DOI QR코드

DOI QR Code

CCT Analysis of Power System Connected to DFIG Wind Turbine

DFIG 풍력터빈이 연계된 전력계통의 CCT 영향분석

  • Seo, Gyu-Seok (Dept. of Electrical Engineering, Koje College) ;
  • Park, Ji-Ho (Dept. of Electrical Engineering, Koje College)
  • 서규석 (거제대학교 선박전기과) ;
  • 박지호 (거제대학교 선박전기과)
  • Received : 2013.02.18
  • Accepted : 2013.05.09
  • Published : 2013.05.31

Abstract

Wind generation systems are very different in nature from conventional generation systems. Therefore it is necessary to research dynamic characteristics of wind generation systems connected to a power system. The stability analysis of wind turbine generator is an important issue in the operation of the power system. The result of angular stability of the power system that consists of only synchronous generators is different from that of the power system including wind turbine generators. This is due to the fact that generators connected to wind turbines are generally induction generators. The angular stability assessing synchronization of generators is determined by its corresponding critical clearing time(CCT). Wind turbine models for the analysis of power system are varied and difficult to use, but now these are standardized into four types. In this paper, the analysis of the CCT of the power system connected to wind farm considering the location and capacity is performed by using DFIG(Doubly-Fed induction Generator) wind turbine built-in type3 model in PSS/E-32.

풍력발전시스템은 기존의 발전시스템과 매우 다르다. 그러므로 전력계통에 풍력시스템을 연계하기 위해서는 동적특성에 대한 연구가 필요하다. 풍력발전기의 안정도해석은 전력계통의 운영에 있어서 중요 쟁점이다. 기존의 동기발전기만으로 구성된 전력계통의 위상각 안정도는 풍력발전기가 포함되면 그 결과가 달라진다. 즉, 풍력터빈에 연계된 발전기는 대부분 비동기인 유도발전기이기 때문이다. 위상각의 동기화 여부로 판별하는 위상각 안정도는 임계고장제거시간(CCT)을 계산하여 평가한다. 계통해석용 풍력터빈의 모델은 다양하여 그 해석에 어려움이 있으나 지금은 크게 4가지 타입으로 표준화가 되어있다. 본 논문에서는 PSS/E-32에서 제공하는 풍력터빈의 3번째 표준모델인 DFIG(Doubly-Fed induction Generator)모델을 이용하여 풍력단지가 연계된 전력계통의 CCT를 풍력단지의 위치와 용량을 고려하여 분석한다.

Keywords

References

  1. Clemens Jauch, Poul Sorensen, Ian Norheim, Carsten Rasmussen "Simulation of the Impact of Wind Power on the Transient Fault Behavior of the Nordic Power System", Electric Power System Research 77 (2007) 135-144 DOI: http://dx.doi.org/10.1016/j.epsr.2006.02.006
  2. Sun T., Chen Z., Blaabjerg F. "Voltage Recovery of Grid-connected Wind Turbines after a Short-circuit Fault", Annual Conference of the IEEE Industrial Electronics Society, Virginia, USA, 2003 DOI: http://dx.doi.org/10.1109/IECON.2003.1280678
  3. Salman S. K., Teo A. L. I. "Investigation in to the Estimation of the Critical Clearing Time of a Grid Connected Wind Power Based Embedded Generator", Proceedings of the IEEE/PES transmission and distribution Conference and exhibition 2002, Asis Pacific Pucific, Vol. 11 2002, p975-980 DOI: http://dx.doi.org/10.1109/TDC.2002.1177609
  4. "PSS/E-32 Program Application Guide Vol. 1", Shaw Power Technologies Inc.