DOI QR코드

DOI QR Code

Bending characteristics of corroded reinforced concrete beam under repeated loading

  • Fang, Congqi (Department of Civil Engineering, Shanghai Jiaotong University) ;
  • Yang, Shuai (Department of Civil Engineering, Shanghai Jiaotong University) ;
  • Zhang, Zhang (Shanghai Third Harbour Engineering Science & Technology Research Institute CO., LTD.)
  • Received : 2012.09.02
  • Accepted : 2013.08.31
  • Published : 2013.09.25

Abstract

Bending behaviors of corroded reinforced concrete (RC) beams under repeated loading were investigated experimentally. A total of twenty test specimens, including four non-corrosion and sixteen corrosion reinforced concrete beams, were prepared and tested. A numerical model for flexural and cracking behaviors of the beam under repeated loading was also developed. Effects of steel corrosion on reinforced concrete beams regarding cracking, mid-span deflection, stiffness and bearing capacity of corroded beams were studied. The impact of corrosion on bond strength as the key factor was investigated to develop the computational model of flexural capacity. It was shown from the experimental results that the bond strength between reinforcement and concrete had increased for specimen of low corrosion levels, while this effect was changed when the corrosion level was higher. It was indicated that the bearing capacity of corrosion beam increased even at a corrosion level of about 5%.

Keywords

References

  1. Al-Hammoud, R., Soudki, K. and Topper, T.H. (2010), "Bond analysis of corroded reinforced concrete beams under monotonic and fatigue loads", Cem. Concr. Compos., 32, 194-203. https://doi.org/10.1016/j.cemconcomp.2009.12.001
  2. Almusallam, A.A. (2001), "Effect of degree of corrosion on the properties of reinforcing steel bars", Constr. Build. Mater., 15, 361-368.
  3. Almusallam A.A. Al-Gahtani A.S., Aziz A.R. and Rasheeduzzafart (1996), "Effect of reinforcement corrosion on bond strength", Constr. Build. Mater., 10(2), 123-129. https://doi.org/10.1016/0950-0618(95)00077-1
  4. Al-sulaimani, G.J., Kaleemullah, M., Basunbul, I.A. and Rasheeduzzafar. (1990), "Influence of corrosion and cracking on bond behaviour and strength of reinforced concrete member", ACI Struct. J., 87(2), 220-231.
  5. Amleh, L. and Mirza, S. (1999), "Corrosion influence on bond between steel and concrete", ACI Struct. J., 96(3), 415-423.
  6. Auyeung, Y.B., Balaguru, P. and Chung, L. (2000), "Bond behavior of corroded reinforcement bars", ACI Mater. J., 97(2), 214-220.
  7. Azad, A.K., Ahmad, S. and Al-Gohi, B.H.A. (2010), "Flexural strength of corroded reinforced concrete beams", Mag. Concr. Res., 62(6), 405-414. https://doi.org/10.1680/macr.2010.62.6.405
  8. Azad, A.K., Ahmad, S. and Azher, S.A. (2007), "Residual strength of corrosion-damaged reinforced concrete beams", ACI Mater. J., 104(1), 40-47.
  9. Baldwin, M.I. and Clark, L.A. (1995), "The assessment of reinforcing bars with inadequate anchorage", Mag. Concr. Res., 47(171), 95-102. https://doi.org/10.1680/macr.1995.47.171.95
  10. Ballim, Y. and Reid, J.C. (2003), "Reinforcement corrosion and the deflection of RC beams-an experimental critique of current test methods", Cem. Concr. Compos., 25, 625-632. https://doi.org/10.1016/S0958-9465(02)00076-8
  11. Balogh, J., Fragiacomo, M., Gutkowski, R.M. and Fast, R.S. (2008), "Influence of repeated and sustained loading on the performance of layered wood- concrete composite beams", J. Struct. Eng., 134(3), 430-439. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:3(430)
  12. Berra, M., Castellani, A., Coronelli, D., Zanni, S. and Zhang, G. (2003), "Steel-concrete bond deterioration due to corrosion: finite-element analysis for different confinement levels", Mag. Concr. Res., 55(3), 237-247. https://doi.org/10.1680/macr.2003.55.3.237
  13. Bhargava, K., Ghosh, A.K., Mori, Y. and Ramanujam, S. (2007), "Corrosion induced bond strength degradation in reinforced concrete-Analytical and empirical models", Nucl. Eng. Des., 237, 1140-1157. https://doi.org/10.1016/j.nucengdes.2007.01.010
  14. Cabrera, J.G. (1996), "Deterioration of concrete due to reinforcement steel corrosion", Cem. Concr. Compos., 18(1), 47-59. https://doi.org/10.1016/0958-9465(95)00043-7
  15. Castel, A., François, R. and Arliguie, G. (1998), "Mechanical behaviour of corroded reinforced concrete beams-Part 1: Experimental study of corroded beams", Mater. Struct., 33, 539-544.
  16. Chen, W.F. and Saleeb, A.F. (1982), Constitutive Equations for Engineering Materials: Elasticity and Modelling v. 1, John Wiley & Sons Inc, London.
  17. Coronelli, D. and Gambarova, P. (2004), "Structural assessment of corroded reinforced concrete beams: Modeling guidelines", J. Struct. Eng., 130(8), 1214-1224. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:8(1214)
  18. Dekoster, M., Buyle-Bodin, F., Maurel, O. and Delmas, Y. (2003), "Modeling of the flexural behaviour of RC beams subjected to localized and uniform corrosion", Eng. Struct., 25, 1333-1341. https://doi.org/10.1016/S0141-0296(03)00108-1
  19. Fang, C., Lundgren, K., Chen, L. and Zhu, C. (2004), "Effect of corrosion on bond in reinforced concrete", Cem. Concr. Res., 34(11), 2159-2167. https://doi.org/10.1016/j.cemconres.2004.04.006
  20. Fang, C., Gylltoft, K., Lundgren, K. and Plos, M. (2006), "Effect of corrosion on bond in reinforced concrete under cyclic loading", Cem. Concr. Res., 36, 548-555. https://doi.org/10.1016/j.cemconres.2005.11.019
  21. Guo, Z.H. and Shi, X.D. (2003), Reinforced Concrete Theory and Analyse, Tsinghua University Press, Beijing.
  22. Jason, L., Huerta, A., Pijaudier-Cabot, G. and Ghavamian, S. (2006), "An elastic plastic damage formulation for concrete: Application to elementary tests and comparison with an isotropic damage model", Comput. Meth. Appl. Mech. Eng., 195, 7077-7092. https://doi.org/10.1016/j.cma.2005.04.017
  23. Jin, W.L. and Zhao, Y.X. (2001), "Effect of corrosion on bond behavior and bending strength of reinforced concrete beams", J Zhejiang Univ-Sc., 2(3), 298-308. https://doi.org/10.1631/jzus.2001.0298
  24. Mangat, P.S. and Elgarf, M.S. (1999), "Flexural strength of concrete beams with corroding reinforcement", ACI Struct. J., 96(1), 149-159.
  25. Stewart, M.G. (2009), "Mechanical behaviour of pitting corrosion of flexural and shear reinforcement and its effect on structural reliability of corroding RC beams", Struct. Saf., 31, 19-30. https://doi.org/10.1016/j.strusafe.2007.12.001
  26. Suzuki, H. and Chen, W. (1983), "Elastic-plastic fracture analysis of concrete structures", Comput. Struct., 16(6), 697-705. https://doi.org/10.1016/0045-7949(83)90061-5
  27. Stanish, K., Hooton, R.D. and Pantazopoulou, S.J. (1999), "Corrosion effects on bond strength in reinforced concrete", ACI Struct. J., 96(6), 915-922.
  28. Tracy, R.G. and Klein, R. (1994), "Corrosion-induced slab liftoff", Concr. Int., 16(3), 35-38.

Cited by

  1. Performance deterioration of corroded RC beams and reinforcing bars under repeated loading vol.96, 2015, https://doi.org/10.1016/j.conbuildmat.2015.08.066
  2. Analysis of the adhesive damage for different patch shapes in bonded composite repair of corroded aluminum plate vol.59, pp.1, 2016, https://doi.org/10.12989/sem.2016.59.1.123
  3. Effects of Stress Ratio and Banded Microstructure on Fatigue Crack Growth Behavior of HRB400 Steel Bar vol.30, pp.3, 2018, https://doi.org/10.1061/(ASCE)MT.1943-5533.0002193
  4. Symptom-based reliability analyses and performance assessment of corroded reinforced concrete structures vol.53, pp.6, 2015, https://doi.org/10.12989/sem.2015.53.6.1183
  5. Corrosion Cracking Process of Reinforced Concrete under the Coupled Effects of Chloride and Fatigue Loading vol.25, pp.9, 2021, https://doi.org/10.1007/s12205-021-0768-4