DOI QR코드

DOI QR Code

Comparison of Hoek-Brown and Mohr-Coulomb failure criterion for deep open coal mine slope stability

  • Aksoy, Cemalettin O. (Department of Mining Engineering, DokuzEylul University, Faculty of Engineering) ;
  • Uyar, Guzin G. (Department of Mining Engineering, Hacettepe University, Faculty of Engineering) ;
  • Ozcelik, Yilmaz (Department of Mining Engineering, Hacettepe University, Faculty of Engineering)
  • Received : 2016.03.18
  • Accepted : 2016.09.21
  • Published : 2016.12.10

Abstract

In deep open pit mines, slope stability is very important. Particularly, increasing the depths increase the risks in mines having weak rock mass. Blasting operations in this type of open pits may have a negative impact on slope stability. Several or combination of methods can be used in order to enable better analysis in this type of deep open-pit mines. Numerical modeling is one of these options. Many complex problems can be integrated into numerical methods at the same time and analysis, solutions can be performed on a single model. Rock failure criterions and rock models are used in numerical modeling. Hoek-Brown and Mohr-Coulomb terms are the two most commonly used rock failure conditions. In this study, mine planning and discontinuity conditions of a lignite mine facing two big landslides previously, has been investigated. Moreover, the presence of some damage before starting the study was identified in surrounding structures. The primary research of this study is on slope study. In slope stability analysis, numerical modeling methods with Hoek-Brown and Mohr-Coulomb failure criterions were used separately. Preparing the input data to the numerical model, the outcomes of patented-blast vibration minimization method, developed by co-author was used. The analysis showed that, the model prepared by applying Hoek-Brown failure criterion, failed in the stage of 10. However, the model prepared by using Mohr-Coulomb failure criterion did not fail even in the stage 17. Examining the full research field, there has been ongoing production in this mine without any failure and damage to surface structures.

Keywords

Acknowledgement

Supported by : Turkish Coal Enterprises (TKI)

References

  1. Aksoy, C.O., Ogul, K., Topal, I., Ozer, S.C., Ozacar, V. and Posluk, E. (2012), "Numerical modeling of nondeformable support in swelling and squeezing rock", Int. J. Rock Mech. Min., 5261-70.
  2. Aksoy, C.O., Onargan, T., Pamukcu, C., Kucuk, K. and O zacar, V. (2013), "The Determination of optimal evaluation condition of gumuspinar, sagirlar and civili coal field connected to bursa lignite management of TKI-GLI and research of the solution of landslides on gumuspinar section, revised project", The Prepare The Primary Project of Sagirlar and Civili Underground Reserves for Production, Appendix-2. (In Turkish)
  3. Aldas, G.G. and Kaypak, B. (2013), "The determination of optimal evaluation condition of gumuspinar, sagirlar and civili coal field connected to bursa lignite management of TKI-GLI and research of the solution of landslides on gumuspinar section", Revised Project, The Prepare The Primary Project of Sagirlar and Civili Underground Reserves for Production, Appendix-4. (In Turkish)
  4. Aldas, G.G.U. (2002), "Effect of some rock mass properties on blasting induced ground vibration wave characteristics at Orhaneli surface coal mine", Ph.D. thesis, Middle East Technical University, Department of Mining Engineering, Ankara, Turkey.
  5. Aldas, G.G.U. and Ecevitoglu B. (2008), "Waveform analysis in mitigation of blast-vibration", J. Appl. Geophys., 66, 25-30. https://doi.org/10.1016/j.jappgeo.2008.08.004
  6. Aldas, G.G.U. and Ecevitoglu, B. (2007), "Methodology for minimising blast-induced ground vibration", TPE. 2007/03459.
  7. Casciati, S., Chassiakos, A.G. and Masri, S.F. (2014), "Toward a paradigm for civil structural control", Smart Struct. Syst., 14(5), 981-1004. https://doi.org/10.12989/sss.2014.14.5.981
  8. Chen, B., Xu, Q. and Sun, D. (2014), "An elastoplastic model for structured clays", Geomech. Eng., 7(2), 213-231. https://doi.org/10.12989/gae.2014.7.2.213
  9. Chen, C.H., Zhu, Y.F., Yao, Y. and Huang, Y. (2016), "The finite element model research of the pre-twisted thin-walled beam", Struct. Eng. Mech., 57(3), 389-402. https://doi.org/10.12989/sem.2016.57.3.389
  10. Eberhardt, E. (2012), "The Hoek-Brown failure criterion", Rock Mech. Rock Eng. 45(6), 981-988. https://doi.org/10.1007/s00603-012-0276-4
  11. Feng, X.T. and Hudson, J.A. (2008), "Specifying the required information for rock engineering modeling and design", Int. J. Rock Mech. Min. Sci., 47, 179-94.
  12. Gokay, M.K., Ozkan, I., Ozsen, H., Dogan, K. and Mesutoglu, M. (2013), "The determination of optimal evaluation condition of gumuspinar, sagirlar and civili coal field connected to bursa lignite management of TKI-GLI and research of the solution of landslides on gumuspinar section", Revised Project, The Prepare The Primary Project of Sagirlar and Civili Underground Reserves for Production, Ek-3. (In Turkish)
  13. Griffith, A.A. (1920), "The phenomena of rupture and flow in solids", Philos. Trans. R. Soc. Lond. Ser. A. Math. Phys. Sci., 221(587), 163-198.
  14. Griffith, A.A. (1924), "The theory of rupture", Proceedings of the First International Congress for Applied Mechanics, Delft. J. Waltman Jr, Delft.
  15. Gunalay, M.E. (1974), "Bursa ili-Orhaneli ilcesi-Yenidanisment Koyu Civarinda Bulunan Maden Komuru sahasi Isletme Projesi", MTA Report No: 5271, p:43. (in Turkish)
  16. Hoek, E. (1968), Brittle Failure of Rock, Eds. Stagg, K.G., Zienkiewicz, O.C., Rock mechanics in engineering practice,Wiley, New York.
  17. Hoek, E. (1983), "Strength of jointed rock masses", 23rd Rankine Lecture, Geotechnique, 33(3), 187-223. https://doi.org/10.1680/geot.1983.33.3.187
  18. Hoek, E. and Bray, J.W. (1981), "Rock slope engineering", Institution of Mining and Metallurgy, London.
  19. Hoek, E. and Brown, E.T. (1980), "Underground excavations in rock", The Institution of Mining and Metallurgy, London.
  20. Hoek, E. and Brown, E.T. (1988), "The Hoek-Brown failure criterion-a 1988 update", Proceedings of the 15th Canadian Rock Mechanics Symposium, University of Toronto, Toronto.
  21. Jaeger, J.C. and Cook, N.G.W. (1979), Fundamentals of Rock Mechanics, 3rd Edition, Chapman & Hall, London.
  22. John, K.W. (1968), "Graphical stability analysis of slopes in jointed rock mass", J. Soil Found. Div., ASCE, 94(SM2), 497-523.
  23. Karpuz, C., Kocyigit, A., Tutluoglu, L., Duzgun, S., Kocal, A., Erdem, E. and Alkilicgil, C. (2006), "Turkiye Komur Isletmeleri Kurumu TKI, Orhaneli Isletmesi Acik Ocaklari Panolarinda Sev Tasarimi ve Dragline Calisma sisteminin Belirlenmesi Projesi", Proje kod no: 05-03-05-2-00-13. (in Turkish)
  24. Loh, C.H., Huang, Y.T., Hsiung, W.H., Yang, Y. and Loh, K.J. (2015), "Vibration-based identification of rotating blades using Rodrigues", Wind Struct., 21(6), 677-691. https://doi.org/10.12989/was.2015.21.6.677
  25. Londe, P., Vigier, G. and Vormeringer, R. (1969), "Stability of rock slopes-a three dimensional study", J. Soil and Found. Div., ASCE, 95(SM1), 235-262.
  26. Memikoglu, O. (1976), "Bursa-Orhaneli Komur Yatagi Fizibilite Arastirmasi", Cilt 1-Jeoloji. MTA Report no: 7112. (in Turkish)
  27. Men, J., Guo, Z. and Shi, Q. (2015a), "Experimental research on seismic behaviour of novel composite RCS joints", Steel Compos. Struct., 19(1), 209-221. https://doi.org/10.12989/scs.2015.19.1.209
  28. Men, J., Zhang, Y., Guo, Z. and Shi, Q. (2015b), "Experimental research on seismic behavior of a composite RCS frame", Steel Compos. Struct., 18(4), 971-983. https://doi.org/10.12989/scs.2015.18.4.971
  29. Nadai, A. (1950), Theory of Flow and Fracture of Solids, McGraw Hill, New York.
  30. Ozcelik, Y., Dirik, K., Cengiz, K., Ozsayin, E. and Yilmazkaya, E. (2013), "The determination of optimal evaluation condition of gumuspinar, sagirlar and civili coal field connected to bursa lignite management of TKI-GLI and research of the solution of landslides on gumuspinar section", Revised Project, The Prepare The Primary Project of Sagirlar and Civili Underground Reserves for Production, Appendix-1.
  31. Yaylac, M. (2016), "The investigation crack problem through numerical analysis", Struct. Eng. Mech., 57(6), 1141-1156.

Cited by

  1. Investigation lateral deformation and failure characteristics of strip coal pillar in deep mining vol.14, pp.5, 2016, https://doi.org/10.12989/gae.2018.14.5.421
  2. Numerical investigation of the impact of geological discontinuities on the propagation of ground vibrations vol.14, pp.6, 2018, https://doi.org/10.12989/gae.2018.14.6.545
  3. Law of Movement of Discontinuous Deformation of Strata and Ground with a Thick Loess Layer and Thin Bedrock in Long Wall Mining vol.10, pp.8, 2016, https://doi.org/10.3390/app10082874
  4. Experimental research on the effect of water-rock interaction in filling media of fault structure vol.24, pp.5, 2016, https://doi.org/10.12989/gae.2021.24.5.471
  5. Stability analysis of rock slopes using strength reduction adaptive finite element limit analysis vol.79, pp.4, 2016, https://doi.org/10.12989/sem.2021.79.4.487