DOI QR코드

DOI QR Code

Effect Analysis of Mix Designing Factors on Workability and Rheological Parameters of Self-Compacting Concrete

배합요인이 자기충전 콘크리트의 워커빌리티 및 레올로지 파라미터에 미치는 영향 분석

  • Yoon, Seob (R& D Center, Sampyo Industry) ;
  • Han, Min-Cheol (Department of Architectural Engineering, Cheongju University)
  • Received : 2018.02.05
  • Accepted : 2018.04.02
  • Published : 2018.06.20

Abstract

The objective of the paper is to investigate the effect of mix designing factors on the workability and rheological parameters of self compacting concrete in order to facilitate the difficulties of quality control of high sensitivity of SCC. Mix proportions of SCC were prepared with various conditions of coarse, and fine aggregate, and unit water content, and the SCC mixtures were tested on workability, rheological properties to provide basic data for quantitative evaluation. Test results indicated that the yield stress of SCC decreased with increasing the coarse aggregate volume ratio, and increased with increasing the amount of VMA. However, unit water content, fine aggregate type, and air content didn't affect the yield stress value. The plastic viscosity according to the mixing factors showed a similar tendency to the yield stress. In addition, there was no correlation between yield stress and workability (flow, T50, V-lot). However, there was closely correlation among plastic viscosity and T50 and V-lot. Especially, T50 and V-lot time decreased with decreasing plastic viscosity.

본 연구에서는 SCC의 높은 민감성으로 인한 품질관리에 어려움을 극복하고자 굵은 골재의 부피, 잔골재의 종류, 단위수량, 공기량, 증점제 사용량 변화 등과 같은 다양한 배합요인이 SCC 특성에 미치는 영향을 분석하여 SCC의 초기물성을 정량적으로 판단할 수 있는 기초자료를 제공하고자 하였다. 실험결과, 항복응력은 굵은 골재 용적율이 증가할수록 낮아졌고 증점제 사용량이 증가할수록 증가하는 것으로 나타났다. 그러나 단위수량, 잔골재 종류 변화, 공기량 증감에 따른 항복응력값의 변화는 없는 것으로 나타났다. 배합요인에 따른 소성 점도는 항복응력과 비슷한 경향을 나타냈다. 또한 항복응력과 슬럼프 플로, $T_{50}$, V-lot와의 상관성 분석결과, 상관관계가 없었고 소성 점도와 $T_{50}$, V-lot와의 상관성은 매우 밀접한 관계가 있는 것으로 나타났는데, 특히, $T_{50}$ 및 V-lot 시간이 줄어들수록 소성 점도도 낮아지는 것을 알 수 있었다.

Keywords

References

  1. European Project Group. The european guidelines for self-compacting concrete EFNARC. UK. 2005 May.
  2. Shen L, Jovein HB, Shen S, Li M. Effects of aggregate properties and concrete rheology on stability robustness of self-consolidating concrete. Journal of Materials in Civil Engineering. 2014 Oct;27(5):1-10.
  3. Abdelhamid R, Mongi Ben O, Mohamed A, Elhem G. Incorporation of crushed sands and tunisian desert sands in the composition of self compacting concrete part II:SCC fresh and hardened states characteristics. Concrete Structures and Materials. 2013;3(1):3-9.
  4. Ryo J, Lee Y, Jeon J, Jeon C. An experimental study on the self-consolidating concrete with EP nylon fiber. Journal of the Korea institute of Building construction. 2011 Jun 20;15(1):159-68.
  5. Kwon Y. Optimum mix proportion and characteristics of the combined self compacting concrete according to cement types. Journal of the Korea Concrete Institute. 2009 Mar 20;21(1):55-64. https://doi.org/10.4334/JKCI.2009.21.1.055
  6. Kwon S, Tri P, Kim J. Experiment for verification of prediction model for SCC formwork pressure. Journal of the Korea Concrete Institute. 2009 May;21(1):217-8.
  7. Kwan A, Ng I. Optimum superplasticizer dosage and aggregate proportions for SCC. Magazine of Concrete Research. 2009;61(4):281-92. https://doi.org/10.1680/macr.2008.00010
  8. Zerbino R, Barragan B, Garcia T, Agullo L, Gettu R. Workability tests and rheological parameters in self-compacting concrete. Materials and Structures. 2008;42(7):947-60. https://doi.org/10.1617/s11527-008-9434-2