DOI QR코드

DOI QR Code

Study on Current Limiting Characteristics of YBCO Thin-Film Wire with Insulation Layer

  • Doo, Seung-Gyu (HANARO REACTOR Management Department, Korea Atomic Energy Research Institute) ;
  • Du, Ho-Ik (Advanced Graduate Education Center of Jeonbuk for Electronics and Information Technology-BK21, Chonbuk National University) ;
  • Jeon, An-Gyoon (Department of Electrical Engineering, Ho Nam University)
  • 투고 : 2012.09.13
  • 심사 : 2012.11.27
  • 발행 : 2013.02.25

초록

When applying superconducting wire to power machines, an investigation needs to be carried out on the characteristics of wire phase changes in connection with the insulating layer. This study examined trends in the increase of the wire's resistance and the characteristics of its recovery from quenching by a current-applied cycle at temperatures of 90 K, 180 K, and 250 K. The procedure was conducted based on the thickness and presence (or absence) of the insulating wire layers. To achieve this, YBCO thin-film wires with the same critical temperatures were prepared with copper and stainless steel stabilizing layers. At levels (-one, three, and five-), with superior performance, polyimide pressure-sensitive adhesive tape was attached to the wires at a very low temperature. The eight prepared test samples were wound around the linear frames. The wire's voltage and current created from the phase change characteristics were measured at the wire's prescribed temperature, using the four-point probe method. The wire's resistance and recovery characteristics were examined for each cycle at temperatures of 90 K, 180 K, and 250 K.

키워드

참고문헌

  1. A. Ishiyama, Hiroshi. Ueda, Taketoshi. Ando, Hironori. Naka, Sadanoir. Bamba and Yuh. Shiohara "A criterion for determining stabilizer thickness of YBCO coated conductors based on coil protection," IEEE Trans. Appl. Supercond., Vol. 17, No. 2, pp. 2430-2433, 2007 [DOI: http://dx.doi.org/10.1109/ TASC.2007.897998].
  2. H.-I. Du, S.-W. Yim, B.-J. Choi, B.-H. Choi, S.-G. Doo, B.-S. Han, Y.-H Han, and T.-H. Sung "Study on over-current characteristics of HTS tape by stabilizing material," Physica C, Vol. 468, pp. 1706-17009, 2008 [DOI: http://dx.doi.org/DOI:10.1016/ j.physc.2008.05.278].
  3. Tomonori Watanabe, Yuh Shiohara, and Teruo Izumi, "Progress and future prospects of research and development on coated conductor in Japan," IEEE Trans. Appl. Supercond., Vol. 13, No. 2, pp. 2445-2451, 2003 [DOI: http://dx.doi.org/10.1109/ TASC.203.811818].
  4. Naoyuki Amemiya, Shun-ichi Murasawa, Nobuya Banno, Kengo Miyamoto, "Numerical modelings of superconducting wires for AC loss calculation," Physica C, Vol. 310, pp. 16-29, 1998. https://doi.org/10.1016/S0921-4534(98)00427-4
  5. Ho-ik Du, Yong-jin Kim, Dong-hyeok Lee, Byoung-sung Han, Sang-seob Song, Min-ju Kim, and Sang-chul Han, "Study on maximum operating condition of resistive type SFCL using YBCO coated conductor," IEEE Trans. Appl, Supercond., Vol. 20, No. 3, pp. 1238-1241, 2010 [DOI: http://dx.doi.org/10.1109/ TASC.2010.2041212].