DOI QR코드

DOI QR Code

Effect of soil overburden pressure on mechanical properties of carbon FRP strips

  • Toufigh, Vahid (Department of Civil Engineering, Graduate University of Advanced Technology Kerman) ;
  • Bilondi, Meysam Pourabbas (Department of Civil Engineering, Bahonar University of Kerman) ;
  • Tohidi, Farshid (Department of Civil Engineering, Bahonar University of Kerman)
  • Received : 2016.06.08
  • Accepted : 2016.10.31
  • Published : 2017.03.10

Abstract

Carbon fiber reinforced polymers (CFRPs) have been recently investigated as an alternative material for Geosynthetics to improve soil properties. One of the factors influencing the fiber orientation and mechanical properties of CFRP is the effect of soil overburden pressure. This study investigates the tensile behavior of cast-in-place CFRP. During the curing time of specimens, a wide range of normal stress is applied on specimens sandwiched between the soils. Two different soil types are used to determine the effect of soil grain size on the mechanical properties of CFRP. Specimens are also prepared with different specifications such as curing time and mixing soil in to the epoxy. In this study, tensile tests are conducted to investigate the effect of such parameters on tensile behavior of CFRP. The experimental results indicate that by increasing the normal stress and soil grain size, the ultimate tensile strength and the corresponding strain of CFRP decrease; however, reduction in elastic modulus is not noticeable. It should be noted that, increasing the curing period of epoxy resin and mixing soil in to the epoxy have no significant effect on the tensile properties of CFRP.

Keywords

References

  1. ASTM C128-12 (2012), Standard Test Method for Density, Relative Density (Specific Gravity), and Absorption of Fine Aggregate, ASTM International, West Conshohocken, PA, USA.
  2. ASTM D 2216-10 (2010), Standard Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass, ASTM International, West Conshohocken, PA, USA.
  3. ASTM D 3039/D 3039M (2014), Standard Test Method for Tensile Properties of Polymer Matrix Composite Material, Annual Book of ASTM Standards, West Conshohocken, PA. USA.
  4. ASTM D 422-63e2 (2007), Standard Test Method for Particle-Size Analysis of Soils, Annual Book of ASTM Standards, West Conshohocken, PA, USA.
  5. ASTM D 698-12e2 (2012), Standard Test Methods for Laboratory Compaction Characteristics of Soil Using Standard Effort (12 400 ft-lbf/$ft^3$ (600 kN-$m/m^3$)), ASTM International, West Conshohocken, PA, USA.
  6. ASTM D3080 / D3080M-11 (2011), Standard Test Method for Direct Shear Test of Soils Under Consolidated Drained Conditions, ASTM International, West Conshohocken, PA, USA.
  7. Ballinger, C. (1990), "Structural FRP composites", Civil Eng., ASCE, 60(7), 63-65.
  8. Desai, C.S. and El-Hoseiny K.E. (2005), "Prediction of field behavior of reinforced soil wall using advanced constitutive model", J. Geotech. Geoenviron. Eng., ASCE, 131(6), 729-739. https://doi.org/10.1061/(ASCE)1090-0241(2005)131:6(729)
  9. Fib (2001), "Externally bonded FRP reinforcement for RC structures", (CEB-FIP), Technical Report, No.14.
  10. Frost, J.D. and Han, J. (1999), "Behavior of interfaces between fiber-reinforced polymers and sands", J. Geotech. Geoenviron. Eng., 125(8), 633-640. https://doi.org/10.1061/(ASCE)1090-0241(1999)125:8(633)
  11. Ghasemi, S., Maghsoudi, A.A., Bengar H.A. and Ronagh, H.R. (2015), "Flexural strengthening of continuous unbounded post-tensioned concrete beams with end-anchored CFRP laminates", Struct. Eng. Mech., 53(6), 1083-1104. https://doi.org/10.12989/sem.2015.53.6.1083
  12. Gibson, R.F. (1994), Principles of Composite Material Mechanics, McGraw-Hill, New York, NY, USA.
  13. Javid, N. (2011), "Experimental studies of the interaction of soil and FRP composites FRP", M.Sc. Thesis, Bbahonar University, Iran.
  14. Jewell, R.A. (1980), "Some effects of reinforcement on the mechanical behavior of soils", Ph.D. Dissertation, Cambridge University, UK.
  15. Koerner, R. (1998), Designing with Geosynthetics, 3rd Edition, Prentice Hall Publishers, Upper Saddle River, NJ, USA.
  16. Nardone, F., Di Ludovico, M., Prota, A. and Nanni, A. (2011), "Tensile behavior of epoxy based FRP composites under extreme service conditions", Compos. Part B, 43(3), 186-195.
  17. Saadatmanesh, H., Tavakkolizadeh, M. and Mostofinejad, D. (2010), "Environmental effects on mechanical properties of wet lay-up fiber-reinforced polymer", ACI Mater. J., 107(3), 267-274.
  18. Saribiyik, A. and Caglar, N. (2016), "Flexural strengthening of RC Beams with low-strength concrete using GFRP and CFRP", Struct. Eng. Mech., 58(5), 825-845. https://doi.org/10.12989/sem.2016.58.5.825
  19. Shi, J.W., Zhu, H., Wu, G. and Wu, Z.S. (2014), "Tensile behavior of FRP and hybrid FRP sheets in freeze-thaw cycling environments", Compos. Part B: Eng., 60, 239-247. https://doi.org/10.1016/j.compositesb.2013.11.026
  20. Sika Poland sp. Z. (2003), "Sika carbo dur FRP composites for repair & strengthening of structures", Technical Report, March.
  21. Toufigh, V. (2012), "Experimental and analytical studies of geo-composite applications in soil reinforcement", Ph.D. Dissertation, University of Arizona, Tucson, AZ, USA.
  22. Toufigh, V., Desai, C.S., Saadatmanesh, H., Toufigh, V., Ahmari, S. and Kabiri, E. (2013), "Constitutive modelling and testing of interface between backfill soil and fiber-reinforced polymer", Int. J. Geomech., ASCE, 14(3), 04014009. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000298
  23. Toufigh, V., Hosseinali, M. and Shirkhorshidi, S.M. (2016), "Experimental study and constitutive modeling of polymer concrete's behavior in compression", Constr. Build. Mater., 112, 183-190. https://doi.org/10.1016/j.conbuildmat.2016.02.100
  24. Toufigh, V., Saeid, F., Toufigh, V., Ouria, A., Desai, C.S. and Saadatmanesh, H. (2013), "Laboratory study of soil-CFRP interaction using pull-out test", Int. J. Geomech. Geoeng., 9(3), 208-214.
  25. Toufigh, V., Toufigh, V. and Saadatmanesh, H. (2013), "Behavior of FRP bonded to steel under freeze thaw cycles", Steel Compos. Struct., 14(1), 41-55. https://doi.org/10.12989/scs.2013.14.1.041
  26. Toufigh, V., Toufigh, V., Saadatmanesh, H. and Ahmari, S. (2013), "Strength evaluation and energy-dissipation behavior of fiber-reinforced polymer concrete", Adv. Civil Eng. Mater., 2(1), 622-636.
  27. Triantafillou, T., Matthys, S., Audenaert, K., Balazs, G., Blaschko, M., Blontrock, H. and et al. (2001), "Externally bonded FRP reinforcement for RC structures", International Federation for Structural Concrete (fib), Lausanne, Switzerland.
  28. Wang, L., Hou, W., Han, H. and Huo, J. (2015), "Repair of flange damage steel-concrete composite girders using CFRP sheets", Struct. Eng. Mech., 55(3), 511-523. https://doi.org/10.12989/sem.2015.55.3.511
  29. Zhang, C.C., Zhu, H.H., Shi, B., Wu, F.D. and Yin, J.H. (2014), "Experimental investigation of pull-out behavior of fiber-reinforced polymer reinforcements in sand", J. Compos. Construct., ASCE, 19(3), 04014062. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000526

Cited by

  1. Experimental investigation of interface behaviour between different types of sand and carbon fibre polymer vol.25, pp.13, 2017, https://doi.org/10.1080/19648189.2019.1626290