금형 및 공정변수에 따른 층상복합재료의 압출성형 특성에 관한 연구

A study on the extrusion forming characteristics of construction materials with die and process parameters

  • 고병두 (유한대학교 금형설계과) ;
  • 이하성 (유한대학교 금형설계과)
  • Ko, Byung-Du (Department of Tool & Mould Design, Yuhan University) ;
  • Lee, Ha-Sung (Department of Tool & Mould Design, Yuhan University)
  • 투고 : 2012.11.09
  • 심사 : 2013.01.25
  • 발행 : 2013.03.29

초록

This paper presents the plastic inhomogeneous deformation behavior of bimetal composite rods during the axisymmetric and steady-state extrusion process through a conical die. The rigid-plastic FE model considering frictional contact problem was used to analyze the co-extrusion process with material combinations of Cu/Al. Different cases of initial geometry shape for composite material were simulated under different conditions of co-extrusion process, which includes the interference and frictional conditions. The main design parameters influencing on deformation pattern are diameter ratio of the composite components and semi-die angle. Efforts are focused on the deformation patterns, velocity gradient, predicted forming load and the end distance through the various simulations. Simulation results indicate that there is an obvious difference of forming pattern with various diameter ratio and semi-die angle. The analysis in this paper is concentrated on the evaluation of the design parameters on the deformation pattern of composite rod.

키워드