DOI QR코드

DOI QR Code

Modal parametric changes in a steel bridge with retrofitting

  • 투고 : 2013.03.02
  • 심사 : 2015.01.21
  • 발행 : 2015.08.25

초록

This paper presents the status improvement of an old damaged deck type rural road steel truss bridge through the modal parametric study after partial retrofitting. The dynamic and static tests on bridge were carried out as in damaged state and after partial retrofitting. The dynamic testing on the steel bridge was carried out using accelerometers under similar environmental conditions with same speed of the moving vehicle. The comparison of the modal parameters i.e., frequency, mode shape mode shape curvature, modal strain energy, along with the deflection parameter are studied with respect to structural analytical model parameters. The status up gradation for the upper and downstream truss obtained was different due to differential level of damage in the bridge. Also after retrofitting the structural elemental behavior obtained was not same as desired. The damage level obtained through static tests carried out using total station indicated further retrofitting requirement.

키워드

참고문헌

  1. Alampalli, S., Fu, G. and Dillon, E.W. (1997), "Signal versus noise in damage detection by experimental modal analysis", J. Struct. Eng., 123(2), 237-245. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:2(237)
  2. Altunisik, A.C., Bayraktar, A., Sevm, B., Kartal, M.E. and Adanur, S. (2010), "Finite element model updating of an arch type steel laboratory bridge model using semi-rigid connection", Steel Compos. Struct., Int. J., 10(6), 543-563.
  3. ARTeMIS (2004), Ambient Response Testing and Modal Identification Software ARTeMIS Extractor Pro 3.43.; Structural Vibration Solution A/S Aalborg East, Denmark, www.svibs.com
  4. Avitabile, P. (2006), "101 ways to extract modal parameters - which one is for me?", Experimental Techniques, (September/October), Society for Experimental Mechanics.
  5. Broquet, C., Bailey, F.S., Fafard, M. and Bruhwiler, E. (2004), "Dynamic behavior of deck slab of concrete road bridges", J. Bridge Eng., 9(2), 137-146. https://doi.org/10.1061/(ASCE)1084-0702(2004)9:2(137)
  6. Cantieni, R., Krebs, W. and Heywood, R. (2000), "Dynamic interaction between vehicle and infrastructure experiment", EMPA Test Report, 153'031.
  7. Constructional Department (1906), Pocket Companion Containing Useful Information and Tables Pertaining to the Use of Steel; Dorman, Long & Co. Limited, Middlesbrough, England, UK.
  8. Doebling, S.W., Farrar, C.R., Prime, M.B. and Shevitz, D.W. (2003), "A review of structural health monitoring literature: 1996-2001", Research Rep. No. LA-13076-MS; Los Alamos National Laboratory, Los Alamos, NM, USA.
  9. Dong, Y. and Song, S. (2010), "Bridge structural health monitoring and deterioration detection - synthesis of knowledge and technology", AUTC #309036, University of Alaska Fairbanks, Fairbanks, AK, USA.
  10. Dutta, A. and Talukdar, S. (2004), "Damage detection in bridges using accurate modal parameters", Finite Elem. Anal. Des., 40(3), 287-304. https://doi.org/10.1016/S0168-874X(02)00227-5
  11. Fryba, L. and Pirner, M. (2001), "Load tests and modal analysis of bridges", Eng. Struct., 23, 102-109. https://doi.org/10.1016/S0141-0296(00)00026-2
  12. Gandomi, A.H., Sahab, M.G., Rahaei, A. and Gorji, M.S. (2008), "Development in Mode Shape-Based Structural Fault Identification Technique", World Appl. Sci. J., 5(1), 29-38.
  13. Graybeal, B.A., Phares, B.M., Rolander, D.D., Moore, M. and Washer, G. (2002), "Visual inspection of highway bridges", J. Nondestr. Eval., 21(3), 67-83. https://doi.org/10.1023/A:1022508121821
  14. Green, M.F., Cebon, D. and Cole, D.J. (1995), "Effects of vehicle suspension design on dynamics of highway bridges", J. Struct. Eng., 121(2), 272-282. https://doi.org/10.1061/(ASCE)0733-9445(1995)121:2(272)
  15. IRC: 6 (2000), Indian Standard code of Practice for Plain and Reinforced Concrete, (4th Rev.), Bureau of Indian Standards, New Delhi, India.
  16. Jauregui, D.V., White, K.R., Woodward, C.B. and Leitch, K.R. (2003), "Noncontact photogrammetric measurement of vertical bridge deflection", J. Bridge Eng., 8(4), 212-222. https://doi.org/10.1061/(ASCE)1084-0702(2003)8:4(212)
  17. Kim, C.-Y., Jung, D.-S., Kim, N.-S., Kwon, S.-D. and Feng, M.Q. (2003), "Effect of vehicle weight on natural frequencies of bridges measured from traffic-induced vibration", Earthq. Eng. Eng. Vib., 2(1), 109-115. https://doi.org/10.1007/BF02857543
  18. Le, T.H., Nakata, S., Yoshida, A., Kiriyama, S., Naito, S. and Tamura, Y. (2010), "Influence of vibration methods, structural components and excitation amplitude of modal parameters of low-rise building", Proceedings of 5th World Conference on Structural Control and Monitoring, Tokyo, Japan, July.
  19. Merkle, W. and Myers, J.J. (2004), "Use of the total station for serviceability monitoring of bridges with limited access in Missouri, USA", Proceedings of 16thWorld Conference on NDT, August-September, Montreal, Canada.
  20. Panigrahi, R., Gupta, A. and Bhalla, S. (2009), "Dismountable steel tensegrity grids as alternate roof structures", Steel Compos. Struct., Int. J., 9(3), 239-253 . https://doi.org/10.12989/scs.2009.9.3.239
  21. Parloo, E., Guillaume, P. and Overmeire, M.V. (2003), "Damage assessment using mode shape sensitivities", Mech. Syst. Sig. Process, 17(3), 499-518. https://doi.org/10.1006/mssp.2001.1429
  22. Paultre, P., Chaallal, O. and Proulx, J. (1992), "Bridge dynamics and dynamic amplification factors - A review of analytical and experimental findings", Can. J. Civ. Eng., 19(2), 260-278. https://doi.org/10.1139/l92-032
  23. Rashidi, M. and Gibson, P. (2011), "Proposal of a methodology for bridge condition assessment", Proceedings of Australasian Transport Research Forum, Adelaide, Australia, September.
  24. Salawu, O.S. and Williams, C. (1995), "Review of full-scale dynamic testing of bridge structures", Eng. Struct., 17(2), 113-121. https://doi.org/10.1016/0141-0296(95)92642-L
  25. SAP2000 (2006), Structural Analysis Program, 10.0.5; Computers and Structures, Inc. Berkeley, CA, USA.
  26. Shi, Z.Y., Law, S.S. and Zhang, L.M. (2000a), "Damage localization by directly using incomplete mode shapes", J. Eng. Mech., 126(6), 656-660. https://doi.org/10.1061/(ASCE)0733-9399(2000)126:6(656)
  27. Shi, Z.Y., Law, S.S. and Zhang, L.M. (2000b), "Structural damage detection from modal strain energy Change", J. Eng. Mech., 126(12), 1216-1223. https://doi.org/10.1061/(ASCE)0733-9399(2000)126:12(1216)
  28. Spyrakos, C.C., Raftoyiannis, I.G. and Ermopoulos, J.C. (2004), "Condition assessment and retrofit of a historic steel-truss railway bridge", J. Constr. Steel Res., 60(8), 1213-1225. https://doi.org/10.1016/j.jcsr.2003.11.004
  29. Subramanian, N. (2008), Design of Steel Structures, Oxford University Press, New Delhi, India.
  30. Wahab, M.M.A. and Roeck, G.D. (1999), "Damage detection in bridges using modal curvatures: application to a real damage scenario", J. Sound Vib., 226(2), 217-235. https://doi.org/10.1006/jsvi.1999.2295
  31. Wiberg, J. (2006), "Bridge monitoring to allow for reliable dynamic FE modeling- A Case study of new Arsra railway bridge", KTH/BKM/B-81-SE; Royal Institute of Technology, Stockholm, Sweden.
  32. Yuen, K.V. (2011), "Updating large models for mechanical systems using incomplete modal measurement", Mech. Sys. Sig. Process. DOI:10.1016/j.ymssp.2011.08.005.
  33. Yuen, K.V., Beck, J.L. and Katafygiotis, L.S. (2006), "Efficient model updating and monitoring methodology using incomplete modal data without mode matching", Struct. Control Health., 13(1), 91-107. https://doi.org/10.1002/stc.144

피인용 문헌

  1. Finite element model calibration of a steel railway bridge via ambient vibration test vol.27, pp.3, 2015, https://doi.org/10.12989/scs.2018.27.3.327