초록
플랜지 볼트는 체결하중을 분산시키기 위한 와셔와 같은 역할을 하는 플랜지를 가지고 있으며, 주로 냉간단조로 성형된다. 플랜지의 단조 시 꽃무늬 모양의 결함이 발생할 수 있다. 이 결함은 치수 정밀도 및 품질 저하 등의 문제점을 야기할 수 있어 이에 대한 개선이 요구된다. 본 논문에서는 플랜지 볼트의 플라워 형상 결함을 개선하기 위한 금형 설계방법을 제안하고자 하였다. 이를 위해 기존의 단조 공정에서 앞판의 내경을 변수로 금형을 수정하였다. 수정된 금형을 적용한 단조 공정은 상용 유한요소해석 코드인 DEFORM-3D를 이용하여 시뮬레이션 하였고, 해석결과를 기준으로 단조 실험을 하여 결과의 신뢰성을 검증하였다.
Flange bolt has a circular flange under the head that acts like a washer to distribute the clamping load over a large area. Flange bolt has usually been manufactured by cold forging. Flower shape defect occurs in the flange forging stage. This defect causes lack of dimensional accuracy and low quality. So it is needed to improve these forging defects. In this study, die design method for flower shape defect of flange bolt was suggested. In order to improve flower shape defect, inner diameter of the addition die in conventional forging process was modified. The forging process with applied modified die was simulated by commercial FEM code DEFORM-3D. The simulated results for modified die were confirmed by experimental trials with the same condition.