DOI QR코드

DOI QR Code

Design and Analysis of a 12 V PWM Boost DC-DC Converter for Smart Device Applications

스마트기기를 위한 12 V 승압형 PWM DC-DC 변환기 설계 및 특성해석

  • Na, Jae-Hun (Department of Nanoscience & Engineering, Inje University/Department of Nanoscience and Engineering, Center for Nano Manufacturing, Inje University) ;
  • Song, Han-Jung (Department of Nanoscience & Engineering, Inje University/Department of Nanoscience and Engineering, Center for Nano Manufacturing, Inje University)
  • 나재훈 (인제대학교 나노융합공학과/인제대학교 나노매뉴팩처링 연구소) ;
  • 송한정 (인제대학교 나노융합공학과/인제대학교 나노매뉴팩처링 연구소)
  • Received : 2016.03.17
  • Accepted : 2016.06.02
  • Published : 2016.06.30

Abstract

In this study, a 12 V PWM boost converter was designed with the optimal values of the external components of the power stage was well as the compensation stage for smart electronic applications powered by a battery device. The 12 V boost PWM converter consisted of several passive elements, such as a resistor, inductor and capacitor with a diode, power MOS switch and control IC chip for the control PWM signal. The devices of the power stage and compensation stage were designed to maintain stable operation under a range of load conditions as well as achieving the highest power efficiency. The results of this study were first verified by a simulation in SPICE from calculations of the values of major external elements comprising the converter. The design was also implemented on the prototype PCBboard using commercial IC LM3481 from Texas Instruments, which has a nominal output voltage of 12 V. The output voltage, ripple voltage, and load regulation with the line regulation were measured using a digital oscilloscope, DMM tester, and DC power supply. By configuring the converter under the same conditions as in the circuit simulation, the experimental results matched the simulation results.

본 논문에서는 스마트기기의 배터리를 전원으로 갖는 12 V 승압형 PWM 변환기를 설계하고 컨버터를 구성하는 각 소자들의 손실을 계산하여 가장 안정적인 동작을 하는 설계 값을 도출하였다. 12 V 승압형 PWM 변환기는 저항, 커패시터 및 인덕터 등의 여러 수동소자를 비롯하여, 다이오드, 전력 스위치용 파워 MOS 트랜지스터와 PWM 신호제어를 위한 IC를 사용하여 구현하였다. 컨버터를 구성하는 주요 소자들의 이론적인 계산 값과 회로설계 해석프로그램인 PSPICE를 사용한 시뮬레이션 결과를 비교하고 각 소자 값들을 변화시키며 결과 파형을 분석한다. 분석한 컨버터를 실제 PCB 보드에 구성하고 디지털 오실로스코프와 DMM 멀티미터를 사용하여 측정하였고, SPICE 시뮬레이션을 통해 얻은 결과 값과 비교하였다. 설계한 컨버터에서 사용한 제어용 IC 칩은 TI(텍사스 인스트루먼트) 사의 LM3481을 사용하여 설계를 구현하였고, 5V 입력, 12V의 출력 값을 가지는 것을 확인하였다. 모의실험과 동일한 조건에서 출력전압, 리플전압 및 부하, 입력전압 변도율 등의 특성에 대한 측정결과는 SPICE 시뮬레이션 결과와 일치하는 것을 확인하였다.

Keywords

References

  1. L. M. Piao, "A study on Design of PMIC of SEPIC/BOOST Topology with Integrated current sensing circuit", Inha University Master degree , 2011.
  2. J. K. Kim, "Design of high-efficiency Buck DC-DC converter for reduction of control circuit loss," Hanyang University Master degree, 15-16, 2011.
  3. Xiaoming Duan, Haifei Deng, Nick X. Sun, Alex Q. Huang, Dan Y. Chen " A High Performance Intergrated Boost DC-DC converter For Portable Power Supply" 13-17, IEEE 2004. DOI: http://dx.doi.org/10.1109/APEC.2004.1295950
  4. Eric Magne Solie, "Soft Start Precharge Circuit for DC Power Supply," U.S. Patent 6 998 829, 2006.
  5. K. Jung, J. Lim, J. Park, H. Yang "A High Efficiency CMOS DC-DC Boost Converter with Current Sensing Feedback", IEEE Tran. Circuits and systems, 1-3, 2005. DOI: http://dx.doi.org/10.1109/MWSCAS.2005.1594437
  6. Said Oucheriah, Liping Guo, "PWM-Based Adaptive Sliding-Mode Control for Boost DC-DC Converters," IEEE Transactions on industrial electronics, vol. 60, no. 8, pp. 3291-3294, 3292-3293, 2013. DOI: http://dx.doi.org/10.1109/TIE.2012.2203769
  7. Gabriel A, Rincon-Mora, Philip E. Allen, "A Low-Voltage, Low Quiescent Current, Low Drop-Out Regulator", IEEE Journal of Solid-state Circuits, Vol. 33, 36-44, No. 1, Jan 1998. DOI: http://dx.doi.org/10.1109/4.654935
  8. C. F. Lee, Philip K. T. Mok, "A Monolithic Current-Mode CMOS DC-DC Converter With On-Chip Current-Sensing Technique", IEEE Journal of Solid-State Cirucits, Vol. 39, No. 1, 3-14, Jan 2004. DOI: http://dx.doi.org/10.1109/JSSC.2003.820870
  9. Y. Katayama, S. Sugahara, H. Nakazawa, M.Edo, "High-Power-Density MHz-Switching monolithic DC-DC Converter with Thin-Film Inductor", 1485-1490, IEEE 2000. DOI: http://dx.doi.org/10.1109/PESC.2000.880526
  10. D. M Bellur, M. K. Kazimierzuk, "DC-DC Converters for Electric Vehicle Applications", 286-293, 1-3, IEEE 2007. DOI: http://dx.doi.org/10.1109/EEIC.2007.4562633