DOI QR코드

DOI QR Code

최초의 평가시험 방법을 고려한 수격흡수기의 장치에 관한 연구

A Study on the Water Hammer Arrester Considering the Way of First Assessment Test

  • 투고 : 2014.12.29
  • 심사 : 2015.02.15
  • 발행 : 2015.02.28

초록

배관시스템의 불안정한 유동에 의해 생성되는 수격현상은 관내 압력의 과도한 변화, 진동 및 소음을 일으킬 수 있다. 이러한 수격현상은 관로, 펌프 및 밸브등의 시설물에 기계적인 사고를 유발시키는 원인이 되기도 한다. 한편, 국내에서는 수격현상으로 인한 피해를 최소화하기 위하여 수격흡수기를 제조 및 사용하여 왔으며, 그동안 별도의 기준이 없어 저가 위주로 생산 및 설치되어 왔다. 따라서, 본 연구에서는 수격흡수기 성능에 대한 최소 가이드라인을 제시하기 위하여, 하나의 배관으로 검증 가능한 시험방법, 수계소화설비에서 수격발생을 가정한 시험방법, 개방충격압과 차단충격압으로 구분한 흡수시험 방법, 배관을 분기한 시험시설 구성 방법 등의 다양한 방법들을 통하여 수격흡수기의 성능을 기준화 할 수 있는 방법등에 대하여 고안하였다. 그리고, 최종적으로는 U자형 배관과 시험용 추를 이용한 간단한 기계적 방식으로 수격흡수기의 수격압 흡수성능을 검증할 수 있는 실험 장치를 최초로 고안하여, 소방용 수격흡수기의 인정기준이 제정되었다.

Water hammering created by an unsteady flow in pipeline systems can cause excessive change in pressure, vibration, and noise. So, water hammer analysis is very important for limiting the damage caused to pipeline, pump and valve systems by operation conditions. On the other hand, water hammer arrester has been manufactured and used in order to minimize the damage caused by water hammering phenomenon in domestic, and it has been produced and installed as the low cost-oriented because of being no separate standard in the meanwhile. Therefore, our research team investigated about the standardization of water hammer arrester performance through the various methods, such as test methods for verification of one pipe, assuming the occurrence of water hammer in a water-based fire extinguishing system, separated for opening impact pressure and shut off impact pressure and for a branch pipe in order to make guideline for water hammer arrester performance. And finally, verified the performance of the water hammer pressure as the simple mechanical way using the U-shaped pipe and a test weight, so KFI standards for the water hammer arrester could be established.

키워드

참고문헌

  1. S. H. Sweeney and P. Griffith, "Water Hammer due to the Sudden Stopping of a Flashing Flow", Journal of Thermal Hydraulics, pp. 121-126 (1992).
  2. H. T. Han and J. M. Kim, "Effect of Water Hammer Arresters and Air Chambers in a Simple Water Piping System of Buildings", Journal of Air-Conditioning ad Refrigeration, pp. 13-20 (1997).
  3. K. Takumi, "A Fundamental Study of the Water Hammering in Hot Water Supply Pipes", Proceedings of the Society of Heating, Air-conditioning the Sanitary Engineers of Japan, pp. 865-868 (1992).
  4. SHASE, "The Society of Heating, Air-conditioning", The Sanitary Engineers of Japan, HASS 212 (1996).
  5. J. H. Ahn, "An Experimental Study on the Effect of Air Chamber and Water Hammer Arresters in a Water Piping System", Master Degree Thesis of Han-yang Univ. (2002).
  6. K. Y. Kim, "Water-hammer in the Transmission Pipeline with an Air Chamber", Transactions of the KSME B, Vol. 26, No. 2, pp. 177-183 (2002).
  7. K. Y. Kim and J. B. Kim, "Water-hammer in Transmission Pumping Station with Ball Valve", Proceedings of 2002 Spring Annual Meeting of the KSME, Vol. A, pp. 1697-702 (2004).
  8. J. H. Jo, Y. S. Lee, Y. H. Kim and H. R. Kim, "Structural Integrity Evaluation of Large Main Steam Piping by Water Hammmering", Transactions of the KSME A, Vol. 36, No. 9, pp. 1103-1108 (2012).
  9. W. G. An, T. H. Jung, Y. H. Park, H. Kim and D. K. Lee, "Water-Hammer Control Valve", Proceedings of the KFMA Annual Meeting, pp. 409-414 (2006).
  10. N. S. Park, S. S. Kim, M. S. Kang and J. W. Choi, "Study on a Multi-pipe Water Hammer Phenomenon by Using CFD of Rapid Valve Closing, Korean Society of Water and Wastewater, Vol. 27, No. 4, pp. 479-487 (2013). https://doi.org/10.11001/jksww.2013.27.4.479
  11. Y. W. Kim, H. S. Kim, Y. C. Bae, H. Lee and Y. S. Lee, "Excess Vibration Phenomena and Soundness of Drain Piping in Moisture Separator Reheat Exchanger", Proceeding of Spring Conference of the Korea Society for Noise and Vibration Engineering, pp. 393-398 (2001).
  12. S. M. Jo, "Experimental and Analysis of a Transient Vibration Response Caused by Water Hammer in a pipeline System", Master degree thesis of Bu-San Univ. (2005).
  13. L. J. Xuan, F. Mao and J. Z. W, "Water Hammer Prediction and Control: the Green's Function Method", Chinese Society of Theoretical and Applied Mechanics, Vol. 28, No. 2, pp. 266-273 (2012).
  14. J. K. Choi, S. J. Lee, M. H. Lee and J. Y. Sung, "Experimental Study on the Water Hammer Absorption Effects of Water Hammer Arrester in the Water Supply Piping System", Journal of the Korean Society of Marine Engineering, Vol. 241, pp. 674-682 (2001).
  15. H. T. Han and J. M. Kim, "An Experimental Study on the Effect of Water Hammer Arresters and Air Chambers in a Simple Water Piping System", The Society of Air-conditional and Refrigerating Engineers of Korea, Vol. 8, No. 1, pp. 37-44 (1996).