DOI QR코드

DOI QR Code

Evaluation of Shear Behavior of Beams Strengthened in Shear with Carbon Fiber Reinforced Polymer with Mohr's Circle

모어써클을 활용한 탄소섬유 전단보강된 보의 전단거동 평가

  • Kim, Yun-Gon (Hyundai Engineering and Construction, R&D Division)
  • 김윤곤 (현대건설 연구개발본부)
  • Received : 2016.02.13
  • Accepted : 2016.08.01
  • Published : 2016.10.30

Abstract

Beams strengthened in shear with Carbon Fiber Reinforced Polymer (CFRP) which had different transverse reinforcement ratio were tested to evaluate shear contribution in the CFRP and to analyze shear behavior of each test with Mohr's circle. Strain in the CFRP should be evaluated to estimate the shear contribution in the CFRP which is brittle material. Test results were compared each other based on the Mohr's circle which can correlate shear strain with both principal tensile strain and crack angle. With low transverse steel ratio, shear strengthening with CFRP not only increases the shear strength effectively but also minimizes the loss in shear contribution of concrete by limiting the development of crack. With high transverse steel ratio, the effect on shear strengthening with CFRP is not as much as the beam with low ratio. Therefore, the shear contribution in the CFRP should be evaluated based on the strain compatibility which can consider the interaction between steel and CFRP when determining the shear capacity of a strengthened member.

CFRP의 전단강도 기여분을 평가하고, 모어서클을 이용하여 전단거동 특성을 분석하기 위해 전단철근비가 서로 다른 보에 동일한 탄소섬유 전단보강 설계한 보 실험을 수행하였다. 취성특성을 가지는 CFRP의 전단기여분을 평가하기 위해서는 CFRP의 변형률을 평가해야 한다. 각 실험결과는 모어써클(Mohr's Circle)을 활용하여 전단변형률을 주인장변형률 및 균열각도의 변화와 연계하여 비교하였다. 전단철근비가 작은 경우 탄소섬유 자체의 전단강도 기여분 뿐만 아니라 탄소섬유에 의해 콘크리트 균열의 진전을 제어하여 균열에 의한 콘크리트의 성능저하를 최소화한다. 전단철근비가 큰 경우는 전단철근비가 작을 때 보다 탄소섬유 보강효과가 크지 않았다. 따라서 보강부재의 전단성능을 결정할 때 탄소섬유의 전단강도 기여분은 전단철근과의 상호작용을 고려할 수 있는 변형적합조건에 근거하여 평가되어야 한다.

Keywords

References

  1. ACI Committee 440, "Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures (ACI 440.2R-08)", American Concrete Institute, 2008, pp.45.
  2. National Cooperative Highway Research Program (NCHRP), "Bonded repair and retrofit of concrete structures using FRP composites: recommended construction specifications and process control manual (Report 514)", Transportation Research Board, Washington, D.C., 2004.
  3. National Cooperative Highway Research Program (NCHRP), "Recommended guide specification for the design of externally bonded FRP systems for repair and strengthening of concrete bridge elements (Report 655)", Transportation Research Board, Washington, D.C., 2010, pp.118.
  4. National Cooperative Highway Research Program (NCHRP), "Design of FRP Systems for Strengthening Concrete Girders in Shear (Report 678)", Transportation Research Board, Washington, D.C., 2011.
  5. Korea Institute of Civil Engineering and Building Technology, "Establishment of test items, methods and criteria for certification of FRP strengthening technology" (R&D / 2004-A13), 2006, pp.1014.
  6. Khalifa, A., and Nanni, A., "Improving shear capacity of existing RC T-section beams using CFRP composites", Cement and Concrete Composites, Vol.22, No.3, 2000, pp.165-174. https://doi.org/10.1016/S0958-9465(99)00051-7
  7. Lim, D., and Nam, M., "Shear Behavior of Reinforced Concrete Beams Strengthened with CFRP strips", Journal of the Korea Concrete Institute, Vol.20, No.3, 2008, pp.299-305. https://doi.org/10.4334/JKCI.2008.20.3.299
  8. Lim, D., and Kwon, Y., "An Experimental Study on the Shear Behavior of RC Beams Strengthened with Near Surface Mounted and Externally Bonded CFRP Strips", Journal of the Korea Concrete Institute, Vol.21, No.3, 2009, pp.337-345. https://doi.org/10.4334/JKCI.2009.21.3.337
  9. Chen, G., Teng, J., Chen, J., and Rosenboom, O., "Interaction between Steel Stirrups and Shear-Strengthening FRP Strips in RC Beams", Journal of Composites for Construction, Vol.14, No.5, 2010, pp.498-509. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000120
  10. Sas, G., Taljsten, B., Barros, J., Lima, J., and Carolin, A., "Are Available Models Reliable for Predicting the FRP Contribution to the Shear Resistance of RC Beams?", Journal of Composites for Construction, Vol.13, No.6, 2009, pp.514-534. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000045
  11. Orton, S., Jirsa, J., and Bayrak O., "Design Considerations of Carbon Fibre Anchors", Journal of Composites for Construction, ASCE, Vol.12, No.6, 2008, pp. 608-616. https://doi.org/10.1061/(ASCE)1090-0268(2008)12:6(608)
  12. Hu, S., Kim, S., and Seracino, R., "FRP-strengthened RC Slabs Anchored with FRP Anchors", Engineering Structures, Vol.33, No.4, 2011, pp. 1075-1087. https://doi.org/10.1016/j.engstruct.2010.11.018
  13. Koutas, L., and Triantafillou, T. C., "Use of Anchors in Shear Strengthening of Reinforced Concrete T-Beams with FRP", Journal of Composites for Construction, Vol.17, No.1, 2013 pp.101-107. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000316
  14. Kim, Y., Quinn, K., Satrom, N., Garcia, J., Sun, W., Ghannoum, W., and Jirsa, J.,"Shear Strengthening of Large Reinforced and Prestressed Concrete Elements Using Carbon Fiber Reinforced Polymer (CFRP) Sheets and CFRP Anchors", Center for Transportation Research(CTR), Report 0-6306-1, 2012, pp.296.
  15. Kim, Y. , Ghannoum, W., and Jirsa, J., "Shear Behavior of Full-scale Reinforced Concrete T-beams Strengthened with CFRP Strips and Anchors", Construction and Building Materials, Vol.94, 2015, pp. 1-9. https://doi.org/10.1016/j.conbuildmat.2015.06.005
  16. Korea Concrete Institute, "Concrete Design Code and Commentary", Kimoondang Publishing Company, Seoul, Korea, 2012.
  17. ACI Committee 318, "Building Code Requirements for Structural Concrete (ACI 318-14) and Commentary", American Concrete Institute, Farmington Hills, MI, 2014.