Earthquakes and Structures

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Yield penetration in seismically loaded anchorages: effects on member deformation capacity

  • Tastani, S.P. (Department of Civil Engineering, Democritus University of Thrace (DUTh)) ;
  • Pantazopoulou, S.J. (Department of Civil & Environmental Engineering, University of Cyprus)
  • Received : 2013.01.05
  • Accepted : 2013.07.15
  • Published : 2013.11.25
⟨ Previous Next ⟩

Abstract

Development of flexural yielding and large rotation ductilities in the plastic hinge zones of frame members is synonymous with the spread of bar reinforcement yielding into the supporting anchorage. Yield penetration where it occurs, destroys interfacial bond between bar and concrete and reduces the strain development capacity of the reinforcement. This affects the plastic rotation capacity of the member by increasing the contribution of bar pullout. A side effect is increased strains in the compression zone within the plastic hinge region, which may be critical in displacement-based detailing procedures that are linked to concrete strains (e.g. in structural walls). To quantify the effects of yield penetration from first principles, closed form solutions of the field equations of bond over the anchorage are derived, considering bond plastification, cover debonding after bar yielding and spread of inelasticity in the anchorage. Strain development capacity is shown to be a totally different entity from stress development capacity and, in the framework of performance based design, bar slip and the length of debonding are calculated as functions of the bar strain at the loaded-end, to be used in calculations of pullout rotation at monolithic member connections. Analytical results are explored parametrically to lead to design charts for practical use of the paper's findings but also to identify the implications of the phenomena studied on the detailing requirements in the plastic hinge regions of flexural members including post-earthquake retrofits.

Keywords

References

  1. ACI 318 (2011), Building code requirements for structural concrete (ACI 318-11) and commentary, ACI, Farmington Hills, Michigan, USA.
  2. ACI 408-2R12 (2012), Report on bond of steel reinforcing bars under cyclic loads, ACI, Farmington Hills, Michigan, USA.
  3. ASCE/SEI 41 (2007), "Seismic rehabilitation of existing buildings", American Society of Civil Engineers, Reston, VA.
  4. Bonacci, J. and Marquez, J. (1994), "Tests of yielding anchorages under monotonic loadings", J. Struct. Eng.- ASCE, 120 (3), 987-997. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:3(987)
  5. Bonacci, J. and Ustuner, T. (1992), Discussion of "Analytical modeling of bonded bars under cyclic loads (Jan. 1991, Vol. 117, No.1)", J. Struct. Eng.- ASCE, 118 (9), 2626-2628. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:9(2626)
  6. Bonacci, J.F. (1994), "Bar yield penetration in monotonically loaded anchorages", J. Struct. Eng.- ASCE, 120 (3), 965-986. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:3(965)
  7. Cox, J.V. and Herrmann, L. (1992), "Confinement stress dependent bond behavior, Part II: A two degree of freedom plasticity model", Proceedings, International Conference "Bond in Concrete", CEB, Riga, Latvia, Vol. 3, pp. 11-11:11-20.
  8. Eurocode 2 (EC2) (2004), BS EN 1992-1-1: Design of concrete structures-general rules and rules for buildings, European Committee for Standardization (CEN), Brussels.
  9. Eurocode 8 (EC8-I) (2004), Design of structures for earthquake resistance - Part 1: General rules seismic actions and rules for buildings, European Committee for Standardization (CEN), Brussels.
  10. Eurocode 8 (EC8-III) (2005), EN1998-3-2005: Design of structures for earthquake resistance - Part 3: Assessment and retrofitting of buildings, European Committee for Standardization (CEN), Brussels.
  11. Goodnight, J., Kowalsky, M., Nau, J.M. and Feng, Y.H. (2012), "Effect of load history on the behavior of circular bridge columns", presented in the ACI341 Session: "Forming a Framework for Performance based Seismic Design of Concrete Bridges", ACI Fall Convention, Toronto, Canada.
  12. Hannewald P., Beyer K. and Mihaylov B. (2012), "Performance based assessment of existing bridges with wall type piers and structural deficiencies", presented in the ACI341 Session: "Forming a Framework for Performance based Seismic Design of Concrete Bridges", ACI Fall Convention, Toronto, Canada.
  13. International Federation for Structural Concrete (fib CEB-FIP) (2010), fib Model Code 2010 - Final draft, Volume 1, fib Bulletin No. 65, Lausanne, Switzerland.
  14. International Federation for Structural Concrete (fib) (2003), fib Bulletin No. 24: Seismic assessment and retrofit of reinforced concrete buildings, State-of-art report (312 pages, ISBN 978-2-88394-064-2), Lausanne, Switzerland.
  15. Priestley, M.J.N., Seible, F. and Calvi, G.M. (1996), Seismic design and retrofit of bridges, John Wiley & Sons, Inc.
  16. Soroushian, P., Obasaki, K. and Marikunte, S. (1991), "Analytical modeling of bonded bars under cyclic loads", J. Struct. Eng.- ASCE, 117(1), 48-60. https://doi.org/10.1061/(ASCE)0733-9445(1991)117:1(48)
  17. Syntzirma, D., Thermou, G., Pantazopoulou, S. and Halkitis, G. (2006), "Experimental research of R.C. elements with substandard details", Procs. 1st Europ. Conf. on Earthquake Engineering and Seismology, 3−8 September, Geneva, Switzerland, pap. #: 819.
  18. Syntzirma, D., Pantazopoulou, S. and Aschheim, M. (2010), "Load-history effects on deformation capacity of flexural members limited by bar buckling", J. Struct. Eng.- ASCE, 136(1), 1-11. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000088
  19. Tastani, S.P. and Pantazopoulou, S.J. (2007), "Detailing procedures for seismic rehabilitation of reinforced concrete members with fiber reinforced polymers", Eng. Struct., 30(2), 450-461.
  20. Tastani, S.P. and Pantazopoulou, S.J. (2010), "Direct tension pullout bond test: experimental results", J. Struct. Eng.- ASCE, 136(6), 731-743. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000159
  21. Tastani, S.P. and Pantazopoulou, S.J. (2013). "Reinforcement-concrete bond: state determination along the development length", J. Struct. Eng. - ASCE, 139(9), 1567-1581. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000725
  22. Tastani, S.P., Thermou, G.E. and Pantazopoulou, S.J. (2012a), "Deformation analysis of reinforced concrete columns after repair with FRP jacketing", Procs. 15th World Conference on Earthquake Engineering, September 26-28, Lisbon, Portugal.
  23. Tastani, S.P., Thermou, G.E. and Pantazopoulou, S.J. (2012b), "Yield penetration in bar anchorages and the effect on rotation capacity", Vol. Compiled by the Institut fur Werkstofe im Bauwesen, Universitat Stuttgart, in honor of Prof. R. Eligehausen.
  24. Thermou, G. and Pantazopoulou, S. (2009), "Fiber reinforced polymer retrofitting of substandard r.c. prismatic members", J. Comp. Constr. - ASCE, 13(6), 535-546. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000057
  25. Thermou, G., Tastani, S. and Pantazopoulou, J. (2010), "The effect of previous damage on the effectiveness of FRP-jacketing for seismic repairs of RC structural members", Procs. 10th Int. Symposium on Fiber Reinforced Polymer Reinforcement for Reinforced Concrete Structures (SP275-54), October 15, Tampa, Florida, USA.
  26. Timosidis, D. and Pantazopoulou, S.J. (2009), "Anchorage of longitudinal column reinforcement in bridge monolithic connections", J. Struct. Eng.- ASCE, 135(4), 344-355. https://doi.org/10.1061/(ASCE)0733-9445(2009)135:4(344)
  27. Wallace, J. (1995). "Seismic design of r.c. structural walls. Part I: new code format", J. Struct. Eng.- ASCE, 121(1), 75-87.
  28. Wallace, J.W. and Moehle, J. (2012), "Behavior and design of structural walls - lessons from recent laboratory tests and earthquakes", Procs. International Symposium on Engineering - Lessons learned from the 2011 great east Japan earthquake, March 1-4, Tokyo, Japan.
  29. Wallace, J.W., Massone, L.M., Bonelli, P., Dragovich, J., Lagos, R., Luders, C. and Moehle, J. (2012), "Damage and implications for seismic design of RC structural wall buildings", Earthq. Spectra, 28(1), 281-299. https://doi.org/10.1193/1.4000047
  30. Wallace, J.W. and Moehle, J.P. (1992), "Ductility and detailing requirements of bearing wall buildings", J. Struct. Eng.- ASCE, 118(6), 1625-1644. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:6(1625)
  31. Wallace, J.W. and Orakcal K. (2002), "ACI 318-99 provisions for seismic design of structural walls", ACI Struct. J., 99(4), 499-508.

Cited by

  1. Implications of yield penetration on confinement requirements of r.c. wall elements vol.9, pp.4, 2015, https://doi.org/10.12989/eas.2015.9.4.831
  2. Mechanics Model for Simulating RC Hinges under Reversed Cyclic Loading vol.9, pp.12, 2016, https://doi.org/10.3390/ma9040305
  3. Efficiency of Externally Bonded L-Shaped FRP Laminates in Strengthening Reinforced-Concrete Interior Beam-Column Joints vol.20, pp.3, 2016, https://doi.org/10.1061/(ASCE)CC.1943-5614.0000622
  4. Seismic behavior of non-seismically designed reinforced concrete frame structure vol.11, pp.2, 2016, https://doi.org/10.12989/eas.2016.11.2.281
  5. Effect of yield penetration on column plastic hinge length vol.156, 2018, https://doi.org/10.1016/j.engstruct.2017.11.003
  6. Earthquake resistance of structural walls confined by conventional tie hoops and steel fiber reinforced concrete vol.7, pp.5, 2014, https://doi.org/10.12989/eas.2014.7.5.843
  7. Effect of structural features and loading parameters on bond in reinforced concrete under repeated load vol.18, pp.6, 2017, https://doi.org/10.1002/suco.201600170
  8. Evaluation of load–deformation behavior of reinforced concrete shear walls with continuous or lap-spliced bars in plastic hinge zone pp.2048-4011, 2018, https://doi.org/10.1177/1369433218798717
  9. Experimental Study on Strain Penetration Effects in Fixed-End Rotation of RC Beam-Column Connections with High-Strength Reinforcement vol.2018, pp.None, 2013, https://doi.org/10.1155/2018/9127167
  10. Experimental evaluation of strength assessment procedures for R.C. elements with sub-standard details vol.224, pp.None, 2020, https://doi.org/10.1016/j.engstruct.2020.111191
  11. On the Modeling and Analysis of Brittle Failure in Existing R/C Structures Due to Seismic Loads vol.12, pp.3, 2022, https://doi.org/10.3390/app12031602