DOI QR코드

DOI QR Code

Systematic Approach for Design of Broadband, High Efficiency, High Power RF Amplifiers

  • Mohadeskasaei, Seyed Alireza (Department of Communication, School of Computer and Communication, University of Science and Technology Beijing) ;
  • An, Jianwei (Department of Communication, School of Computer and Communication, University of Science and Technology Beijing) ;
  • Chen, Yueyun (Department of Communication, School of Computer and Communication, University of Science and Technology Beijing) ;
  • Li, Zhi (Department of Communication, School of Computer and Communication, University of Science and Technology Beijing) ;
  • Abdullahi, Sani Umar (Department of Communication, School of Computer and Communication, University of Science and Technology Beijing) ;
  • Sun, Tie (Department of Communication, School of Computer and Communication, University of Science and Technology Beijing)
  • Received : 2016.07.28
  • Accepted : 2016.10.17
  • Published : 2017.02.01

Abstract

This paper demonstrates a systematic approach for the design of broadband, high efficiency, high power, Class-AB RF amplifiers with high gain flatness. It is usually difficult to simultaneously achieve a high gain flatness and high efficiency in a broadband RF power amplifier, especially in a high power design. As a result, the use of a computer-aided simulation is most often the best way to achieve these goals; however, an appropriate initial value and a systematic approach are necessary for the simulation results to rapidly converge. These objectives can be accomplished with a minimum of trial and error through the following techniques. First, signal gain variations are reduced over a wide bandwidth using a proper pre-matching network. Then, the source and load impedances are satisfactorily obtained from small-signal and load-pull simulations, respectively. Finally, two high-order Chebyshev low-pass filters are employed to provide optimum input and output impedance matching networks over a bandwidth of 100 MHz-500 MHz. By using an EM simulation for the substrate, the simulation results were observed to be in close agreement with the measured results.

Keywords

References

  1. C. Sanchez-Perez et al., "Optimization of the Efficiency and Linearity in RF Power Amplifiers Under Load Variations Using a Reconfigurable Matching Network," IEEE Veh. Technol. Conf. Fall, Ottawa, Canada, Sept. 6-9, 2010, pp. 1-5.
  2. P. Medrel et al., "Time Domain Envelope Characterization of Power Amplifiers for Linear and High Efficiency Design Solutions," IEEE Annu. Wireless Microw. Technol. Conf., Orlando, FL, USA, Apr. 7-9, 2013, pp. 1-6.
  3. W. Ga et al., "A Highly Linear Low Noise Amplifier with Wide Range Derivative Superposition Method," IEEE Microw. Wireless Compon. Lett., vol. 25, no. 12, Dec. 2015, pp. 817-819. https://doi.org/10.1109/LMWC.2015.2496793
  4. J.J. Yan et al., "Design of a 4-W Envelope Tracking Power Amplifier with More Than One Octave Carrier Bandwidth," IEEE J. Solid-State Circuits, vol. 47, no. 10, Oct. 2012, pp. 2298-2308. https://doi.org/10.1109/JSSC.2012.2204927
  5. J.J. Ya et al., "Broadband High PAE GaN Push-Pull Power Amplifier for 500 MHz to 2.5 GHz Operation," IEEE MTT-S Int. Microw. Symp. Dig., Seattle, WA, USA, June 2-7, 2013, pp. 1-3.
  6. N. Tuffy, A. Zhu, and T.J. Brazil, "Novel Realisation of a Broadband High-Efficiency Continuous Class-F Power Amplifier," European Microw. Integr. Circuits Conf., Manchester, UK, Oct. 10-11, 2011, pp. 120-123.
  7. B. Kim et al., "Broadband Operation of Saturated Amplifier with High Efficiency," IEEE Annu. Wireless Microw. Technol. Conf., Tampa, FL, USA, June 6, 2014, pp. 1-4.
  8. K. Li et al., "A 40 W Ultra Broadband LDMOS Power Amplifier," IEEE MTT-S Int. Microw. Symp., Phoenix, AZ, USA, May 17-22, 2015, pp. 1-4.
  9. Z. Dai et al., "A New Distributed Parameter Broadband Matching Method for Power Amplifier Via Real Frequency Technique," IEEE Trans. Microw. Theory Techn., vol. 63, no. 2, Feb. 2015, pp. 449-458. https://doi.org/10.1109/TMTT.2014.2385087
  10. X. Ding and L. Zhang, "A High-Efficiency GaAs MMIC Power Amplifier for Multi-standard System," IEEE Microw. Wireless Compon. Lett., vol. 26, no. 1, Jan. 2016, pp. 55-57. https://doi.org/10.1109/LMWC.2015.2505615
  11. J. Kim et al., "Highly Efficient Envelope-Tracking Modulator over Wide Output Power Range for Dual-Mode Power Amplifier," IDEC J. Integr. Circuits Syst., vol. 1, no. 1, 2015, pp. 28-35.
  12. Z. Wang, "Demystifying Envelope Tracking: Use for High-Efficiency Power Amplifiers for 4G and Beyond," IEEE Microw. Mag., vol. 16, no. 3, Apr. 2015, pp. 106-129. https://doi.org/10.1109/MMM.2014.2385351
  13. A. Jundi, H. Sarbishaei, and S. Boumaiza, "An 85-W Multi-octave Push-Pull GaN HEMT Power Amplifier for High-Dfficiency Communication Applications at Microwave Frequencies," IEEE Trans. Microw. Theory Techn., vol. 63, no. 11, Nov. 2015, pp. 3691-3700. https://doi.org/10.1109/TMTT.2015.2479615
  14. D.Y.T. Wu, L. Zhao, and M. Szymanowski, "A 25 W, 2.3 to 2.7 GHz Wideband LDMOS Two-Stage RFIC Power Amplifier for Driver and Small-Cell Doherty Application," European Microw. Integr. Circuits Conf., Paris, France, Sept. 7-8, 2015, pp. 258-261.
  15. C.Q. Chen et al., "A 1.8-2.8 GHz Highly Linear Broadband Power Amplifier for LTE-A Application," Progress Electromagn. Res. C, vol. 66, Apr. 2016, pp. 47-54. https://doi.org/10.2528/PIERC16050503
  16. V. Camarchia et al., "The Doherty Power Amplifier: Review of Recent Solutions and Trends," IEEE Trans. Microw. Theory Techn., vol. 63, no. 2, Feb. 2015, pp. 559-571. https://doi.org/10.1109/TMTT.2014.2387061
  17. J. Xia et al., "A Broadband High-Efficiency Doherty Power Amplifier with Integrated Compensating Reactance," IEEE Trans. Microw. Theory Techn., vol. 64, no. 7, July 2016, pp. 2014-2024. https://doi.org/10.1109/TMTT.2016.2574861
  18. R.S. Pengelly et al., "A Review of GaN on SiC High Electron-Mobility Power Transistors and MMICs," IEEE Trans. Microw. Theory Techn., vol. 60, no. 6, June 2012, pp. 1764-1783. https://doi.org/10.1109/TMTT.2012.2187535
  19. N. Giovannelli et al., "A 250W LDMOS Doherty PA with 31% of Fractional Bandwidth for DVB-T Applications," IEEE MTT-S Int. Microw. Symp., Tampa Bay, FL, USA, June 1-6, 2014, pp. 1-4.
  20. N. Kumar and L. Anand, "Broadband High Performance Laterally Diffused Metal-Oxide-Semiconductor Power Amplifier for Mobile Two-Way Radio Applications," IET Circuits, Devices Syst., vol. 9, no. 4, July 2015, pp. 283-289. https://doi.org/10.1049/iet-cds.2014.0206
  21. G. Gonzalez, Microwave Transistor Amplifiers: Analysis and Design, vol. 61, Englewood Cliffs, NJ, USA: Prentice-Hall, 1997.
  22. R. Gilmore and L. Besser, Practical RF Circuit Design for Modern Wireless Systems, vol. 2, Norwood, MA, USA: Artech House, 2003.
  23. D. M. Pozar, Microwave Engineering, Hoboken, NJ, USA: John Wiley & Sons, 2009.
  24. F.H. Raab et al., "Power Amplifiers and Transmitters for RF and Microwave," IEEE Trans. Microw. Theory Techn., vol. 50, no. 3, Mar. 2002, pp. 814-826. https://doi.org/10.1109/22.989965
  25. I. Aoki et al., "Distributed Active Transformer-a New Power-Combining and Impedance-Transformation Technique," IEEE Trans. Microw. Theory Techn., vol. 50, no. 1, Jan. 2002, pp. 316-331. https://doi.org/10.1109/22.981284
  26. D. Kuylenstierna and P. Linner, "Design of Broad-Band Lumped-Element Baluns with Inherent Impedance Transformation," IEEE Trans. Microw. Theory Techn., vol. 52, no. 12, Dec. 2004, pp. 2739-2745. https://doi.org/10.1109/TMTT.2004.838305
  27. J. Sevick, "A Simplified Analysis of the Broadband Transmission Line Transformer," High Frequency Electron., vol. 3, no. 2, 2004, pp. 48-53.
  28. T. Jensen et al., "Coupled Transmission Lines as Impedance Transformer," IEEE Trans. Microw. Theory Techn., vol. 55, no. 12, Dec. 2007, pp. 2957-2965. https://doi.org/10.1109/TMTT.2007.909617
  29. R. Zhang et al., "A 550-1050 MHz +30 dBm Class-E Power Amplifier in 65nm CMOS," IEEE Radio Frequency Integr. Circuits Symp., Boltimore, MD, USA, June 5-7, 2011, pp. 1-4.
  30. G.L. Matthaei, "Tables of Chebyshev Impedance-Transforming Networks of Low-Pass Filter Form," Proc. IEEE, vol. 52, no. 8, Aug. 1964, pp. 939-963. https://doi.org/10.1109/PROC.1964.3185
  31. A. Bhargava, "Designing circuits using an EM/circuit co-simulation technique," RF Des., 2005, p. 76.

Cited by

  1. Design of a 2.5-kW L-band solid-state pulsed power amplifier for radar applications vol.53, pp.15, 2017, https://doi.org/10.1049/el.2017.0493