콘크리트학회논문집 (Journal of the Korea Concrete Institute)

  • 제25권2호
  • /
  • Pages.241-250
  • /
  • 2013
  • /
  • 1229-5515(pISSN)
  • /
  • 2234-2842(eISSN)
한국콘크리트학회 (Korea Concrete Institute)
권호 표지
DOI QR코드

DOI QR Code

순환골재와 플라이애쉬가 콘크리트 유동성 및 강도에 미치는 영향

Effect of Fly Ash on Rheology and Strength of Recycled Aggregate Concrete

  • 김규헌 (울산과학기술대학교 도시환경공학부) ;
  • 신명수 (울산과학기술대학교 도시환경공학부) ;
  • 공영식 (울산대학교 건설환경공학부) ;
  • 차수원 (울산대학교 건설환경공학부)
  • Kim, Kyu-Hun (School of Urban and Environmental Engineering, Ulsan National Institute of Science and Technology) ;
  • Shin, Myoung-Su (School of Urban and Environmental Engineering, Ulsan National Institute of Science and Technology) ;
  • Kong, Young-Sik (Dept. of Civil and Environmental Engineering, University of Ulsan) ;
  • Cha, Soo-Won (Dept. of Civil and Environmental Engineering, University of Ulsan)
  • 투고 : 2013.01.02
  • 심사 : 2013.01.17
  • 발행 : 2013.04.30
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

건설폐기물의 증가에 따라 지속가능한 기술로 폐콘크리트의 재사용에 대한 연구가 활발해지고 있다. 따라서 이 연구에서는 순환골재를 활용한 콘크리트의 유동성, 압축강도 및 쪼갬인장강도에 대한 특성을 조사하였다. 실험변수로는 콘크리트의 설계강도, 순환골재의 함수상태, 총 굵은골재량에 대한 순환굵은골재의 치환율, 플라이애쉬 사용 유무 등을 사용하여 11가지 경우에 대한 시험체 제작과 실험을 계획하였다. 굳지 않은 순환골재 콘크리트의 유동성을 평가하기 위해 ICAR 레오미터를 이용하여 유동곡선실험을 실시하였고, 슬럼프 실험 결과와 비교하였다. 순환골재와 플라이애쉬의 사용은 슬럼프와 유동곡선 모두 콘크리트의 유동성을 향상시키는 결과를 얻었다. 순환골재의 치환율이 증가할수록 항복응력이 감소하였으며, 이를 통해서 슬럼프와 항복응력은 대략적으로 반비례 관계에 있는 것을 확인하였다. 또한 플라이애쉬를 함유한 순환골재 콘크리트는 플라이애쉬를 함유하지 않은 경우에 비해 상당히 낮은 소성점도를 보였다. 순환골재를 사용한 콘크리트의 압축강도, 쪼갬인장강도는 치환율이 증가할수록 감소하는 경향을 보였고, 순환골재를 30% 이상 치환한 경우는 이러한 경향이 보다 뚜렷하게 보였다. 순환골재를 30% 치환하고, 플라이애쉬를 사용한 콘크리트는 장기강도 증진에 도움이 되는 것으로 판단된다.

As the amount of construction wastes increase, reuse of demolished concrete is being considered in research areas. Reflecting these interests, this experiment was performed to clarify concrete's mechanical property and workability using recycled aggregate as a coarse aggregate. Eleven cases of concrete specimens were produced by changing the rates of replacement of coarse recycled aggregate, replacement of fly ash, design strength, and moisture state of coarse aggregate. Compressive and tensile split strength tests were taken to study the mechanical properties of hardened concrete. To verify flowability of fresh concrete, a slump test and a flow curve test using ICAR Rheometer were performed. It was found that using recycled aggregate and fly ash leads good workability by testing slump and flow curve. The yield stress of fresh concrete decreased with increase of recycled aggregate substitution rate. Through the test, it was confirmed that there is inversely proportional relationship between the slump and yield stress roughly. Recycled aggregate concrete containing fly ash has considerably lower plasticity viscosity than not containing fly ash. Strength test results showed that recycled aggregate tended to decrease compressive and tensile strength of concrete, when recycled aggregate was used as a coarse aggregate. Using over 30% recycled aggregate caused significant decreases in compressive and tensile strength. Replacing 30% cement with fly ash was helpful to improve the long-term strength of concrete.

키워드

참고문헌

  1. www.cwms.or.kr, Condition of Waste Disposal, Accessed 2012.
  2. Korean of Land, Infrastructure and Transport, Research for Supply Stabilization and Quality Improvement of Aggregate, 2010, pp. 33-39.
  3. Korean Ministry of Environment, Report for Statistics of Investigation of Recycling, 2005, pp. 14-15.
  4. Korea Concrete Institute, Concrete Specification and Commentary, Kimoondang Publishing Company, Seoul, 2009, 762 pp.
  5. Kou, S. C. and Poon, C. S., "Properties of Self-Compacting Concrete Prepared with Coarse and Fine Recycled Concrete Aggregates," Cement and Concrete Composites, Vol. 31, Issue 9, 2009, pp. 622-627. (doi: http://dx.doi.org/10.1016/j.cemconcomp.2009.06.005)
  6. Poon, C. S. and Kou, S. C., "Properties of Concrete Prepared with PVA-Impregnated Recycled Concrete Aggregate," Cement and Concrete Composites, Vol. 32, Issue 8, 2010, pp. 649-654. (doi: http://dx.doi.org/10.1016/j.cemconcomp.2010.05.003)
  7. Nassar, Poz-Ud-Din and Soroushian, P., "Strength andDurability of Recycled Aggregate Concrete Containing MilledGlass as Partial Replacement for Cement," Constructionand Building Materials, Vol. 29, 2012, pp. 386-377. (doi: http://dx.doi.org/10.1016/j.conbuildmat.2011.10.061)
  8. Yoon, S. J., Seo, S. Y., Lee, W. J., and Kim, D. Y., "Concrete Physical Properties with Substitution Ratio of Recycled Coarse Aggregate and Recycled Fine Aggregate," Journal of the Korean Concrete Institute Fall Research Conference, Vol. 18, No. 1, 2006, pp. 161-164. https://doi.org/10.4334/JKCI.2006.18.2.161
  9. Han, C. G. and Park, Y. K., "Analysis of Fundamental Properties of Concrete for Rising up Fly Ash Contents," Korean Recycled Construction Resource Institute, Vol. 6, No. 2, 2011, pp. 89-96.
  10. Wallevik, J. E., "Relationship between the Bingham Parameters and Slump," Cement and Concrete Composites, Vol. 36, Issue 7, 2006, pp. 1214-1221. (doi: http://dx.doi. org/10.1016/j.cemconres.2006.03.001)
  11. M. Barra de Oliveira and E. Vazquez, "Influence of Retained Moisture in Aggregates from Recycling on the Properties of New Hardened Concrete," Waste Management, Vol. 16 No. 1-3, 1996, pp. 113-117. (doi: http://dx.doi.org/10.1016/S0956-053X(96)00033-5)
  12. Poon, C. S., Shui, Z. H., Lam, L., Fok, H., and Kou, S.C., "Influence of Moisture States of Natural and RecycledAggregates on the Slump and Compressive Strength ofConcrete," Cement and Concrete Composites, Vol. 34, Issue1, 2003, pp. 31-36. (doi: http://dx.doi.org/10.1016/S0008-8846(03)00186-8)
  13. Berndt, M. L., "Properties of Sustainable Concrete Containing Fly Ash, Slag and Recycled Concrete Aggregate," Construction and Building Materials, Vol. 23, Issue 7, 2009, pp. 2606-2613. (doi:http://dx.doi.org/10.1016/j.conbuildmat.2009.02.011)
  14. Xiao, J., Li, J., and Zhang, C., "Mechanical Properties ofRecycled Aggregate Concrete under Uniaxial Loading,"Cement and Concrete Composites, Vol. 35, 2005, pp. 1187-1194. (doi: http://dx.doi.org/10.1016/j.cemconres.2004.09.020)
  15. Kwan, W. H., Ramli, M., Kam, K. J., and Sulieman, M.Z., "Influence of the Amount of Recycled Coarse Aggregatein Concrete Design and Durability Properties," Constructionand Building Materials, Vol. 26, Issue 1, 2012, pp.565-573. (doi: http://dx.doi.org/10.1016/j.conbuildmat.2011.06.059)
  16. Sim, J. S., Park, C. W., Moon, I. W., and Lee, H. C., "Fundamental Performance Evaluation of Recycled Aggregate Concrete with Varying Amount of Fly Ash and Recycled Fine Aggregate," Journal of the Korea Concrete Institute, Vol. 17, No. 5, 2005, pp. 793-801. https://doi.org/10.4334/JKCI.2005.17.5.793
  17. Chung, H. S., Yang, K. H., and Kim, H. H., "The Influence of the Quality and the Replacement Level of Recycled Aggregate on the Mechanical Properties of Concrete," Journal of the Architectural Institute of Korea, Vol. 22, No. 6, 2006, pp. 71-78.
  18. Kong, D., Lei, T., Zheng, J., Ma, C., Jiang, J., and Jiang, J., "Effect and Mechanism of Surface-Coating Pozzolanic Materials around Aggregate on Properties and ITZ Microstructure of Recycled Aggregate Concrete," Construction and Building Materials, Vol. 24, Issue 5, 2010, pp. 701-708. (doi: http://dx.doi.org/10.1016/j.conbuildmat.2009.10.038)
  19. Sofiane Amziane, Shiara F. Ferraris, Eric Koehler, "Feasibility of Using a Concrete Mixing Truck as a Rheometer," NISTIR 7333, US, 2006, 43 pp.
  20. Weiss, J., Bentz, D., Schindler, A. P. E., Lura, P., "Internal Curing," Structure Magazine, January 2012, pp. 10-14.

피인용 문헌

  1. The Strength and Length Change Properties of Recycled Aggregate Concrete(RAC) by Compressive Strength Levels vol.3, pp.4, 2015, https://doi.org/10.14190/JRCR.2015.3.4.307
  2. Applicability Evaluation of Tailing Admixture as Grout Material vol.26, pp.2, 2016, https://doi.org/10.7474/TUS.2016.26.2.110
  3. Effect of Recycled Coarse Aggregate on Compressive Strength and Mechanical Properties of Concrete vol.28, pp.1, 2016, https://doi.org/10.4334/JKCI.2016.28.1.105
  4. Experimental Study on Mechanical Properties and Deformation Behavior of Concrete with Recycled Aggregates and Steel Fiber vol.28, pp.3, 2016, https://doi.org/10.4334/JKCI.2016.28.3.357