설비공학논문집 (Korean Journal of Air-Conditioning and Refrigeration Engineering)

  • 제27권1호
  • /
  • Pages.1-7
  • /
  • 2015
  • /
  • 1229-6422(pISSN)
  • /
  • 2465-7611(eISSN)
대한설비공학회 (The Society of Air-Conditioning and Refrigerating Engineers of Korea)
권호 표지
DOI QR코드

DOI QR Code

탄소나노튜브 입자의 길이와 혼합비율이 나노유체의 비등 열전달에 미치는 영향에 대한 연구

A Study on the Influence of Boiling Heat Transfer of Nanofluid with Particle Length and Mixing Ratio of Carbon Nanotube

  • 박성식 (제주대학교 에너지공학과) ;
  • 김우중 (제주대학교 에너지공학과) ;
  • 김종윤 (서정대학교 소방안전관리과) ;
  • 전용한 (상지영서대학교 소방안전과) ;
  • 김남진 (제주대학교 에너지공학과)
  • Park, Sung-Seek (Department of Nuclear and Energy Engineering, Jeju National University) ;
  • Kim, Woo Joong (Department of Nuclear and Energy Engineering, Jeju National University) ;
  • Kim, Jong Yoon (Department of Fire Safety Management, Seojeong College) ;
  • Jeon, Yong-Han (Department of Protection and Safety, Sang Ji Young seo College) ;
  • Kim, Nam-Jin (Department of Nuclear and Energy Engineering, Jeju National University)
  • 투고 : 2014.08.08
  • 심사 : 2014.10.06
  • 발행 : 2015.01.10
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

A boiling heat transfer system is used in a variety of industrial processes and applications, such as refrigeration, power generation, heat exchangers, cooling of high-power electronics components, and cooling of nuclear reactors. The critical heat flux (CHF) is the thermal limit during a boiling heat transfer phase change; at the CHF point, the heat transfer is maximized, followed by a drastic degradation beyond the CHF point. Therefore, Enhancement of CHF is essential for economy and safety of heat transfer system. In this study, the CHF and heat transfer coefficient under the pool-boiling state were tested using multi-wall carbon nanotubes (MWCNTs) CM-95 and CM-100. These two types of multi-wall carbon nanotubes have different sizes but the same thermal conductivity. The results showed that the highest CHF increased for both MWCNTs CM-95 and CM-100 at the volume fraction of 0.001%, and that the CHF-increase ratio for MWCNT CM-100 nanofluid with long particles was higher than that for MWCNT CM-95 nanofluid with short particles. Also, at the volume fraction of 0.001%, the MWCNT CM-100 nanofluid indicated a 5.5% higher CHF-increase ratio as well as an approximately 23.87% higher heat-transfer coefficient increase ratio compared with the MWCNT CM-95 nanofluid.

키워드

참고문헌

  1. Das, S. K., Choi, S. U., Yu, W., and Pradeep, T., 2008, Nanofluids : Science and Technology, John Wiley and Sons.
  2. You, S. M., Kim, J. H., and Kim, K. H., 2003, Effect of nanoparticles on critical heat flux of water in pool boiling heat transfer, Applied Physics Letters, Vol. 83, No. 16, pp. 3374-3376. https://doi.org/10.1063/1.1619206
  3. Liu, Z. H. and Liao, L., 2008, Sorption and agglutination phenomenon of nanofluids on a plain heating surface during pool boiling, International Journal of Heat and Mass Transfer, Vol. 51, No. 9-10, pp. 2593-2602. https://doi.org/10.1016/j.ijheatmasstransfer.2006.11.050
  4. Suriyawong, A. and Wongwises, S., 2010, Nucleate pool boiling heat transfer characteristics of $TiO_2$-water nanofluids at very low concentrations, Experimental Thermal and Fluid Science, Vol. 34, No. 8, pp. 992-999. https://doi.org/10.1016/j.expthermflusci.2010.03.002
  5. Ajayan, P. M., 1999, Nanotubes from carbon, Chemical Reviews, Vol. 99, pp. 1787-1799. https://doi.org/10.1021/cr970102g
  6. Dresselhaus, M. S., Dresselhaus, G., and Avouris, P., 2001, Carbon nanotubes : Synthesis, Structure, Properties and Applications, Springer Science and Business Media, New York.
  7. Park, K. J. and Jung, D. S., 2007, Enhancement of nucleate boiling heat transfer using carbon nanotubes, International Journal of Heat and Mass Transfer, Vol. 50, No. 21-22, pp. 4499-4502. https://doi.org/10.1016/j.ijheatmasstransfer.2007.03.012
  8. Liu, Z. H., Yang, X. F., and Xiong, J. G., 2010, Boiling characteristics of carbon nanotube suspensions under sub-atmospheric pressures, International Journal of Thermal Sciences, Vol. 49, No. 7, pp. 1156-1164. https://doi.org/10.1016/j.ijthermalsci.2010.01.023
  9. Barber, J., Brutin, D., and Tadrist, L., 2011, A review on boiling heat transfer enhancement with nanofluids, Nanoscale Research Letters, Vol. 6, pp. 1-16.
  10. Zuber, N., 1958, On stability of boiling heat transfer, ASME transactions, Vol. 80, pp. 711-714.
  11. Kline, S. J. and McClintock, F. A., 1953, Describing uncertainties in single sample experiments, Mechanical Engineer, Vol. 75, pp. 3-8.
  12. Park, K. J., Jung, D. S., and Shim, S. E., 2009, Nucleate boiling heat transfer in aqueous solutions with carbon nanotubes up to critical heat fluxes, International Journal of Multiphase Flow, Vol. 35, No. 6, pp. 525-532. https://doi.org/10.1016/j.ijmultiphaseflow.2009.02.015
  13. Kim, H. D., DeWitt, G., McKrell, T., Buongiorno, J., and Hu, L. W., 2009, On the quenching of steel and zircaloy spheres in water-based nanofluids with alumina, silica and diamond nanoparicles, International Journal of Multiphase Flow, Vol. 35, No. 5, pp. 427-438. https://doi.org/10.1016/j.ijmultiphaseflow.2009.02.004
  14. Chen, R., Lu, M. C., Srinivasan, V., Wang, Z., Cho, H. H., and Majumdar, A., 2009, Nanowires for enhanced boiling heat transfer, Nano Letters, Vol. 9, No. 2, pp. 548-553. https://doi.org/10.1021/nl8026857
  15. Ahn, H. S., Kim, H. D., Jo, H. J., Kang, S. H., and Kim, M. H., 2009, Experimental investigation on the pool boiling critical heat flux of water-based alumina and titania nanofluids on a flat plate heater, Transactions of the Korean Society of Mechanical Engineers B, Vol. 33, No. 10, pp. 729-736. https://doi.org/10.3795/KSME-B.2009.33.10.729
  16. Cieslinski, J. T., 2002, Nucleate pool boiling on porous metallic coatings, Experimental Thermal and Fluid Science, Vol. 25, No. 7, pp. 557-564. https://doi.org/10.1016/S0894-1777(01)00105-4

피인용 문헌

  1. A Study on Influence of Flow Boiling Heat Transfer on Fouling Phenomenon in Nanofluids vol.28, pp.3, 2016, https://doi.org/10.6110/KJACR.2016.28.3.095
  2. Recent Progress in Air-Conditioning and Refrigeration Research : A Review of Papers Published in the Korean Journal of Air-Conditioning and Refrigeration Engineering in 2015 vol.28, pp.6, 2016, https://doi.org/10.6110/KJACR.2016.28.6.256