2009), "Structural coupling and wind-induced response of twin tall buildings with a skybridge", Colorado State University.
  24. Lim, J., Bienkiewicz, B. and Richards, E. (2011), "Modeling of structural coupling for assessment of modal properties of twin tall buildings with a skybridge", J. Wind Eng. Indus. Aerodyn., 99(5), 615-623. https://doi.org/10.1016/j.jweia.2011.02.010
  25. Luong, A. and Kwok, M. (2012), "Finding structural solutions by connecting towers", CTBUH J., 26-31..
  26. Merritt, S., Uang, C.M. and Benzoni, G. (2003), "Subassemblage testing of star seismic buckling restrained braces", TR-2003/04, La Jolla (CA), Univ. of California at San Diego.
  27. Mortezaei, A. and Ronagh, H.R. (2013), "Plastic hinge length of reinforced concrete columns subjected to both far-fault and near-fault ground motions having forward directivity", Struct. Des. Tall Spec. Build., 22(12), 903-926. https://doi.org/10.1002/tal.729
  28. Nguyen, A.H., Chintanapakdee, C. and Hayashikawa, T. (2010), "Assessment of current nonlinear static procedures for seismic evaluation of BRBF buildings", J. Constr. Steel Res., 66(8-9), 1118-1127. https://doi.org/10.1016/j.jcsr.2010.03.001
  29. Ozuygur, A.R. (2015), "Performance-based seismic design of an irregular tall building in Istanbul-a case study", Struct., 5, 112-122.
  30. Ozuygur, A.R. (2015), "Performance-based seismic design of an irregular tall building in Istanbul", Struct. Des. Tall Spec. Build., 24(10), 703-723. https://doi.org/10.1002/tal.1207
  31. Panagiotou, M. and Restrepo, J. (2009), "Dual-plastic hinge design concept for reducing higher-mode effects on high-rise cantilever wall buildings", Earthq. Eng. Struct. Dyn., 38, 1359-1380. https://doi.org/10.1002/eqe.905
  32. Paulay, T. and Priestley, M. (1992), Seismic Design of Reinforced Concrete and Masonry Buildings,Wiley, New York.
  33. PERFORM-3D (2006), Nonlinear Analysis and Performance Assessment for 3D Structures, V.4, User Guide, Computers and Structures, Inc., Berkeley, CA.
  34. PERFORM-3D (2011), Nonlinear Analysis and Performance Assessment for 3D Structures, V.4.0.3, Computers and Structures, Inc., Berkeley, CA.
  35. Rai, D.C. and Goel, S.C. (2003), "Seismic evaluation and upgrading of chevron braced frames", J. Constr. Steel Res., 59, 971-994. https://doi.org/10.1016/S0143-974X(03)00006-3
  36. Richardson, A., Walsh, K.K. and Abdullah, M.M. (2013), "Closed-form equations for coupling linear structures using stiffness and damping elements", Struct. Control Hlth. Monit., 20(3), 259-281. https://doi.org/10.1002/stc.490
  37. Saad, G., Najjar, S.S. and Saddik, F. (2016), "Seismic performance of reinforced concrete shear wall buildings with underground stories", Earthq. Struct., 10(4), 965-988. https://doi.org/10.12989/eas.2016.10.4.965
  38. Smith, B.S. and Salim, I. (1981), "Parameter study of outrigger-braced tall building structures", J. Struct. Div., 107(10), 2001-2014.
  39. Tremblay, R., Bolduc, P., Neville, R. and DeVall, R. (2006), "Seismic testing and performance of buckling restrained bracing systems", Can. J. Civil Eng., 33, 183-198. https://doi.org/10.1139/l05-103
  40. Xu, Y.L., He, Q. and Ko, J.M. (1999), "Dynamic response of damper-connected adjacent buildings under earthquake excitation", Eng. Struct., 21(2), 135-148. https://doi.org/10.1016/S0141-0296(97)00154-5

피인용 문헌

  1. Seismic response of dual structures comprised by Buckling-Restrained Braces (BRB) and RC walls vol.72, pp.4, 2018, https://doi.org/10.12989/sem.2019.72.4.443
  2. Dual‐steel frame consisting of moment‐resisting frame and shape memory alloy braces subjected to near‐field earthquakes vol.29, pp.14, 2020, https://doi.org/10.1002/tal.1784
  3. Optimum location of second outrigger in RC core walls subjected to NF earthquakes vol.38, pp.6, 2018, https://doi.org/10.12989/scs.2021.38.6.671