Abstract
In the present experimental study, the effect of gas- and liquid-injected methods on the formation of bubble and liquid slug at the merging micro T-junction of a square microchannel with dimensions $600{\mu}m{\times}600{\mu}m$ was investigated. Nitrogen and water were used as test fluids. The superficial velocities of the liquid and gas were in the range of 0.05 - 1 m/s, and 0.1 - 1 m/s, respectively, where the Taylor flow was observed. The bubble length, liquid slug length, bubble velocity, and bubble generation frequency were measured by analyzing the images captured using a high-speed camera. Under similar inlet superficial velocity conditions, in the case of gas injection to the main channel at the merging T-junction (T_gas-liquid), the lengths of the bubble and liquid slug were longer, and the bubble generation frequency was lower than in the case of liquid injection to the main channel at the merging T-junction (T_liquid-gas). On the other hand, in both cases, the bubble velocity was almost the same. The previous correlation proposed using experimental data for T_liquid-gas had predicted the present experimental data of bubble length, bubble velocity, liquid slug length, and bubble generation frequency for T_gas-liquid to be ~24%, ~9%, ~39%, ~55%, respectively.
본 논문에서는 $600{\times}600{\mu}m$ 사각 마이크로 채널에서 T자형 합류지점에서의 기체 및 액체의 주입방법이 기포 및 액체 슬러그의 생성에 미치는 영향을 실험을 통해 살펴보았다. 실험 유체로는 질소와 물을 사용하였으며, 액체 및 기체 겉보기 속도는 각각 0.05 - 1 m/s, 0.1 - 1 m/s 의 범위로 테일러 유동이 나타나는 구간에서 데이터를 얻었다. 기포 길이, 액체 슬러그 길이, 기포 속도 그리고 기포 생성 빈도를 고속 카메라를 사용하여 이미지 분석을 통해 측정하였다. 유사한 입구 겉보기 속도 조건에서, T-자형 합류지점의 main channel에 기체를 주입하는 방법(T_gas-liquid)이 액체를 주입하는 방법(T_liquid-gas)보다 기포와 액체 슬러그의 길이가 길었고 기포 생성 빈도는 낮았다. 한편, 두 주입방법에서 기포 속도는 유사하게 나타났다. T_liquid-gas 주입방법의 기존 예측 상관식은 T_gas-liquid 주입방법의 기포 길이, 기포 속도, 액체 슬러그 길이, 기포 생성 빈도 실험데이터를 각각 ~24 %, ~9 %, ~39 %, ~55 %로 예측하였다.