DOI QR코드

DOI QR Code

Experimental investigation of longitudinal shear behavior for composite floor slab

  • Kataoka, Marcela N. (University of Sao Paulo, Engineering School of Sao Carlos, Structural Department) ;
  • Friedrich, Juliana T. (University of Sao Paulo, Engineering School of Sao Carlos, Structural Department) ;
  • El Debs, Ana Lucia H.C. (University of Sao Paulo, Engineering School of Sao Carlos, Structural Department)
  • 투고 : 2015.06.11
  • 심사 : 2017.01.16
  • 발행 : 2017.02.28

초록

This paper presents an experimental study on the behavior of composite floor slab comprised by a new steel sheet and concrete slab. The strength of composite slabs depends mainly on the strength of the connection between the steel sheet and concrete, which is denoted by longitudinal shear strength. The composite slabs have three main failures modes, failure by bending, vertical shear failure and longitudinal shear failure. These modes are based on the load versus deflection curves that are obtained in bending tests. The longitudinal shear failure is brittle due to the mechanical connection was not capable of transferring the shear force until the failure by bending occurs. The vertical shear failure is observed in slabs with short span, large heights and high concentrated loads subjected near the supports. In order to analyze the behavior of the composite slab with a new steel sheet, six bending tests were undertaken aiming to provide information on their longitudinal shear strength, and to assess the failure mechanisms of the proposed connections. Two groups of slabs were tested, one with 3000 mm in length and other with 1500 mm in length. The tested composite slabs showed satisfactory composite behavior and longitudinal shear resistance, as good as well, the analysis confirmed that the developed sheet is suitable for use in composite structures without damage to the global behavior.

키워드

과제정보

연구 과제 주관 기관 : University of Sao Paulo

참고문헌

  1. Abdullah, R. (2004), "Experimental evaluation and analytical modeling of shear bond in composite slabs", M.A.Sc. Dissertation; Virginia Polytech Institute, Blacksburg, VA, USA.
  2. ABNT - Brazilian Association of Technical Codes (2003), NBR 6118: Design of reinforced concrete structures: Procedure, Rio de Janeiro, Brazil, 170 p. [In Portuguese]
  3. ABNT - Brazilian Association of Technical Codes (2008), NBR 8800: Design and execution of steel concrete composite building structures: Procedures, Rio de Janeiro, Brazil, 237 p. [In Portuguese]
  4. Al-Deen, S., Ranzi, G. and Uy, B. (2015), "Non-uniform shrinkage in simply-supported composite steel- concrete slabs", Steel Compos. Struct., Int. J., 18(2), 375-394. https://doi.org/10.12989/scs.2015.18.2.375
  5. Chen, S. and Shi, X. (2011), "Shear bond mechanism of composite slabs - A universal FE approach", J. Construct. Steel Res., 67(10), 1475-1484. https://doi.org/10.1016/j.jcsr.2011.03.021
  6. Chen, S., Limazie, T. and Tan, J. (2015), "Flexural behavior of shallow cellular composite floor beams with innovative shear connections", J. Construct. Steel Res., 106, 329-346. https://doi.org/10.1016/j.jcsr.2014.12.021
  7. Daniels, B. and Crisinel, M. (1988), "Composite slab with profiled shetting", Proceedings of an Engineering Foudation Conference on Compostie Construction in Steel and Concrete, ASCE, Henniker, NH, USA, June, pp. 656-662.
  8. De Nardin, S. and El Debs, A.L.H.C. (2009), "Study of partially encased composite beams with innovative position of stud bolts", J. Construct. Steel Res., 65(2), 342-350. https://doi.org/10.1016/j.jcsr.2008.03.021
  9. De Nardin, S. and El Debs, A.L.H.C. (2011), "Composite connections in slim-floor system: An experimental study", J. Construct. Steel Res., 68(1), 78-88. https://doi.org/10.1016/j.jcsr.2011.07.006
  10. Easterling, W.S. and Young, C.S. (1992), "Strength of composite slabs", J. Struct. Eng., ASCE, 118(9), 2370-2389. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:9(2370)
  11. EUROCODE 4 (2004), Design of composite steel and concrete structures - Part 1-1: General rules and rules for buildings, European Committee for Standardization.
  12. Ferrer, M., Marimon, F. and Crisinel, M. (2006), "Designing cold-formed steel sheets for composite slabs: An experimentally validated FEM approach to slip failure mechanics", Thin-Wall. Struct., 44(12), 1261-1271. https://doi.org/10.1016/j.tws.2007.01.010
  13. Friedrich, J.T. (2012), "Experimental and theorical analysis of composite shallow floors", Master Dissertation; School of Engineering of Sao Carlos, University of Sao Paulo, Sao Carlos, Brazil, 128 p. [In Portuguese]
  14. Huo, B.Y. and D'Mello, C.A. (2013), "Push-out tests and analytical study of shear transfer mechanisms in composite shallow cellular floor beams", J. Construct. Steel Res., 88, 191-205. https://doi.org/10.1016/j.jcsr.2013.05.007
  15. Johnson, R.P. (1994), Composite Structures of Steel and Concrete, Beams, Columns, Frames and Applications in Buildings, (Vol. 1), Blackwell Scientific Publications, London, UK.
  16. Kataoka, M.N. and El Debs, A.L.H.C. (2013), "Modelo de elementos finitos para analise nao linear de piso misto de pequena altura", IX Congresso de Construcao Metalica e Mista I Congresso Luso-Brasileiro de Construcao Metalica Sustentavel, Porto, Portugal. [In Portuguese]
  17. Kataoka, M.N. and El Debs, A.L.H.C. (2014), "Parametric study of composite beam-column connections using 3D finite element modeling", J. Construct. Steel Res., 102, 136-149. https://doi.org/10.1016/j.jcsr.2014.07.006
  18. Kataoka, M.N. and El Debs, A.L.H.C. (2015), "Beam-column composite connections under cyclic loading: An experimental study", Mater. Struct., 48(4), 929-946. https://doi.org/10.1617/s11527-013-0204-4
  19. Kim, H.Y. and Jeong, Y.J. (2010), "Ultimate strength of a steel-concrete composite bridge deck slab with profiled sheeting", Eng. Struct., 32(2), 534-546. https://doi.org/10.1016/j.engstruct.2009.10.014
  20. Marimuthu, V., Seetharaman, S., Arul Jayachandran, S., Chellappan, A., Bandyopadhyay, T.K. and Datta, D. (2007), "Experimental studies on composite deck slabs to determine the shear-bond characteristic (m-k) values of the embossed profile sheet", J. Construct. Steel Res., 63(6), 791- 803. https://doi.org/10.1016/j.jcsr.2006.07.009
  21. Salonikios, T.N., Sextos, A.G. and Kappos, A.J. (2012), "Tests on composite slabs and evaluation of relevant Eurocode 4 provisions", Steel Compos. Struct., Int. J., 13(6), 571-586. https://doi.org/10.12989/scs.2012.13.6.571
  22. Saravanan, M., Marimuthu, V., Prabha, P., Arul Jayachandran, S. and Datta, D. (2012), "Experimental investigations on composite slabs to evaluate longitudinal shear strength", Steel Compos. Struct., Int. J., 13(5), 489-500. https://doi.org/10.12989/scs.2012.13.5.489
  23. Shen, G. (2001), "Perfomance evaluation of new corrugated-type embossments for composite deck", M.A.Sc. Thesis.
  24. Seleim, S. and Schuster, R. (1985), "Shear-bond resistance of composite deck-slabs", Can. J. Civil Eng., National Research Council of Canada, 12(2), 316-324. https://doi.org/10.1139/l85-034
  25. Vainiünas, P., Valivonis, J., Marciukaitis, G. and Jonaitis, B. (2006), "Analysis of longitudinal shear behaviour for composite steel and concrete slabs", J. Construct. Steel Res., 62(12), 1264-1269. https://doi.org/10.1016/j.jcsr.2006.04.019
  26. Widjaja, R.B. (1997), "Analysis and design of steel deck - Concrete composite slabs", Master Dissertation; Faculty of the Virginia Polytechnic, Blacksburg, VA, USA.

피인용 문헌

  1. Simplified equations for Vierendeel design calculations of composite beams with web openings vol.27, pp.4, 2017, https://doi.org/10.12989/scs.2018.27.4.401
  2. Vibration performance of composite steel-bar truss slab with steel girder vol.30, pp.6, 2017, https://doi.org/10.12989/scs.2019.30.6.577
  3. Investigation on mechanical performance of flat steel plate-lightweight aggregate concrete hollow composite slab vol.31, pp.4, 2019, https://doi.org/10.12989/scs.2019.31.4.329
  4. Strengthening of steel-concrete composite beams with composite slab vol.34, pp.1, 2020, https://doi.org/10.12989/scs.2020.34.1.091
  5. Ultimate strength behavior of steel plate-concrete composite slabs: An experimental and theoretical study vol.37, pp.6, 2017, https://doi.org/10.12989/scs.2020.37.6.741
  6. Study on the ductility of open‐rib and re‐entrant composite slabs vol.4, pp.2, 2017, https://doi.org/10.1002/cepa.1357
  7. Experimental and numerical study of continuous span concrete composite slabs vol.34, pp.None, 2021, https://doi.org/10.1016/j.istruc.2021.08.043
  8. Experimental Study on the Behavior of Steel-Concrete Composite Decks with Different Shear Span-to-Depth Ratios vol.11, pp.12, 2017, https://doi.org/10.3390/buildings11120624