DOI QR코드

DOI QR Code

Characterization of Polyester Cloth as an Alternative Separator to Nafion Membrane in Microbial Fuel Cells for Bioelectricity Generation Using Swine Wastewater

  • Kim, Taeyoung (Energy and Environmental Engineering Division, National Institute of Agricultural Science, Rural Development Administration) ;
  • Kang, Sukwon (Energy and Environmental Engineering Division, National Institute of Agricultural Science, Rural Development Administration) ;
  • Sung, Je Hoon (Energy and Environmental Engineering Division, National Institute of Agricultural Science, Rural Development Administration) ;
  • Kang, Youn Koo (Energy and Environmental Engineering Division, National Institute of Agricultural Science, Rural Development Administration) ;
  • Kim, Young Hwa (Energy and Environmental Engineering Division, National Institute of Agricultural Science, Rural Development Administration) ;
  • Jang, Jae Kyung (Energy and Environmental Engineering Division, National Institute of Agricultural Science, Rural Development Administration)
  • Received : 2016.08.19
  • Accepted : 2016.09.12
  • Published : 2016.12.28

Abstract

Polyester cloth (PC) was selected as a prospective inexpensive substitute separator material for microbial fuel cells (MFCs). PC was compared with a traditional Nafion proton exchange membrane (PEM) as an MFC separator by analyzing its physical and electrochemical properties. A single layer of PC showed higher mass transfer (e.g., for $O_2/H^+/ions$) than the Nafion PEM; in the case of oxygen mass transfer coefficient ($k_o$), a rate of $50.0{\times}10^{-5} cm{\cdot}s^{-1}$ was observed compared with a rate of $20.8{\times}10^{-5}cm/s$ in the Nafion PEM. Increased numbers of PC layers were found to reduce the oxygen mass transfer coefficient. In addition, the diffusion coefficient of oxygen ($D_O$) for PC ($2.0-3.3{\times}10^{-6}cm^2/s$) was lower than that of the Nafion PEM ($3.8{\times}10^{-6}cm^2/s$). The PC was found to have a low ohmic resistance ($0.29-0.38{\Omega}$) in the MFC, which was similar to that of Nafion PEM ($0.31{\Omega}$); this resulted in comparable maximum power density and maximum current density in MFCs with PC and those with Nafion PEMs. Moreover, a higher average current generation was observed in MFCs with PC ($104.3{\pm}15.3A/m^3$) compared with MFCs with Nafion PEM ($100.4{\pm}17.7A/m^3$), as well as showing insignificant degradation of the PC surface, during 177 days of use in swine wastewater. These results suggest that PC separators could serve as a low-cost alternative to Nafion PEMs for construction of cost-effective MFCs.

Keywords

References

  1. Chae KJ, Choi M, Ajayi FF, Park W, Chang IS, Kim IS. 2007. Mass transport through a proton exchange membrane (nafion) in microbial fuel cells. Energy Fuels 22: 169-176.
  2. Chae KJ, Choi MJ, Lee JW, Kim KY, Kim IS. 2009. Effect of different substrates on the performance, bacterial diversity, and bacterial viability in microbial fuel cells. Bioresour. Technol. 100: 3518-3525. https://doi.org/10.1016/j.biortech.2009.02.065
  3. Chang I-S, Moon H-S, Bretschger O, Jang J-K, Park H-I, Nealson KH, Kim B-H. 2006. Electrochemically active bacteria (EAB) and mediator-less microbial fuel cells. J. Microbiol. Biotechnol. 16: 163-177.
  4. Choi M-J, Chae K-J, Ajayi FF, Kim K-Y, Yu H-W, Kim C-W, Kim IS. 2011. Effects of biofouling on ion transport through cation exchange membranes and microbial fuel cell performance. Bioresour. Technol. 102: 298-303. https://doi.org/10.1016/j.biortech.2010.06.129
  5. Choi S, Kim JR, Cha J, Kim Y, Premier GC, Kim C. 2013. Enhanced power production of a membrane electrode assembly microbial fuel cell (MFC) using a cost effective poly [2, 5-benzimidazole](ABPBI) impregnated non-woven fabric filter. Bioresour. Technol. 128: 14-21. https://doi.org/10.1016/j.biortech.2012.10.013
  6. Christgen B, Scott K, Dolfing J, Head IM, Curtis TP. 2015. An evaluation of the performance and economics of membranes and separators in single chamber microbial fuel cells treating domestic wastewater. PLoS One 10: e0136108. https://doi.org/10.1371/journal.pone.0136108
  7. Daud SM, Kim BH, Ghasemi M, Daud WRW. 2015. Separators used in microbial electrochemical technologies: current status and future prospects. Bioresour. Technol. 195: 170-179. https://doi.org/10.1016/j.biortech.2015.06.105
  8. Fan Y, Sharbrough E, Liu H. 2008. Quantification of the internal resistance distribution of microbial fuel cells. Environ. Sci. Technol. 42: 8101-8107. https://doi.org/10.1021/es801229j
  9. Ghasemi M, Daud WRW, Ismail AF, Jafari Y, Ismail M, Mayahi A, Othman J. 2013. Simultaneous wastewater treatment and electricity generation by microbial fuel cell: performance comparison and cost investigation of using Nafion 117 and SPEEK as separators. Desalination 325: 1-6. https://doi.org/10.1016/j.desal.2013.06.013
  10. Jang JK, Kim KM, Byun S, Ryou YS, Chang IS, Kang YK, Kim YH. 2014. Current generation from microbial fuel cell using stainless steel wire as anode electrode. J. Kor. Soc. Environ. Eng. 36: 753-757. https://doi.org/10.4491/KSEE.2014.36.11.753
  11. Jang JK, Moon HS, Chang IS, Kim BH. 2005. Improved performance of microbial fuel cell using membrane-electrode assembly. J. Microbiol. Biotechnol. 15: 438-441.
  12. Kim D, Chang IS. 2009. Electricity generation from synthesis gas by microbial processes: CO fermentation and microbial fuel cell technology. Bioresour. Technol. 100: 4527-4530. https://doi.org/10.1016/j.biortech.2009.04.017
  13. Kim JR, Cheng S, Oh S-E, Logan BE. 2007. Power generation using different cation, anion, and ultrafiltration membranes in microbial fuel cells. Environ. Sci. Technol. 41: 1004-1009. https://doi.org/10.1021/es062202m
  14. Kim T, An J, Jang JK, Chang IS. 2015. Coupling of anaerobic digester and microbial fuel cell for COD removal and ammonia recovery. Bioresour. Technol. 195: 217-222. https://doi.org/10.1016/j.biortech.2015.06.009
  15. Kim T, An J, Lee H, Jang JK, Chang IS. 2016. pH-dependent ammonia removal pathways in microbial fuel cell system. Bioresour. Technol. 215: 290-295. https://doi.org/10.1016/j.biortech.2016.03.167
  16. Kondaveeti S, Lee J, Kakarla R, Kim HS, Min B. 2014. Lowcost separators for enhanced power production and field application of microbial fuel cells (MFCs). Electrochim. Acta 132: 434-440. https://doi.org/10.1016/j.electacta.2014.03.046
  17. Li W-W, Sheng G-P, Liu X-W, Yu H-Q. 2011. Recent advances in the separators for microbial fuel cells. Bioresour. Technol. 102: 244-252. https://doi.org/10.1016/j.biortech.2010.03.090
  18. Liu H, Cheng S, Logan BE. 2005. Power generation in fedbatch microbial fuel cells as a function of ionic strength, temperature, and reactor configuration. Environ. Sci. Technol. 39: 5488-5493. https://doi.org/10.1021/es050316c
  19. Liu H, Logan BE. 2004. Electricity generation using an aircathode single chamber microbial fuel cell in the presence and absence of a proton exchange membrane. Environ. Sci. Technol. 38: 4040-4046. https://doi.org/10.1021/es0499344
  20. Liu H, Logan BE. 2004. Electricity generation using an aircathode single chamber microbial fuel cell in the presence and absence of a proton exchange membrane. Environ. Sci. Technol. 38: 4040-4046. https://doi.org/10.1021/es0499344
  21. Liu H, Ramnarayanan R, Logan BE. 2004. Production of electricity during wastewater treatment using a single chamber microbial fuel cell. Environ. Sci. Technol. 38: 2281-2285. https://doi.org/10.1021/es034923g
  22. Min B, Cheng S, Logan BE. 2005. Electricity generation using membrane and salt bridge microbial fuel cells. Water Res. 39: 1675-1686. https://doi.org/10.1016/j.watres.2005.02.002
  23. Oh S, Min B, Logan BE. 2004. Cathode performance as a factor in electricity generation in microbial fuel cells. Environ. Sci. Technol. 38: 4900-4904. https://doi.org/10.1021/es049422p
  24. Rozendal RA, Hamelers HV, Buisman CJ. 2006. Effects of membrane cation transport on pH and microbial fuel cell performance. Environ. Sci. Technol. 40: 5206-5211. https://doi.org/10.1021/es060387r
  25. Xu J, Sheng G-P, Luo H-W, Li W-W, Wang L-F, Yu H-Q. 2012. Fouling of proton exchange membrane (PEM) deteriorates the performance of microbial fuel cell. Water Res. 46: 1817-1824. https://doi.org/10.1016/j.watres.2011.12.060
  26. Zhang X, Cheng S, Huang X, Logan BE. 2010. Improved performance of single-chamber microbial fuel cells through control of membrane deformation. Biosens. Bioelectron. 25: 1825-1828. https://doi.org/10.1016/j.bios.2009.11.018
  27. Zhang X, Cheng S, Wang X, Huang X, Logan BE. 2009. Separator characteristics for increasing performance of microbial fuel cells. Environ. Sci. Technol. 43: 8456-8461. https://doi.org/10.1021/es901631p

Cited by

  1. Assessment of organic removal in series- and parallel-connected microbial fuel cell stacks vol.22, pp.6, 2016, https://doi.org/10.1007/s12257-017-0378-7
  2. Living Architecture: Toward Energy Generating Buildings Powered by Microbial Fuel Cells vol.7, pp.None, 2016, https://doi.org/10.3389/fenrg.2019.00094
  3. A study on development of alternative biopolymers based proton exchange membrane for microbial fuel cells and effect of blending ratio and ionic crosslinking on bioenergy generation and COD removal vol.26, pp.12, 2016, https://doi.org/10.1007/s10965-019-1957-4
  4. Marketability Prospects of Microbial Fuel Cells for Sustainable Energy Generation vol.34, pp.8, 2016, https://doi.org/10.1021/acs.energyfuels.0c01766
  5. Optimization of microbial fuel cell process using a novel consortium for aromatic hydrocarbon bioremediation and bioelectricity generation vol.298, pp.None, 2016, https://doi.org/10.1016/j.jenvman.2021.113546