DOI QR코드

DOI QR Code

Assessment of whipping and springing on a large container vessel

  • Published : 2014.06.30

Abstract

Wave induced vibrations increase the fatigue and extreme loading, but this is normally neglected in design. The industry view on this is changing. Wave induced vibrations are often divided into springing and whipping, and their relative contribution to fatigue and extreme loading varies depending on ship design. When it comes to displacement vessels, the contribution from whipping on fatigue and extreme loading is particularly high for certain container vessels. A large modern design container vessel with high bow flare angle and high service speed has been considered. The container vessel was equipped with a hull monitoring system from a recognized supplier of HMON systems. The vessel has been operating between Asia and Europe for a few years and valuable data has been collected. Also model tests have been carried out of this vessel to investigate fatigue and extreme loading, but model tests are often limited to head seas. For the full scale measurements, the correlation between stress data and wind data has been investigated. The wave and vibration damage are shown versus heading and Beaufort strength to indicate general trends. The wind data has also been compared to North Atlantic design environment. Even though it has been shown that the encountered wind data has been much less severe than in North Atlantic, the extreme loading defined by IACS URS11 is significantly exceeded when whipping is included. If whipping may contribute to collapse, then proper seamanship may be useful in order to limit the extreme loading. The vibration damage is also observed to be high from head to beam seas, and even present in stern seas, but fatigue damage in general is low on this East Asia to Europe trade.

Keywords

References

  1. ASTM, 1997. Standard practices for cycle counting in fatigue analysis, Annual Book of ASTM Standards. Vol 03.01, designation E1049-85. USA: ASTM.
  2. DNV, 2010. Fatigue Assessment of Ship structures . DNV Classification Note No. 30.7. Oslo: DNV.
  3. Heggelund, S.E., Storhaug, G. and Choi, B.K., 2011. Full scale measurements of fatigue and extreme loading including whipping on an 8,600TEU post panamax container vessel in Asia to Europe trade. OMAE, ASME, Rotterdam, Holland, 19-24 June 2011.
  4. IACS, 2010. Longitudinal strength standard, Unified Requirements concerning strength of ships S11, Rev. 7. 2010. London: IACS Limited.
  5. IMO, 2012. International shipping facts and figures-information resources on trade, safety, security, environment. London: IMO.
  6. Moe, E., Holtsmark, G. and Storhaug, G., 2005. Full scale measurements of the wave induced hull girder vibrations of an ore carrier trading in the North Atlantic. RINA, International Conference, Design and Operation of bulk carriers, London, UK, 18-19 October 2005, pp.57-85.
  7. Storhaug, G., 2012. The effect of heading on springing and whipping induced fatigue damage measured on container vessels. The 6th International Conference on Hydroelasticity in Marine Technology. Tokyo, Japan, 19-21 September 2012, pp.299-310.
  8. Storhaug, G., Choi, B.K., Moan, T. and Hermundstad, O.A., 2010. Consequence of whipping and springing on fatigue for a 8,600TEU container vessel in different trades based on model tests. PRADS2010. Rio de Janeiro, Brazil, 19-24 September 2010, pp.1210-1223.
  9. Storhaug, G., Pettersen, T., Oma, N. and Blomberg, B., 2012. The effect of wave induced vibrations on fatigue loading and the safety margin against collapse on tow LNG vessels. The 6th International Conference on Hydroelasticity in Marine Technology, Tokyo, Japan, 19-21 September 2012, pp.355-366.
  10. Storhaug, G., Vidic-Perunovic, J., Rudinger, F., Holtsmark, G., Helmers, J.B. and Gu, X., 2003. Springing/whipping response of a large ocean going vessel - A comparison between numerical simulations and full scale measurements. 3rd international conference on Hydroelasticity in Marine Technology. Oxford, UK, 15-17 September 2003, pp.117-131.