Abstract
Even though to discard the waste FRP (Fiber-Reinforced Plastic) is urgent and problematic, the way to do it has not been efficient. In our project team the FRP have been splitted into some layers which have different physical properties; mat and roving layers. Among those, the roving layer woven like a basket by bundles of glass fibers has been cut into reusable fibers called 'F-fiber'. F-fiber is 1 mm or 3 mm in width and 3 cm in length. It is used in fiber-reinforced concrete (FRC) with 0.5%, 0.7%, 1.0%, or 1.5% of volume ratio. Produced FRC was tested in compressive, tensile, and bending stress in contrast to the without-fiber (standard) concrete and 0.1% polypropylene reinforced concrete (PP-FRC). The tensile and bending stresses are more or less those of PP-FRC. The compressive stress, however, is similar (with 3 mm F-fiber) to or lower (with 1 mm F-fiber) than that of standard concrete. Conclusively the usage of the waste FRC in concrete is advised to be limited to the one where the compressive stress is not much critical.
폐 FRP의 처리는 매우 급박하나 뚜렷한 생산성 있는 방법이 많지 않다. 본 연구진은 FRP의 층간 구성에 초점을 맞춰 층으로 분리하였으며, 각 층의 구성 성분에 따라 물성이 다름을 확인한 바 있다. 그 중 유리섬유 다발이 바구니 조직으로 틀을 이루고 있는 로빙층에서 유리섬유("F섬유")를 제작하였다. 그 크기를 폭 1 mm와 3 mm로 달리하고 길이는 3 cm로 잘라 부피비로 0.5%, 0.7%, 1.0%, 1.5%를 포함하도록 섬유강화 콘크리트(fiber reinforced concrete, FRC)를 제작하였다. 압축강도, 인장강도, 휨강도를 비교하기 위해 강화재를 포함하지 않은 것과 합성수지(polypropylene, PP)를 0.1% 포함하는 비교 샘플도 제작하였다. 실험결과 인장강도와 휨강도는 PP를 포함하는 것과 유사하거나 버금가는 강도를 보인 반면, 압축강도는 강화재를 넣지 않은 것과 유사하거나(3 mm 폭), 약 20% 정도 감소하였다(1 mm 폭). 이 결과를 바탕으로 폐 FRP 소재를 건축자재로 쓸 경우에는 압축강도가 큰 영향을 주지 않는 부분에 사용할 것을 권한다.