DOI QR코드

DOI QR Code

Sine sweep effect on specimen modal parameters characterization

  • 투고 : 2016.11.21
  • 심사 : 2017.03.27
  • 발행 : 2018.03.25

초록

The sine sweep base excitation test campaign is a major milestone in the process of mechanical qualification of space structures. The objectives of these vibration tests are to qualify the specimen with respect to the dynamic environment induced by the launcher and to demonstrate that the spacecraft FE model is sufficiently well correlated with the test specimen. Dynamic qualification constraints lead to performing base excitation sine tests using a sine sweep over a prescribed frequency range such that at each frequency the response levels at all accelerometers, load cells and strain gages is the same as the steady state response. However, in practice steady state conditions are not always satisfied. If the sweep rate is too high the response levels will be affected by the presence of transients which in turn will have a direct effect on the estimation of modal parameters. A study funded by ESA and AIRBUS D&S was recently carried out in order to investigate the influence of sine sweep rates in actual test conditions. This paper presents the results of this study along with recommendations concerning the choice of methods.

키워드

참고문헌

  1. Craig, R.R. (1981), Structural Dynamics-An Introduction to Computer Methods, John Wiley & Sons.
  2. Cronin, D.L. (1968), Response Spectra for Sweeping Sinusoidal Excitations, Shock and Vibration Bulletin.
  3. Girard, A. and Bugeat, L.P. (2004), "Effect of sine sweep rate on modal parameter identification", Proceedings of the 5th International Symposium on Environmental Testing for Space Programmes, The Netherlands.
  4. Hawkes, P.E. (1964), Response of a Single-Degree-of-Freedom System to Exponential Sweep Rates, Shock and Vibration Bulletin, 33, Part II.
  5. Lalanne, C. (2009), Mechanical Vibration & Shock Analysis, John Wiley & Sons, Vol 1: Sinusoidal Vibrations, 2nd Edition.
  6. Lollock, J.A. (2002), "The effect of swept sinusoidal excitation on the response of a single-degree-offreedom oscillator", Proceedings of the 43rd AIAA Structures, Structural Dynamics, and Materials Conference, Denver.
  7. Orlando, S., Peeters, B. and Coppotelli, G. (2008), "Improved FRF estimators for MIMO sine sweep data", Proceedings of the ISMA 2008 International Conference on Noise and Vibration Engineering, Leuven, Belgium.
  8. Otnes, R.K. and Enochson, L. (1978), Applied Time Series Analysis, John Wiley & Sons, Vol 1: Basic Techniques.
  9. Roy, N. and Girard, A. (2012), "Revisiting the effect of sine sweep rate on modal identification", Proceedings of the European Conference on Spacecraft Structures, Materials and Environmental Testing, Noordwijk, The Netherlands.
  10. Violin, M. (2015), Sine Sweep Effect on Specimen Modal Parameters Characterization, Executive Summary, AIRBUS D&S, MTF.SWEE.TN.5468, Issue 01, Rev 01.