DOI QR코드

DOI QR Code

Grouting compactness monitoring of concrete-filled steel tube arch bridge model using piezoceramic-based transducers

  • Feng, Qian (Key Laboratory of Earthquake Geodesy, Institute of Seismology, China Earthquake Administration) ;
  • Kong, Qingzhao (Department of Mechanical Engineering, University of Houston) ;
  • Tan, Jie (Key Laboratory of Earthquake Geodesy, Institute of Seismology, China Earthquake Administration) ;
  • Song, Gangbing (Department of Mechanical Engineering, University of Houston)
  • Received : 2016.11.28
  • Accepted : 2017.04.06
  • Published : 2017.08.25

Abstract

The load-carrying capacity and structural behavior of concrete-filled steel tube (CFST) structures is highly influenced by the grouting compactness in the steel tube. Due to the invisibility of the grout in the steel tube, monitoring of the grouting progress in such a structure is still a challenge. This paper develops an active sensing approach with combined piezoceramic-based smart aggregates (SA) and piezoceramic patches to monitor the grouting compactness of CFST bridge structure. A small-scale steel specimen was designed and fabricated to simulate CFST bridge structure in this research. Before casting, four SAs and two piezoceramic patches were installed in the pre-determined locations of the specimen. In the active sensing approach, selected SAs were utilized as actuators to generate designed stress waves, which were detected by other SAs or piezoceramic patch sensors. Since concrete functions as a wave conduit, the stress wave response can be only detected when the wave path between the actuator and the sensor is filled with concrete. For the sake of monitoring the grouting progress, the steel tube specimen was grouted in four stages, and each stage held three days for cement drying. Experimental results show that the received sensor signals in time domain clearly indicate the change of the signal amplitude before and after the wave path is filled with concrete. Further, a wavelet packet-based energy index matrix (WPEIM) was developed to compute signal energy of the received signals. The computed signal energies of the sensors shown in the WPEIM demonstrate the feasibility of the proposed method in the monitoring of the grouting progress.

Keywords

Acknowledgement

Supported by : National Natural Science Foundation of China, Institute of Seismology, China Earthquake Administration

References

  1. Chen, L. (2011), "Debonding defect detection for concrete filled steel tubular using knocking technique", China Concrete, 1, 54-56.
  2. Feng, M.Q., Flaviis, F.D. and Kim, Y.J. (2002), "Use of microwaves for damage detection of fiber reinforced polymer-wrapped concrete structures", J. Eng. Mech. - ASCE, 128(2), 172-183. https://doi.org/10.1061/(ASCE)0733-9399(2002)128:2(172)
  3. Feng, Q., et al. (2015), "Crack detection and leakage monitoring on reinforced concrete pipe", Smart Mater. Struct., 24(11), 115020. https://doi.org/10.1088/0964-1726/24/11/115020
  4. Feng, Q., et al. (2013), "Design of remote real time monitoring system based on GPRS for railway roadbed subsidence", J. Geodesy Geodynam, 6, 155-157.
  5. Hou, S., Zhang, H.B. and Ou, J.P. (2012), "A PZT-based smart aggregate for compressive seismic stress monitoring", Smart Mater. Struct., 21(10), 105035. https://doi.org/10.1088/0964-1726/21/10/105035
  6. Jiang, T., et al. (2016), "Monitoring of grouting compactness in a post-tensioning tendon duct using piezoceramic transducers", Sensors, 16(8), 1343. https://doi.org/10.3390/s16081343
  7. Kong, Q., Hou, S., Ji, Q., Mo, Y.L. and Song, G. (2013), "Very early age concrete hydration characterization monitoring using piezoceramic based smart aggregates", Smart Mater. Struct., 22(8), 085025. https://doi.org/10.1088/0964-1726/22/8/085025
  8. Kong, Q., Robert, R.H., Silva, P. and Mo, Y.L. (2016), "Cyclic crack monitoring of a reinforced concrete column under simulated pseudo-dynamic loading using piezoceramic-based smart aggregates", Appl. Sci., 6(11), 341. https://doi.org/10.3390/app6110341
  9. Lai, T., Yi, T.H. and Li, H.N. (2016), "Parametric study on sequential deconvolution for force identification", J. Sound Vib., 377, 76-89. https://doi.org/10.1016/j.jsv.2016.05.013
  10. Liang, Y., et al. (2016), "Bond-slip detection of concrete-encased composite structure using electro-mechanical impedance technique", Smart Mater. Struct., 25(9).
  11. Lin Y.B., et al. (2004), "The utilization of fiber Bragg grating sensors to monitor high performance concrete at elevated temperature", Smart Mater. Struct., 13(4), 784-790. https://doi.org/10.1088/0964-1726/13/4/016
  12. Liu, Q. (2004), "Compactness detection research for concrete filled steel tube arch bridge using ultrasonic technique", NDT, 2, 13-15.
  13. Liu, T., Huang, Y., Zou, D., Teng, J. and Li, B. (2013), "Exploratory study on water seepage monitoring of concrete structures using piezoceramic based smart aggregates", Smart Mater. Struct., 22(6), 065002. https://doi.org/10.1088/0964-1726/22/6/065002
  14. Liu, T., Zou, D., Du, C. and Wang, Y. (2016), "Influence of axial loads on the health monitoring of concrete structures using embedded piezoelectric transducers", Struct. Health Monit., 1475921716670573.
  15. Liu, Y., Zhang Y. and Zou Z. (2004), "Study of ultrasonic detection and evaluation for the deficiency of concrete-filled steel tube arch bridge", J. Northern Jiaotong Univ., 4, 54-57.
  16. Lu, X., Xu, R. and Wang, G. (2011), "Common defects in the concrete-filled steel tube and its detection methods", Constr. Technol., (S1), 46-48.
  17. Ni, Y.Q., et al. (2009), "Technology innovation in developing the structural health monitoring system for Guangzhou New TV Tower", Struct. Control Health Monit., 1(16), 73-98.
  18. Ni, Y.Q., Ye, X.W. and Ko, J.M. (2010), "Monitoring-based fatigue reliability assessment of steel bridges: analytical model and application", J. Struct. Eng. - ASCE, 136(12), 1563-1573. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000250
  19. Ni, Y.Q., Ye, X.W. and Ko, J.M. (2012), "Modeling of stress spectrum using long-term monitoring data and finite mixture distributions", J. Eng. Mech. - ASCE, 138(2), 175-183. https://doi.org/10.1061/(ASCE)EM.1943-7889.0000313
  20. Ruan, J., et al. (2015), "An anti-noise real-time cross-correlation method for bolted joint monitoring using piezoceramic transducers", Smart Struct. Syst., 16(2), 281-294. https://doi.org/10.12989/sss.2015.16.2.281
  21. Siu, S., et al. (2014), "Stress wave communication in concrete: I. Characterization of a smart aggregate based concrete channel", Buiocontrol Sci. Technol., 23(12).
  22. Song, G., et al. (2007), "Concrete structural health monitoring using embedded piezoceramic transducers", Smart Mater. Struct., 16(4), 959-968. https://doi.org/10.1088/0964-1726/16/4/003
  23. Song, G., Gu, H. and Mo, Y.L. (2008), "Topical review: Smart aggregates: multi-functional sensors for concrete structures-a tutorial and a review", Smart Mater. Struct., 17(3), 847-854.
  24. Song, G., Olmi, C. and Gu, H. (2007), "An overheight vehicle bridge collision monitoring system using piezoelectric transducers", Smart Mater. Struct., 16(2), 462-468. https://doi.org/10.1088/0964-1726/16/2/026
  25. Su, J.C. (2009), Survey on CFST arch bridges and research on their void problem, Southwest Jiaotong University, Chengdu, Sichuan, China.
  26. Xiao, H., Zheng, J. and Song, G. (2016), "Severity evaluation of the transverse crack in a cylindrical part using a PZT wafer based on an interval energy approach", Smart Mater. Struct., 25(3), 035021. https://doi.org/10.1088/0964-1726/25/3/035021
  27. Xu, B., Chen, H. and Xia, S. (2017), "Numerical study on the mechanism of active interfacial debonding detection for rectangular CFSTs based on wavelet packet analysis with piezoceramics", Mech. Syst. Signal Pr., 86, 108-121. https://doi.org/10.1016/j.ymssp.2016.10.002
  28. Xu, B., Chen, H. and Xia, S. (2017), "Study on the active debonding detection mechanism for circular CFSTs with PZT technology using wavelet packet analysis", Smart Struct. Syst., 19(2), 181-194 https://doi.org/10.12989/sss.2017.19.2.181
  29. Xu, B., et al. (2013), "Active interface debonding detection of a concrete-filled steel tube with piezoelectric technologies using wavelet packet analysis", Mech. Syst. Signal Pr., 36(1), 7-17. https://doi.org/10.1016/j.ymssp.2011.07.029
  30. Xu, B., Li, B. and Song, G. (2012), "Active debonding detection for large rectangular CFSTs based on wavelet packet energy spectrum with piezoceramics", J. Struct. Eng. - ASCE, 139(9), 1435-1443.
  31. Yao, P., et al. (2016), "Structural health monitoring of multi-spot welded joints using a lead zirconate titanate based active sensing approach", Smart Mater. Struct., 25(1), 015031. https://doi.org/10.1088/0964-1726/25/1/015031
  32. Ye, X.W., Su, Y.H., Xi, P.S., Chen, B. and Han, J.P. (2016), "Statistical analysis and probabilistic modeling of WIM monitoring data of an instrumented arch bridge", Smart Struct. Syst., 17(6), 1087-1105. https://doi.org/10.12989/sss.2016.17.6.1087
  33. Yi, T.H., Li H.N. and Gu, M. (2013), "Wavelet based multi-step filtering method for bridge health monitoring using GPS and accelerometer", Smart Struct. Syst., 11(4), 331-348. https://doi.org/10.12989/sss.2013.11.4.331
  34. Yi, T.H., Li, H.N. and Wang, C.W. (2015), "Multiaxial sensor placement optimization in structural health monitoring using distributed wolf algorithm", Struct. Control Health Monit., 23(4), 719-734. https://doi.org/10.1002/stc.1806
  35. Zeng, L., et al. (2015), "Bond slip detection of concrete-encased composite structure using shear wave based active sensing approach", Smart Mater. Struct., 24(12), 125026. https://doi.org/10.1088/0964-1726/24/12/125026
  36. Zhang, L., et al. (2016), "Health monitoring of cuplok scaffold joint connection using piezoceramic transducers and time reversal method", Smart Mater. Struct., 25(3), 668-671.
  37. Zou, D., Liu, T., Huang, Y., Zhang, F., Du, C. and Li, B. (2014), "Feasibility of water seepage monitoring in concrete with embedded smart aggregates by P-wave travel time measurement", Smart Mater. Struct., 23(6), 067003. https://doi.org/10.1088/0964-1726/23/6/067003
  38. Zou, D., Liu, T., Huang, Y., Zhang, F., Du, C. and Li, B. (2014), "Feasibility of water seepage monitoring in concrete with embedded smart aggregates by P-wave travel time measurement", Smart Mater. Struct., 23(6), 067003. https://doi.org/10.1088/0964-1726/23/6/067003
  39. Zou, D., Liu, T., Qiao, G., Huang, Y. and Li, B. (2014), "An experimental study on the performance of piezoceramic-based smart aggregate in water environment", IEEE Sens. J., 14(4), 943-944. https://doi.org/10.1109/JSEN.2014.2302893