DOI QR코드

DOI QR Code

Effect of micro-silica on mechanical and durability properties of high volume fly ash recycled aggregate concretes (HVFA-RAC)

  • Shaikh, Faiz (Department of Civil Engineering, Curtin University) ;
  • Kerai, Sachin (Department of Civil Engineering, Curtin University) ;
  • Kerai, Shailesh (Department of Civil Engineering, Curtin University)
  • 투고 : 2016.02.04
  • 심사 : 2016.03.24
  • 발행 : 2015.12.25

초록

This paper presents the effect of different micro-silica (MS) contents of 5, 10 and 15 wt.% as partial replacement of cement on mechanical and durability properties of high volume fly ash - recycled aggregate concretes (HVFA-RAC) containing 50% class F fly ash (FA) and 35% recycled coarse aggregate (RCA) as partial replacement of cement and natural coarse aggregate (NCA), respectively. The measured mechanical and durability properties are compressive strength, indirect tensile strength, elastic modulus, drying shrinkage, water sorptivity and chloride permeability. The effects of different curing ages of 7, 28, 56 and 91 days on above properties are also considered in this study. The results show that the addition of MS up to 10% improved the early age (7 days) strength properties of HVFA-RAC, however, at later ages (e.g. 28-91 days) the above mechanical properties are improved for all MS contents. The 5% MS exhibited the best performance among all MS contents for all mechanical properties of HVFA-RAC. In the case of measured durability properties, mix results are obtained, where 10% and 5% MS exhibited the lowest sorptivity and drying shrinkage, respectively at all ages. However, in the case of chloride ion permeability a decreasing trend is observed with increase in MS contents and curing ages. Strong correlations of indirect tensile strength and modulus of elasticity with square root of compressive strength are also observed in HVFA-RAC. Nevertheless, it is established in this study that MS contributes to the sustainability of HVFA-RAC significantly by improving the mechanical and durability properties of concrete containing 50%less cement and 35% less natural coarse aggregates.

키워드

참고문헌

  1. Ahmed, S.F.U. (2012), "Properties of concrete containing construction and demolition wastes and fly ash", J. Mater. Civil Eng., 25(12), 1864-1870.
  2. Ahmed, S.F.U. (2014), "Properties of concrete containing recycled fine aggregate and fly ash", J. Solid Waste Tech. Manag., 40(1), 70-78. https://doi.org/10.5276/JSWTM.2014.70
  3. AS 1012.10 (1992), Determination of indirect tensile strength of concrete, Standards Australia.
  4. AS 1012.13 (1992), Determination of the Drying Shrinkage of Concrete for Samples Prepared in the Field or in the Laboratory, SAIGlobal.
  5. AS 1012.17 (1992), Determination of elastic modulus of concrete, Standards Australia.
  6. AS 1012.9 (1992), Determination of compressive strength of concrete, Standards Australia.
  7. AS 2758.1 (1998), Aggregates and rocks for engineering purposes, Part 1: concrete structures, Standards Australia, NSW, Australia.
  8. AS 3600 (2010), Australian standard for concrete structures, Standard Australia.
  9. ASTM C1202 (2012), Standard test method for electrical indication of concrete's ability to resist chloride ion penetration, American Society for Testing and Materials.
  10. ASTM C1585 (2013), Standard Test Method for Measurement of Rate of Absorption of Water by Hydraulic-Cement Concretes, American Society for Testing and Materials.
  11. Atis, C.D. (2003), "High-volume fly ash concrete with high strength and low drying shrinkage", J. Mater. Civil Eng., 15(2), 153-156. https://doi.org/10.1061/(ASCE)0899-1561(2003)15:2(153)
  12. Barbhuiya, S.A., Gbagbo, J.K., Russell, M.I. and Basheer, P.A.M. (2009), "Properties of fly ash concrete modified with hydrated lime and silica fume", Constr. Build. Mater., 23(10), 3233-3239. https://doi.org/10.1016/j.conbuildmat.2009.06.001
  13. Brooks, J.J. (1989), "Influence of mix proportions, plasticizers and superplasticizers on creep and drying shrinkage of concrete", Mag. Concrete Res., 41(148), 145-153. https://doi.org/10.1680/macr.1989.41.148.145
  14. Corinaldesi, V. and Moriconi, G. (2009), "Influence of mineral additions on the performance of 100% recycled aggregate concrete", Constr. Build. Mater., 23(8), 2869-2876. https://doi.org/10.1016/j.conbuildmat.2009.02.004
  15. Holt, E. and Leivo, M. (2004), "Cracking risks associated with early age shrinkage", Cement Concrete Compos., 26(5), 521-530. https://doi.org/10.1016/S0958-9465(03)00068-4
  16. Ioannides, A.M., Amarendranath, D., Richard, A.M., Jeff, C.M. and Kristina, M.W. (2006), Fineness of Densified Microsilica and Dispersion in Concrete Mixes, Research report, University of Cincinnati, USA.
  17. Kayali, O., Ahmed, M.S. and Khan, M.S.H. (2013), "Friedel's salt and hydrotalcite-layered double hydroxides and the protection against chloride induced corrosion", Civil Envir. Res., 5, 111-117.
  18. Kou, S.C. and Poon, C.S. (2013), "Long-term mechanical and durability properties of recycled aggregate concrete prepared with the incorporation of fly ash", Cement Concrete Compos., 37, 12-19. https://doi.org/10.1016/j.cemconcomp.2012.12.011
  19. Kou, S.C., Poon, C.S. and Chan, D. (2007), "Influence of fly ash as cement replacement on the properties of recycled aggregate concrete", J. Mater. Civil Eng., 19(9), 709-717. https://doi.org/10.1061/(ASCE)0899-1561(2007)19:9(709)
  20. Malathy, R. and Subramanian, K. (2007), "Drying shrinkage of cementitious composites with mineral admixtures", Indian J. Eng. Mater. Sci., 14(2), 146-150.
  21. Malhotra, V.M. (2002), "Sustainable development and concrete technology", Concrete Int., 24(7), 1-22.
  22. Naik, T.R., Singh, S.S. and Hossain, M.M. (1994), "Permeability of concrete containing large amounts of fly ash", Cement Concrete Res., 24(5), 913-922. https://doi.org/10.1016/0008-8846(94)90011-6
  23. Nochaiya, T., Wongkeo, W. and Chaipanich, A. (2010), "Utilization of fly ash with silica fume and properties of Portland cement-fly ash-silica fume concrete", Fuel, 89(3), 768-774. https://doi.org/10.1016/j.fuel.2009.10.003
  24. Papworth, F. and Grace, W. (1985), "Designing for concrete durability in marine environs", Proceedings of Concrete 85 Conference: 'The Performance of Concrete and Masonry Structures', Brisbane, Qld., Australia.
  25. Siddique, R. (2004), "Performance characteristics of high-volume Class F fly ash concrete", Cement Concrete Res., 34(3), 487-493. https://doi.org/10.1016/j.cemconres.2003.09.002
  26. Somna, R., Jaturapitakkul, C., Chalee, W. and Rattanachu, P. (2011), "Effect of the water to binder ratio and ground fly ash on properties of recycled aggregate concrete", J. Mater. Civil Eng., 24(1), 16-22. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000360
  27. Warner, R.F., Rangan, B.V., Hall, A.S. and Faulkes, K.A. (1999), Concrete Structures, Addison Wesley Longman, Australia Pty Ltd.

피인용 문헌

  1. Mechanical properties of recycled aggregate concrete produced with Portland Pozzolana Cement vol.4, pp.1, 2016, https://doi.org/10.12989/acc.2016.4.1.027
  2. Performance studies on concrete with recycled coarse aggregates vol.4, pp.4, 2016, https://doi.org/10.12989/acc.2016.4.4.263
  3. Effects of steel fibre and silica fume on impact behaviour of recycled aggregate concrete vol.6, pp.1, 2017, https://doi.org/10.1080/21650373.2016.1230900
  4. Experimental investigation for partial replacement of fine aggregates in concrete with sandstone vol.4, pp.4, 2016, https://doi.org/10.12989/acc.2016.4.4.243
  5. Using AP2RC & P1RB micro-silica gels to improve concrete strength and study of resulting contamination vol.4, pp.3, 2016, https://doi.org/10.12989/acc.2016.4.3.195
  6. Effect of silica fume on mechanical properties of concrete containing recycled asphalt pavement vol.62, pp.3, 2015, https://doi.org/10.12989/sem.2017.62.3.357
  7. Usage potential of recycled aggregates in mortar and concrete vol.5, pp.3, 2015, https://doi.org/10.12989/acc.2017.5.3.201
  8. Permeability and mechanical properties of binary and ternary cementitious mixtures vol.5, pp.5, 2015, https://doi.org/10.12989/acc.2017.5.5.423
  9. Sustainable use of mine waste and tailings with suitable admixture as aggregates in concrete pavements-A review vol.6, pp.3, 2015, https://doi.org/10.12989/acc.2018.6.3.221
  10. Modeling of ultimate value and kinetic of compressive strength and hydration heat of concrete made with different replacement rates of silica fume and w/b ratios vol.6, pp.3, 2015, https://doi.org/10.12989/acc.2018.6.3.297
  11. Behavior of repaired RAC beam-column joints using steel welded wire mesh jacketed with cement mortar vol.8, pp.2, 2019, https://doi.org/10.12989/acc.2019.8.2.091
  12. Performance of eco-friendly mortar mixes against aggressive environments vol.10, pp.3, 2020, https://doi.org/10.12989/acc.2020.10.3.237
  13. Mass Concrete Placement of the Offshore Wind Turbine Foundation: A Statistical Approach to Optimize the Use of Fly Ash and Silica Fume vol.15, pp.1, 2021, https://doi.org/10.1186/s40069-021-00491-8