DOI QR코드

DOI QR Code

고체산화물 연료전지 스택 열화 방지를 위한 전해질 기술

Bi-layer Electrolyte for Preventing Solid Oxide Fuel Cell Stack Degradation

  • 박미영 (창원대학교 신소재공학부) ;
  • 배홍열 (포항산업과학연구원 연료전지연구단) ;
  • 임형태 (창원대학교 신소재공학부)
  • Park, Mi Young (School of Materials Science and Engineering, Changwon National University) ;
  • Bae, Hongyeul (Fuel Cell Project, Research Institute of Industrial Science and Technology (RIST)) ;
  • Lim, Hyung-Tae (School of Materials Science and Engineering, Changwon National University)
  • 투고 : 2014.06.18
  • 심사 : 2014.07.07
  • 발행 : 2014.07.31

초록

The stability of a solid oxide fuel cell (SOFC) stack is strongly dependent on the magnitude and profile of the internal chemical potential of the solid electrolyte. If the internal partial pressure is too high, the electrolyte can be delaminated from the electrodes. The formation of high internal pressure is attributed to a negative cell voltage, and this phenomenon can occur in a bad cell (with higher resistance) in a stack. This fact implies that the internal chemical potential plays an important role in determining the lifetime of a stack. In the present work, we fabricate planar type anode-supported cells ($25cm^2$) with a bi-layer electrolyte (with locally increased electronic conduction at the anode side) to prevent high internal pressure, and we test the fabricated cells under a negative voltage condition. The results indicate that the addition of electronic conduction in the electrolyte can effectively depress internal pressure and improve the cell stability.

키워드

참고문헌

  1. J. B. Olson and E. D. Sexton, "Charging VRLA Batteries in Cycling Applications," Annu. Battery Conf. Appl. Adv., 14th IEEE, pp. 155-59, 1999.
  2. E. D. Sexton and J. B. Olson, "Characterization of Plates from a Spiral Wound HEV Battery," Annu. Battery Conf. Appl. Adv., 14th IEEE, pp. 25-29, 1999.
  3. T. T. Sack, J. C. Tice, and J. Reynolds, "Segmented Battery Charger for High Energy 28V Lithium Ion Battery," Annu. Battery Conf. Appl. Adv., 16th IEEE, pp. 157-59, 2001.
  4. D. Berndt and U. Teutsch, "Float Charging of Valve-regulated Lead-acid Batteries : A Balancing Act between Secondary Reactions," J. Electrochem. Soc., 143 [3] 790-98 (1996). https://doi.org/10.1149/1.1836539
  5. S. Atlung and B. Zachau-Christiansen, "Failure Mode of the Negative Plate in Recombinant Lead/acid Batteries," J. Power Sources., 52 [2] 201-09 (1994). https://doi.org/10.1016/0378-7753(94)01963-0
  6. P. T. Krein, S. West, and C. Papenfuss, "Equalization Requirements for Series VRLA Batteries," Annu. Battery Conf. Appl. Adv., 16th IEEE, pp. 125-30, 2001.
  7. A. V. Virkar, "A Model for Solid Oxide Fuel Cell (SOFC) Stack Degradation," J. Power Sources., 172 [2] 713-24 (2007). https://doi.org/10.1016/j.jpowsour.2007.05.076
  8. H.-T. Lim and A. V. Virkar, "A Study of Solid Oxide Fuel Cell Stack Failure by Inducing Abnormal Behavior in a Single Cell Test," J. Power Sources., 185 [2] 790-800 (2008). https://doi.org/10.1016/j.jpowsour.2008.07.051
  9. H.-T. Lim and A. V. Virkar, "Electrochemical Degradation of Fuel Cell : Effect of Electrolyte Composition," ECS Trans., 25 [2] 447-56 (2009).
  10. H.-T. Lim, S. C. Hwang, M. G. Jung, H. W. Park, M. Y. Park, S.-S. Lee, and Y.-G. Jung, "Degradation Mechanism of Anode-supported Solid Oxide Fuel Cell In Planar-cell Channel-type Setup," Fuel Cells., 13 [5] 712-19 (2013).
  11. M. Y. Park, Y. G. Jung, and H.-T. Lim, "Delamination-resistant Bi-layer Electrolyte for Anode-supported Solid Oxide Fuel Cells," Solid State Ionics., 262 438-43 (2014). https://doi.org/10.1016/j.ssi.2014.02.013

피인용 문헌

  1. Degradation study of yttria-doped barium cerate (BCY) electrolyte in protonic ceramic fuel cells under various operating conditions vol.123, pp.1436, 2015, https://doi.org/10.2109/jcersj2.123.257