DOI QR코드

DOI QR Code

A comparison between the dynamic and static stiffness of ballasted track: A field study

  • Mosayeb, Seyed-Ali (School of Railway Engineering, Iran University of Science and Technology) ;
  • Zakeri, Jabbar-Ali (School of Railway Engineering, Iran University of Science and Technology) ;
  • Esmaeili, Morteza (School of Railway Engineering, Iran University of Science and Technology)
  • 투고 : 2015.09.13
  • 심사 : 2016.07.11
  • 발행 : 2016.12.12

초록

Rail support modulus is an important parameter for analysis and design of ballasted railway tracks. One of the challenges in track stiffness assessment is its dynamic nature under the moving trains which differs it from the case of standing trains. So the present study is allocated to establish a relation between the dynamic and static stiffness of ballasted tracks via field measurements. In this regard, two different sites of ballasted tracks with wooden and concrete sleepers were selected and the static and dynamic stiffness were measured based on Talbot - Wasiutynski method. In this matter, the selected tracks were loaded by two heavy and light car bodies for standing and moving conditions and consequently the deflection basins were evaluated in both sites. Knowing the deflection basins respect to light and heavy loading conditions, both of static and dynamic stiffness values were extracted. Finally two definite relations were obtained for ballasted tracks with wooded and concrete sleepers.

키워드

참고문헌

  1. Ahlbeck, D.R., Meacham, H.C. and Prause, R.H. (1978), "The development of analytical models for railroad track dynamics", In: Railroad Track Mechanics & Technology, (A.D. Kerr Ed.), Pergamon Press, Oxford, UK.
  2. Andersson, A., Berglund, H., Blomberg, J. and Yman, O. (2013), "The influence of stiffness variations in railway tracks a study on design, construction, monitoring and maintenance procedures to obtain suitable support conditions for railway sleepers", Bachelor Thesis; Civil Engineering, Department of Applied Mechanics Division of Dynamics, Chalmers University of Technology, Goteborg, Sweden.
  3. Berggren, E.G. (2009), "Railway, track stiffness - dynamic measurements and evaluation for efficient maintenance", Ph.D. Thesis; Royal Institute of Technology Sweden.
  4. Berggren, E.G, Nissen, A. and Paulsson, B.S. (2014), "Track deflection and stiffness measurements from a track recording car", Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 228(6), 570-580. https://doi.org/10.1177/0954409714529267
  5. Byun, Y.H., Hong, W.T. and Lee, J.S. (2015), "Characterization of railway substructure using a hybrid cone penetrometer", Smart Struct. Syst., Int. J., 15(4), 1085-1101. https://doi.org/10.12989/sss.2015.15.4.1085
  6. Dahlberg, T. (2010), "Railway track stiffness variations - consequences and countermeasures", Int. J. Civil Eng., 8(1), 1-12.
  7. De Chiara, F., Pereira, D., Fontul, S. and Fortunato E. (2012), "Track substructure assessment using non-destructive load tests. A portuguese case study", Procedia - Social and Behavioral Sciences, 53, 1131-1140.
  8. Feng, H. (2011), "3D-models of railway track for dynamic analysis", Master Degree Project; Royal Institute of Technology, Stockholm, Sweden.
  9. Fernandes, V.A., Lopez-Caballero, F. and d'Aguiar, S.C. (2014), "Probabilistic analysis of numerical simulated railway track global stiffness", Comput. Geotech., 55, 267-276. https://doi.org/10.1016/j.compgeo.2013.09.017
  10. Kerr, A.D. (2000), "On the determination of the rail support modulus k", Int. J. Solids Struct., 37(32), 4335-4351. https://doi.org/10.1016/S0020-7683(99)00151-1
  11. Kerr, A.D. (2003), Fundamentals of Railway Track Engineering, Simmons-Boardman Books, Inc.
  12. Leaflet No. 301 (2002), Technical and general specification of ballasted railway; Management and Planning Organization of Iran, Tehran, Iran.
  13. Li, M.X.D. and Berggren, E.G. (2010), "A study of the effect of global track stiffness and its variations on track performance: simulation and measurement", Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 224(5), 375-382. https://doi.org/10.1243/09544097JRRT361
  14. Mittal, S. and Meyase, K. (2012), "Study for improvement of grounds subjected to cyclic loads", Geomech. Eng., Int. J., 4(3), 191-208. https://doi.org/10.12989/gae.2012.4.3.191
  15. Puzavac, L., Popovic, Z. and Lazarevic, L. (2012), "Influence of track stiffness on track behavior under vertical load", Sci. J. Traffic Transport. Res., 24(5), 405-412.
  16. Selig, E.T. and Li, D. (1994), "Track modulus: its meaning and factors influencing it", Transportation Research Record; No 1470, ISSN 0361-1981.
  17. Talbot, A.N. (1918), ASCE-AREA committee on "stresses in rail road tracks", First Progress Report; In: Proceedings of AREA, Volume 19.
  18. Wang, C., Zhou, S., Wang, B., Guo, P. and Su, H. (2015), "Differential settlements in foundations under embankment load: Theoretical model and experimental verification", Geomech. Eng., Int. J., 8(2), 283-303. https://doi.org/10.12989/gae.2015.8.2.283
  19. Wasiutynski, A. (1937), "Experimental research on the elastic deformation sand stresses in a railroad track", In: Annalesde L'Academie des Sciences Techniques a Varsavie, Volume 5, Dunod, Paris, France. [In French]
  20. With, C. and Bodare, A. (2009), "Evaluation of track stiffness with a vibrator for prediction of train-induced displacement on railway embankments", Soil Dyn. Earthq. Eng., 29(8), 1187-1197. https://doi.org/10.1016/j.soildyn.2008.11.010
  21. Zakeri, J.A. and Abbasi, R. (2012), "Field investigation of variation of rail support modulus in ballasted railway track", Latin Am. J. Solids Struct., 9(6), 643-656. https://doi.org/10.1590/S1679-78252012000600002
  22. Zakeri, J.A., Esmaeili, M., Mosayebi, S.A. and Abbasi, R. (2012), "Effects of vibration in desert area caused by moving trains", J. Modern Transport., 20(1), 16-23. https://doi.org/10.1007/BF03325772
  23. Zhai, W.M. and Sun, X. (1994), "A detailed model for investigating vertical interaction between railway vehicle and track", Vehicle Syst. Dyn., 23(1), 603-615. https://doi.org/10.1080/00423119308969544
  24. Zhai, W.M., Wang, K.Y. and Lin, J.H. (2004), "Modelling and experiment of railway ballast vibrations", J. Sound Vib., 270(4-5), 673-683. https://doi.org/10.1016/S0022-460X(03)00186-X

피인용 문헌

  1. Vertical load distribution in ballasted railway tracks with steel slag and limestone ballasts 2017, https://doi.org/10.1080/10298436.2017.1380808
  2. 3D stress-fractional plasticity model for granular soil vol.17, pp.4, 2016, https://doi.org/10.12989/gae.2019.17.4.385