DOI QR코드

DOI QR Code

Evaluation of Impact Factor in Composite Cable-Stayed Bridges under Reliability-based Live Load Model

신뢰도 기반 활하중모델에 의한 강합성 사장교의 충격계수 평가

  • Received : 2012.12.03
  • Accepted : 2013.07.23
  • Published : 2013.08.27

Abstract

AASHTO LRFD and Korean Bridge Design Code (Limit State Design) specify to consider Truck and Lane load simultaneously determined from reliability-based live load model, and impact shall be applied to the truck load while it shall not be applied to the lane load. In this paper, vehicle-bridge interaction analysis under moving truck and lane loads were performed to estimate impact factor of the cables and girders for the selected multi-cable-stayed composite bridges with 230m, 400m and 540m main span. A 6-d.o.f. vehicle was used for truck load and a series of single-axle vehicles was applied to simulate equivalent lane load. The effect of damping ratio on the impact factor was estimated and then the essential parameters to impact factor, i.e., road surface roughness and vehicle speed were considered. The road surface roughness was randomly generated based on ISO 8608 and it was applied to the truck load only in the vehicle-bridge interaction analysis. The impact factors evaluated from dynamic interaction analysis were also compared with those by the influence line method that is currently used in design practice to estimate impact factor in cable-stayed bridge.

AASHTO LRFD 및 도로교한계상태설계기준에서는 신뢰도 기반 활하중 모델로부터 결정된 트럭하중과 차로하중을 동시에 재하하도록 하고 있으며, 트럭하중은 충격계수를 고려하되 차로하중은 충격계수를 적용하지 않도록 규정하고 있다. 본 연구에서는 중앙경간 230m, 400m 및 540m의 멀티케이블 강합성 사장교를 대상으로 트럭하중과 차로하중이 동시에 주행하는 경우에 대해 차량-교량 상호작용 해석을 수행하고 케이블과 보강거더의 충격계수를 평가하였다. 트럭하중은 6-자유도의 차량 모델을 사용하였으며, 차로하중은 일련의 1축 차량이 연행해서 주행하는 것으로 모사하였다. 교량의 감쇠비가 충격계수에 미치는 영향을 평가하였으며, 충격에 영향을 미치는 주요 인자인 노면조도와 주행속도를 해석변수로 고려하였다. 노면조도는 ISO 8608 규정에 근거하여 랜덤 생성하였으며, 차량-교량 상호작용해석 시 노면조도는 트럭하중에만 적용하였다. 한편, 사장교의 충격계수 평가를 위해 실무에서 사용되고 있는 영향선 기법에 의한 충격계수를 동적 상호작용 해석에 의한 결과와 비교하였다.

Keywords

References

  1. 한국도로교통협회 (2012) 도로교설계기준(한계상태설계법), 국토해양부 제정. Korea Road and Transportation Association (2012) Korea Highway Bridge Design code(Limit State Design), sponsored by Ministry of land, Transport and Maritime Affairs.
  2. American Association of State Highway and Transportation Officials (2007) AASHTO LRFD Bridge Design Specifications, 4th Ed., Washington D.C.
  3. Wang, T.L. and Huang, D.Z. (1992) Cable-Stayed Bridge Vibration due to Road Surface Roughness, Journal of Structural Engineering, ASCE, Vol. 118, No. 5, pp.1354-1374. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:5(1354)
  4. American Association of State Highway and Transportation Officials (2002) Standard Specifications for Highway Bridges, 17th Ed., Washington D.C.
  5. ISO 8608 (1995) Mechanical vibration-Road surface profiles- Reporting of measured data.
  6. Karoumi, R. (1999) Response of Cable-Stayed and Suspension Bridges to Moving Vehicles-Analysis methods and practical modeling techniques, Royal Institute of Technology Department of Structural Engineering, Doctoral Thesis.
  7. Guo, W.H. and Xu, Y.L. (2001) Fully Computerized Approach to Study Cable-Stayed Bridge-Vehicle Interaction, Journal of Sound and Vibration, Vol. 248, No. 4, pp.745-761. https://doi.org/10.1006/jsvi.2001.3828
  8. Calcada, R., Cunha, A., and Delgado, R. (2005) Analysis of Traffic-Induced Vibrations in a Cable- Stayed Bridge, Part I: Experimental Assessment, Journal of Bridge Engineering, ASCE, Vol. 10, No. 4, pp.370-385. https://doi.org/10.1061/(ASCE)1084-0702(2005)10:4(370)
  9. Calçada, R., Cunha, A., and Delgado, R. (2005) Analysis of Traffic-Induced Vibrations in a Cable- Stayed Bridge, Part II: Numerical Modeling and Stochastic Simulation, Journal of Bridge Engineering, ASCE, Vol. 10, No. 4, pp.386-397. https://doi.org/10.1061/(ASCE)1084-0702(2005)10:4(386)
  10. 장승필, 김철영, 김남식 (1990) 이동하중에 의한 사장교의 동적거동, 한국강구조학회논문집, 한국강구조학회, 제2권, 제1호, pp.93-102. Chang, S.P., Kim, C.Y., and Kim, N.S. (1990) Dynamic Behavior of a Cable-stayed Bridge subjected to Moving Load, Journal of Korean Society of Steel Construction, KSSC, Vol. 2, No. 1, pp.93-102 (in Korean).
  11. 박용명, 박재봉, 김동현, 최병호 (2011) 차량 이동하중 해석에 의한 강합성 사장교 케이블의 충격계수 평가, 한국강구조학회논문집, 한국강구조학회, 제23권, 제2호, pp.199-210. Park, Y.M., Park, J.B., Kim, D.H., and Choi, B.H. (2011) Evaluation of Cable Impact Factor by Moving Vehicle Load Analysis in Steel Composite Cable-Stayed Bridges, Journal of Korean Society of Steel Construction, KSSC, Vol. 23, No. 2, pp.199-210 (in Korean).
  12. 대한토목학회 (2010) 도로교설계기준, 국토해양부 제정. Korea Road and Transportation Association (2012) Korea Highway Bridge Design code, sponsored by Ministry of land, Transport and Maritime Affairs.
  13. 황의승 (1991) 교량의 충격하중 계수에 대한 연구, 한국강구조학회논문집, 한국강구조학회, 제3권, 제4호, pp.205-212. Hwang, E.S. (1991) Dynamic Load Factors in Bridges, Journal of Korean Society of Steel Construction, KSSC, Vol. 3, No. 4, pp.205-212 (in Korean).
  14. 정태주 (2011) 4축 단일차량에 의한 도로교의 동적응답에 관한 연구, 한국강구조학회논문집, 한국강구조학회, 제23권, 제3호, pp.397-404. Chung, T.J. (2011) A Study on the Dynamic Response of Highway Bridges by 4-Axles Single Truck, Journal of Korean Society of Steel Construction, KSSC, Vol. 23, No. 3, pp.397-404 (in Korean).
  15. Dodds, C.J. and Robson, J.D. (1973) The Description of Road Surface Roughness, Journal of Sound and Vibration, Vol. 38, No. 2, pp. 175-183.
  16. Hikosaka, H., Yoshimura, T., and Uchitani, T. (1979) Non-Stationary Random Response And Impact Coefficient of Simple Girder Highway Bridge Under A Series of Moving Vehicle Loads, 土木學會論文報告集, Vol. 290, pp.31-41. (in Japanese)
  17. Ernst, M.J. (1965) The E-Modulus of Cables Considering the Deflection, Der Bauigenieur, Vol. 40, No. 2, pp.52-55.
  18. Yang, F. and Fonder, G.A. (1996) An Iterative Solution Method for Dynamic Response of Bridge- Vehicles Systems, Earthquake Engineering and Structural Dynamics, Vol. 25, pp.195-215. https://doi.org/10.1002/(SICI)1096-9845(199602)25:2<195::AID-EQE547>3.0.CO;2-R
  19. 대한토목학회 (2006) 케이블강교량설계지침. Korean Society of Civil Engineers (2006) Design Guidelines for Cable-supported Steel Bridges.
  20. Chopra, A.K. (1995) Dynamics of Structures, Theory and Applications to Earthquake Engineering, 2nd. Ed., Prentice Hall.

Cited by

  1. 일련의 주행 차량에 의한 현수교의 충격계수 평가 vol.26, pp.5, 2013, https://doi.org/10.7781/kjoss.2014.26.5.485
  2. 실 통행열차에 의한 강박스거더 교량의 동적응답에 대한 확률론적 분석 vol.28, pp.3, 2013, https://doi.org/10.7781/kjoss.2016.28.3.163
  3. 강박스거더 철도교량의 동적거동 및 진동저감 방안 분석 vol.29, pp.6, 2013, https://doi.org/10.7781/kjoss.2017.29.6.487