DOI QR코드

DOI QR Code

Study of heavy fuel oil fly ash for use in concrete blocks and asphalt concrete mixes

  • Al-Osta, Mohammed A. (Department of Civil Engineering, King Fahd University of Petroleum & Minerals) ;
  • Baig, Mirza G. (Department of Civil Engineering, King Fahd University of Petroleum & Minerals) ;
  • Al-Malack, Muhammad H. (Department of Civil Engineering, King Fahd University of Petroleum & Minerals) ;
  • Al-Amoudi, Omar S. Baghabra (Department of Civil Engineering, King Fahd University of Petroleum & Minerals)
  • 투고 : 2016.11.10
  • 심사 : 2016.11.28
  • 발행 : 2016.06.25

초록

Use of heavy fuel fly ash (HFFA) (diesel and cracked fuel) for power generation in Saudi Arabia has generated and accumulated large quantities of HFFA as a byproduct. In this research, HFFA is studied with the emphasis on the utilization of this waste material in concrete blocks and asphalt concrete mixes. Two types of mixes, one with low and other with high cement content, were studied for concrete blocks. Different mixes having varying percentages of HFFA (0% to 25%), as cement/sand replacement or as an additive, were studied. The performance of concrete blocks is evaluated in terms of compressive strength, water absorption, durability and environmental concerns. The results showed that blocks cannot be cast if more than 15% HFFA is used; also there is a marginal reduction in the strength of all the mixes before and after being exposed to the sulfate solution for a period of ten months. HFFA is studied in asphalt concrete mixes in two ways, as an asphalt modifier (3&5%) and as a filler (50%) replacement, the results showed an improvement in stiffness and fatigue life of mixes. However, the stability and indirect tensile strength loss were found to be high as compared to the control mix due to moisture damage, indicating a need of using antistripping agents. On environmental concerns, it was found that most of the concerned elements are within acceptable limits also it is observed that lower concentration of barium is leached out with the higher HFFA concentrations, which indicates that HFFA may work as an adsorbent for this leaching element.

키워드

과제정보

연구 과제 주관 기관 : King Fahd University

참고문헌

  1. Al-Amoudi, O.S.B. (1995), "Performance of fifteen reinforced concretes in magnesium-sodium sulfate environments", Constr. Build. Mater., 9(3), 149-158. https://doi.org/10.1016/0950-0618(95)00007-3
  2. Al-Amoudi, O.S.B. (1998), "Sulfate attack and reinforcement corrosion in concrete exposed to sulfate environments", Build. Envir., 33(1), 53-61. https://doi.org/10.1016/S0360-1323(97)00022-X
  3. Al-Amoudi, O.S.B. (2002), "Attack on plain and blended cements exposed to aggressive sulfate environments", Cement Concrete Compos., 24(3-4), 305-316. https://doi.org/10.1016/S0958-9465(01)00082-8
  4. Al-Amoudi, O.S.B., Al-Kutti, W.A., Shamsad, A. and Maslehuddin, M. (2009), "Relationship between strength and durability indices for plain and blended cement concretes", Cement Concrete Compos., 31(9), 672-676. https://doi.org/10.1016/j.cemconcomp.2009.05.005
  5. Al-Amoudi, O.S.B., Maslehuddin, M. and Saadi, M.M. (1995), "Effect of magnesium sulfate and sodium sulfate on the durability performance of plain and blended cements", ACI Mater. J., 92(1), 15-24.
  6. Al-Malack, M.H., Bukhari, A.A., Al-Amoudi, O.S., Al-Muhanna, H.H. and Zaidi, T.H. (2013), "Characteristics of fly ash produced at power and water desalination plants firing fuel oil", Int. J. Envir. Res., 7(2), 455-466.
  7. Alonso-Hernandez, C.M., Bernal-Castillo, J., Bolanos-Alvarez, Y., Gomez-Batista, M. and Diaz-Asencio, M. (2011), "Heavy metal content of bottom ashes from a fuel oil power plant and oil refinery in Cuba", Fuel, 90(8), 2820-2823. https://doi.org/10.1016/j.fuel.2011.03.014
  8. Camilleri, J., Anastasi, M. and Torpiano, A. (2013), "The microstructure and physical properties of heavy oil fuel ash replaced Portland cement for use in flowable fill concrete and the production of concrete masonry units", Constr. Build. Mater., 38, 970-979. https://doi.org/10.1016/j.conbuildmat.2012.09.054
  9. Chesner, W.H. (1998), "User guidelines for waste and by-product materials in pavement construction", Federal Highway Administration, Turner-Fairbank Highway Research Center, McLean, Virginia.
  10. Colangelo, F., Cioffi, R., Montagnaro, F. and Santoro, L. (2012), "Soluble salt removal from MSWI fly ash and its stabilization for safer disposal and recovery as road basement material", Waste Manag., 32(6), 1179-1185. https://doi.org/10.1016/j.wasman.2011.12.013
  11. Dermatas, D. and Meng, X. (2003), "Utilization of fly ash for stabilization/solidification of heavy metal contaminated soils", Eng. Geol., 70(3-4), 377-394. https://doi.org/10.1016/S0013-7952(03)00105-4
  12. Dong, Y., Diwu, J., Feng, X., Feng, X., Liu, X. and Meng, G. (2008), "Phase evolution and sintering characteristics of porous mullite ceramics produced from the flyash-Al $(OH)_3$ coating powders", J. Alloys Comp., 460(1-2), 651-657. https://doi.org/10.1016/j.jallcom.2007.06.043
  13. Environmental Protection Agency (EPA). (1998), "Back document for proposed CPG III and draft RMAN III", EPA Report EPA530-R-98-003.
  14. Jones, M.R., McCarthy, A. and Booth, A.P.P.G. (2006), "Characteristics of the ultrafine component of fly ash", Fuel, 85(16), 2250-2259. https://doi.org/10.1016/j.fuel.2006.01.028
  15. Kikas, W. (1997), "Composition and binder properties of Estonian Kukersite oil shale ash", J. ZKG Internat., 50(2), 112-125.
  16. Komnitsas, K. and Zaharaki, D. (2007), "Geopolymerisation: A review and prospects for the minerals industry", Miner. Eng., 20(14), 1261-1277. https://doi.org/10.1016/j.mineng.2007.07.011
  17. Mirza, J., Mirza, M., Roya, V. and Saleh, K. (2002), "Basic rheological and mechanical properties of high-volume fly ash grouts", Constr. Build. Mater., 16(6), 353-363. https://doi.org/10.1016/S0950-0618(02)00026-0
  18. Mofarrah, A. and Husain, T. (2013), "Use of heavy oil fly ash as a color ingredient in cement mortar", Concrete Struct. Mater., 7(2), 111-117. https://doi.org/10.1007/s40069-013-0042-3
  19. Mymrin, V.A. and Ponte, H.A. (2005), "Oil-shale fly ash utilization as independent binder of natural clayey soils for road and airfield base construction", J. Parti. Sci. Tech., 23(1), 99-107. https://doi.org/10.1080/02726350590902505
  20. Nazari, A., Bagheri A. and Riahi S. (2011), "Properties of geopolymer with seeded fly ash and rice husk bark ash", Mater. Sci. Eng., 528(24), 7395-7401. https://doi.org/10.1016/j.msea.2011.06.027
  21. Paya, J., Borrachero, M.V., Monzo, J. and Bonilla M. (1999), "Properties of Portland cement mortars incorporating high amounts of oil-fuel ashes", Waste Manag., 19(1), 1-7. https://doi.org/10.1016/S0956-053X(98)00079-8
  22. Pires, M. and Querol, X. (2004), "Characterization of Candiota (South Brazil) coal and combustion by-product", Coal Geol., 60(1), 57-72. https://doi.org/10.1016/j.coal.2004.04.003
  23. Prabakar, J., Dendorkar, N. and Morchhale, R.K. (2004), "Influence of fly ash on strength behavior of typical soils", Constr. Build. Mater., 18(4), 263-267. https://doi.org/10.1016/j.conbuildmat.2003.11.003
  24. Sarkara, A., Ranoa, R., Mishra, K.K. and Sinha, I.N. (2005), "Particle size distribution profile of some Indian fly ash - a comparative study to assess their possible uses", Fuel Process. Technol., 86(11), 1221-1238. https://doi.org/10.1016/j.fuproc.2004.12.002
  25. Sarkara, A., Ranoa, R., Udaybhanua, G. and Basub, A.K. (2006), "A comprehensive characterization of fly ash from a thermal power plant in Eastern India", Fuel Process. Technol., 87(3), 259-277. https://doi.org/10.1016/j.fuproc.2005.09.005
  26. Sezer, A., Inan, G., Yilmaz, R.H. and Ramyar, K. (2006), "Utilization of a very high lime fly ash for improvement of Izmir clay", Build. Envir., 41(2), 150-155. https://doi.org/10.1016/j.buildenv.2004.12.009
  27. U. S. EPA. (1999), "Wastes from the combustion of fossil fuel I and II", EPA 530-R-99-010, United States Environmental Protection Agency, Washington, DC.
  28. Yazic, H. (2007), "Utilization of coal combustion by products in building blocks", Fuel, 86(7-6), 929-937. https://doi.org/10.1016/j.fuel.2006.10.014

피인용 문헌

  1. Effect of cement as mineral filler on the performance development of emulsified asphalt concrete vol.10, pp.6, 2016, https://doi.org/10.12989/acc.2020.10.6.515
  2. Enhancement of road pavement material using conventional and nano-crude oil fly ash vol.11, pp.10, 2016, https://doi.org/10.1007/s13204-021-02103-z