DOI QR코드

DOI QR Code

Effect of MDOF structures' optimal dampers on seismic fragility of piping

  • Jung, Woo Young (Department of Civil Engineering, GangNeung-WonJu National University) ;
  • Ju, Bu Seog (Department of Civil Engineering, North Carolina State University)
  • 투고 : 2014.07.18
  • 심사 : 2015.04.15
  • 발행 : 2015.09.25

초록

Over the past few decades, seismic retrofitting of structural systems has been significantly improved by the adoption of various methods such as FRP composite wraps, base isolation systems, and passive/active damper control systems. In parallel with this trend, probabilistic risk assessment (PRA) for structural and nonstructural components has become necessary for risk mitigation and the achievement of reliable designs in performance-based earthquake engineering. The primary objective of the present study was to evaluate the effect on piping fragility at T-joints due to seismic retrofitting of structural systems with passive energy-dissipation devices (i.e., linear viscous dampers). Three mid-rise building types were considered: without any seismic retrofitting; with distributed damper systems; with optimal placement of dampers. The results showed that the probability of piping system failure was considerably reduced in a Multi Degree of Freedom (MDOF) building retrofitted with optimal passive damper systems at lower floor levels. This effect of damper systems on piping fragility became insignificant as the floor level increased.

키워드

과제정보

연구 과제 주관 기관 : National Research Foundation of Korea (NRF)

참고문헌

  1. ASME (2004), Rule for Construction of Nuclear Facility Components, ASME Boiler and Pressure Vessel Code, Section III, American Society of Mechanical Engineers.
  2. Bachman, R., Bonowitz, D., Caldwell, P.J., Filiatrault, A., Kennedy, R.P., McGavin, G. and Miranda, E. (2004), "Engineering demand parameters for nonstructural components", ATC-58 Project Task Report-ATC, Redwood City, California.
  3. Balasubramanian, S.R., Balaji Rao, K., Meher Prasad, A., Goswami, R. and Anoop, M.B. (2014), "A methodology for development of seismic fragility curves for URBM buildings", Earthq. Struct., 6(6), 611-625. https://doi.org/10.12989/eas.2014.6.6.611
  4. Dow, J. (2010), "Testing and analysis of iron and plastic T-joint in sprinkler systems", NEESR-GC: simulation of the seismic performance of nonstructural systems, http://nees.org/site/oldnees/filedir_2/REU2009_Dow_Paper.pdf.
  5. Gould, N.C. and Griffin, M.J. (2002), "The Value of Seismically Installing and Strengthening Non-Structural Equipment and Systems to Significantly Reduce Business Interruption Losses", Proceedings of Seminar on Seismic Design, Performance, and Retrofit of Nonstructural Components in Critical Facilities, ATC-29-2, Newport Beach, California
  6. Garcia, D.L. and Soong, T.T. (2002), "Efficiency of a simple approach to damper allocation in MDOF structures", J. Struct. Control, 9(1), 19-30. https://doi.org/10.1002/stc.3
  7. Gardoni, P. and Trejo, G. (2013), "Probabilistic seismic demand models and fragility estimates for reinforced concrete bridges with base isolation", Earthq. Struct., 4(5), 525-555
  8. Ju, B.S., Taninada, S.T. and Gupta, A. (2011), "Fragility analysis of threaded T-Joint connections in hospital piping systems", Proceedings of the ASME 2011 Pressure Vessel and Piping Division Conference, Baltimore, Maryland, USA.
  9. Ju, B.S. and Jung, W.Y. (2013), "Seismic fragility evaluation of multi-branch piping systems installed in critical low-rise buildings", Disaster Adv., 6(4),59-65.
  10. Ju, B.S., Jung, W.Y. and Ryu, Y.H. (2013), "Seismic fragility evaluation of piping system installed in critical structures", Struct. Eng. Mech., 46(3), 337-352. https://doi.org/10.12989/sem.2013.46.3.337
  11. Karantoni, F., Tsionis, G., Lyrantzaki, F. and Fardis, M.N. (2014), "Seismic fragility of regular masomy buildings for in-plane and out-of-plane failure", Earthq. Struct., 6(6), 689-713. https://doi.org/10.12989/eas.2014.6.6.689
  12. Kennedy, R.P., Cornell, C.A., Campbell, R.D., Kaplan, S. and Perla, H.F. (1980), "Probabilistic seismic safety study of an existing nuclear power plant", Nuclear Eng. Des., 59(2), 315-338. https://doi.org/10.1016/0029-5493(80)90203-4
  13. Kibboua, A., Naili, M., Benouar, D. and Kehila, F. (2011), "Analytical fragility curves for typical algerian reinforced concrete bridge piers", Struct. Eng. Mech., 39(3), 411-425. https://doi.org/10.12989/sem.2011.39.3.411
  14. Kircher, C.A. (2003), "It makes dollars and sense to improve nonstructural system performance", Proceedings of Seminar on Seismic Design, Performance, and Retrofit of Nonstructural Components in Critical Facilities, ATC-29-2, Newport Beach, California.
  15. Mehani, Y., Bechtoula H., Kibboua, A. and Naili, M. (2013), "Assessment of seismic fragility curves for existing RC buildings in Algiers after the 2003 Bouruerdes Earthquake", Struct. Eng. Mech., 46(6), 791-808. https://doi.org/10.12989/sem.2013.46.6.791
  16. NFPA-13, Standard for the installation of Sprinkler System, National Fire Protection Association, MA, 2007 Edition.
  17. OpenSees (2011), Open System for Earthquake Engineering Simulation. http://opensees.berkeley.edu/
  18. Park, J. and Choi, E. (2011), "Fragility analysis of track-on steel-plate-girder railway bridge in Korea", Eng. Struct., 33(3), 696-705 https://doi.org/10.1016/j.engstruct.2010.09.028
  19. Parulekar, Y.M., Reddy, G.R., Vaze, K.K., Ghosh, A.K., Kushwaha, B.S. and Ramesh Babu, R. (2009), "Seismic response evaluation of safety related nuclear structure with yielding dampers using linearization techniques", 20th International Conference on Structural Mechanics in Reactor Technology (SMiRT-20).
  20. Perotti, F., Domaneschi, M. and De Grandis, S. (2013), "The nuruerical computation of seismic fragility of base-isolated nuclear power plants buildings", Nuclear Eng. Des., 262, 189-200. https://doi.org/10.1016/j.nucengdes.2013.04.029
  21. Porter, K. and Bachman, R. (2006), "Developing fragility functions for building components for ATC-58", ATC-58 Nonstructural Products Team, http://www.sparisk.com/pubs/Porter-2006-deriving-fragility.pdf.
  22. Reitherman, R. and Sabol, T.A. (1995), "Northridge earthquake of January 17, 1994: reconnaissance report-nonstructural damage", Earthq. Spectra, EERI, 11, 453-514. https://doi.org/10.1193/1.1585856
  23. SMACNA (2003), Seismic Restraint Manual Guidelines for Mechanical Systems, Sheet Metal and Air Conditioning Contractors' National Association, Inc.
  24. UBC (1997), Uniform Building Code Vol. 2, International Conference of Building Officials.

피인용 문헌

  1. Seismic Fragility of Steel Piping System Based on Pipe Size, Coupling Type, and Wall Thickness pp.2093-6311, 2018, https://doi.org/10.1007/s13296-018-0100-4
  2. Bayesian-based seismic margin assessment approach: Application to research reactor vol.12, pp.6, 2017, https://doi.org/10.12989/eas.2017.12.6.653