DOI QR코드

DOI QR Code

Effect of base isolation systems on increasing the resistance of structures subjected to progressive collapse

  • Tavakoli, Hamid R. (Department of Earthquake Engineering, Babol University and Technology) ;
  • Naghavi, Fahime (Department of Earthquake Engineering, Babol University and Technology) ;
  • Goltabar, Ali R. (Department of Earthquake Engineering, Babol University and Technology)
  • 투고 : 2014.02.16
  • 심사 : 2015.04.14
  • 발행 : 2015.09.25

초록

Seismic isolation devices are commonly used to mitigate damages caused by seismic responses of structures. More damages are created due to progressive collapse in structures. Therefore, evaluating the impact of the isolation systems to enhance progressive collapse-resisting capacity is very important. In this study, the effect of lead rubber bearing isolation system to increase the resistance of structures against progressive collapse was evaluated. Concrete moment resisting frames were used in both the fixed and base-isolated model structures. Then, progressive collapse-resisting capacity of frames was investigated using the push down nonlinear static analysis under gravity loads that specified in GSA guideline. Nonlinear dynamic analysis was performed to consider dynamic effects column removal under earthquake. The results of the push down analysis are highly dependent on location of removal column and floor number of buildings. Also, seismic isolation system does not play an effective role in increasing the progressive collapse-resisting capacities of structures under gravity loads. Base isolation helps to localize failures and prevented from spreading it to intact span under seismic loads.

키워드

참고문헌

  1. ACI318-08 (2008), Building code requirements for structural concrete and commentary, American Concrete Institute, Washington, DC.
  2. ATC (1996), Seismic evaluation and retrofit of concrete buildings, Report No. ATC-40, Applied Technology Council, Redwood City, California.
  3. Corley, W.G., Sr, P.F.M., Sozen, M.A. and Thornton, C.H. (1998), "The Oklahoma City bombing: Summary and recommendations for multihazard mitigation", J. Perform. Constr. Facil, 12(3), 100-112. https://doi.org/10.1061/(ASCE)0887-3828(1998)12:3(100)
  4. Corley, W.G. (2002), "Applicability of seismic design in mitigating progressive collapse", Proceedings of National Workshop on Prevention of Progressive Collapse, Chicago.
  5. Crawford, J.E. (2002), "Retrofit methods to mitigate progressive collapse", Multihazard Mitigation Council National Workshop on Prevention on Progressive Collapse, Chicago.
  6. Ellingwood, B.R., Smilowitz, R., Dusenberry, D.O., Duthinh, D., Lew, H. and Carino, N. (2007), Best practices for reducing the potential for progressive collapse in buildings, US Department of Commerce, National Institute of Standards and Technology.
  7. FEMA (1997), NEHRP guidelines for the seismic rehabilitation of buildings, Report No. FEMA 273/274, Federal Emergency Agency, Washington, DC.
  8. GSA (2003), Progressive collapse analysis and design guidelines for new federal office buildings and major modernization projects, The US General Services Administration, Washington, DC.
  9. Hayes Jr, J.R., Woodson, S.C., Pekelnicky, R.G., Poland, C.D., Corley, W.G. and Sozen, M. (2005), "Can strengthening for earthquake improve blast and progressive collapse resistance?", J. Struct. Eng., 131(8), 1157-1177. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:8(1157)
  10. Jangid, R. (2007), "Optimum lead-rubber isolation bearings for near-fault motions", Eng. Struct., 29(10), 2503-2513. https://doi.org/10.1016/j.engstruct.2006.12.010
  11. Kaewkulchai, G. and Williamson, E. (2003), "Dynamic behavior of planar frames during progressive collapse", 16th ASCE engineering mechanics conference, Seattle, University of Washington.
  12. Kang, B.S., Li, L. and Ku, T.W. (2009), "Dynamic response characteristics of seismic isolation systems for building structures", J. Mech. Sci. Technol., 23(8), 2179-2192. https://doi.org/10.1007/s12206-009-0437-x
  13. Karimiyan, S., Moghadam, A.S., Karimiyan, M. and Kashan, A.H. (2013a), "Seismic collapse propagation in 6-story RC regular and irregular buildings", Earthq. Struct., 5(6), 753-779. https://doi.org/10.12989/eas.2013.5.6.753
  14. Karimiyan, S., Moghadam, A.S. and Vetr, M.G. (2013b), "Seismic progressive collapse assessment of 3-story RC moment resisting buildings with different levels of eccentricity in plan", Earthq. Struct., 5(3), 277-296. https://doi.org/10.12989/eas.2013.5.3.277
  15. Karimiyan, S., Kashan, A.H. and Karimiyan, M. (2014), "Progressive collapse vulnerability in 6-Story RC symmetric and asymmetric buildings under earthquake loads", Earthq. Struct., 6(5), 473-494. https://doi.org/10.12989/eas.2014.6.5.473
  16. Kelly, J.M. (1997), Seismic Isolation for Earthquake-Resistant Design, Springer, London.
  17. Kim, H.S., Kim, J. and An, D.W. (2009), "Development of integrated system for progressive collapse analysis of building structures considering dynamic effects", Adv. Eng., 40(1), 1-8.
  18. Kim, J., Choi, H. and Min, K.W. (2011a), "Use of rotational friction dampers to enhance seismic and progressive collapse resisting capacity of structures", Struct. Des. Tall Spec. Build., 20(4), 515-537. https://doi.org/10.1002/tal.563
  19. Kim, J., Park, J.H. and Lee, T.H. (2011b), "Sensitivity analysis of steel buildings subjected to column loss", Eng. Struct., 33(2), 421-432. https://doi.org/10.1016/j.engstruct.2010.10.025
  20. Komodromos, P. (2008), "Simulation of the earthquake-induced pounding of seismically isolated buildings", Comput. Struct., 86(7), 618-626. https://doi.org/10.1016/j.compstruc.2007.08.001
  21. Matsagar, V.A. and Jangid, R. (2003), "Seismic response of base-isolated structures during impact with adjacent structures", Eng. Struct., 25(10), 1311-1323. https://doi.org/10.1016/S0141-0296(03)00081-6
  22. Nath, R.J., Deb, S.K. and Dutta, A. (2013), "Base isolated RC building-performance evaluation and numerical model updating using recorded earthquake response", Earthq. Struct., 4(5), 471-487. https://doi.org/10.12989/eas.2013.4.5.471
  23. Providakis, C. (2008), "Pushover analysis of base-isolated steel-concrete composite structures under near-fault excitations", Soil Dyn. Earthq. Eng., 28(4), 293-304. https://doi.org/10.1016/j.soildyn.2007.06.012
  24. SAP2000 (2006), Static and Dynamic Finite Element Analysis of Structures, Computers and Structures INC, Berkeley, CA, USA.
  25. Tavakoli, H.R. and Alashti, A.R. (2013), "Evaluation of progressive collapse potential of multi-story moment resisting steel frame buildings under lateral loading", Sci. Iran., 20(1), 77-86.
  26. Tavakoli, H.R. and Kiakojouri, F. (2013), "Influence of sudden column loss on dynamic response of steel moment frames under blast loading", Int. J. Eng., 26(2), 197-205. https://doi.org/10.5829/idosi.ije.2013.26.02b.10
  27. Tavakoli, H.R. and Kiakojouri, F. (2014), "Progressive collapse of framed structures: Suggestions for robustness assessment", Sci. Iran., 21(2), 329-338.
  28. Tavakoli, H.R., Naghavi, F. and Goltabar, A.R. (2014), "Dynamic Responses of the Base-Fixed and Isolated Building Frames Under Far-and Near-Fault Earthquakes", Arab. J. Sci. Eng., 39(4), 2573-2585. https://doi.org/10.1007/s13369-013-0891-8
  29. Tsai, M.H. and Lin, B.H. (2008), "Investigation of progressive collapse resistance and inelastic response for an earthquake-resistant RC building subjected to column failure", Eng. Struct., 30(12), 3619-3628. https://doi.org/10.1016/j.engstruct.2008.05.031
  30. UFC (2005), Design of buildings to resist progressive collapse, Unified Facilities Criteria, Department of Defense, USA.
  31. Win, A.C. (2008), "Analysis and design of base isolation for multi-storeyed building", GMSARAN International Conference on Sustainable, November.

피인용 문헌

  1. On the progressive collapse resistant optimal seismic design of steel frames vol.60, pp.5, 2016, https://doi.org/10.12989/sem.2016.60.5.761
  2. Magnetorheological elastomer base isolator for earthquake response mitigation on building structures: modeling and second-order sliding mode control vol.11, pp.6, 2016, https://doi.org/10.12989/eas.2016.11.6.943
  3. Robustness analysis of steel structures with various lateral load resisting systems under the seismic progressive collapse vol.83, 2018, https://doi.org/10.1016/j.engfailanal.2017.10.003
  4. Effect of Earthquake characteristics on seismic progressive collapse potential in steel moment resisting frame vol.12, pp.5, 2017, https://doi.org/10.12989/eas.2017.12.5.529
  5. Seismic retrofitting by base-isolation of r.c. framed buildings exposed to different fire scenarios vol.13, pp.3, 2015, https://doi.org/10.12989/eas.2017.13.3.267
  6. The effect of base isolation and tuned mass dampers on the seismic response of RC high-rise buildings considering soil-structure interaction vol.17, pp.4, 2015, https://doi.org/10.12989/eas.2019.17.4.425
  7. Sensitivity analysis of the failure time of reinforcement concrete frame under postearthquake fire loading vol.21, pp.2, 2015, https://doi.org/10.1002/suco.201900165
  8. Seismic progressive collapse mitigation of buildings using cylindrical friction damper vol.20, pp.1, 2021, https://doi.org/10.12989/eas.2021.20.1.001
  9. Progressive collapse of regular- and irregular-plan concrete structures in an earthquake vol.174, pp.2, 2015, https://doi.org/10.1680/jstbu.18.00138
  10. Seismic poundings of multi-story buildings isolated by TFPB against moat walls vol.20, pp.3, 2021, https://doi.org/10.12989/eas.2021.20.3.295