DOI QR코드

DOI QR Code

Steel - concrete bond potentials in self-compacting concrete mixes incorporating dolomite powder

  • Kamal, Mounir M. (Department of Civil Engineering, Faculty of Engineering, Menoufia University) ;
  • Safan, Mohamed A. (Department of Civil Engineering, Faculty of Engineering, Menoufia University) ;
  • Al-Gazzar, Mohamed A. (Water Research Center, Ministry of Irrigation, Al-Kanater)
  • 투고 : 2012.01.20
  • 심사 : 2013.10.20
  • 발행 : 2013.12.25

초록

The main objective of this research was to evaluate the potentials of self-compacting concrete (SCC) mixes to develop bond strength. The investigated mixes incorporated relatively high contents of dolomite powder replacing Portland cement. Either silica fume or fly ash was used along with the dolomite powder in some mixes. Seven mixes were proportioned and cast without vibration in long beams with 10 mm and 16 mm steel dowels fixed vertically along the flowing path. The beams were then broken into discrete test specimens. A push-put configuration was adopted for conducting the bond test. The variation of the ultimate bond strength along the flowing path for the different mixes was evaluated. The steel-concrete bond adequacy was evaluated based on normalized bond strength. The results showed that the bond strength was reduced due to Portland cement replacement with dolomite powder. The addition of either silica fume or fly ash positively hindered further degradation as the dolomite powder content increased. However, all SCC mixes containing up to 30% dolomite powder still yielded bond strengths that were adequate for design purpose. The test results demonstrated inconsistent normalized bond strength in the case of the larger diameter compared to the smaller one.

키워드

참고문헌

  1. ACI 232.2R-03 (2003), Use of fly ash in concrete, ACI Committee 232, 41.
  2. ACI 234R-06 (2006), Guide for the use of silica fume in concrete, Bond and development of straight reinforcing bars in tension, ACI Committee 234, 63.
  3. ACI 318R-08 (2008), Building code requirements for structural concrete (318-08) and commentary, ACI Committee 318, 471.
  4. ACI 408R-03 (2003), Bond and development of straight reinforcing bars in tension, ACI Committee 408, 49.
  5. Al-Gazzar M.A. (2009), Low-cost self-compacting Concrete, Ph.D. Dissertation, Menoufia University, Egypt, 243.
  6. Assie, S., Escadeillas, G. and Waller, V. (2007), "Estimates of self-compacting concrete potential durability", Constr. Build. Mater., 21, 1909-1917. https://doi.org/10.1016/j.conbuildmat.2006.06.034
  7. ASTM C618, Specification for fly ash and raw calcined natural Pozzolan for use as a mineral admixture in portland cement concrete, 4.
  8. ASTM C494 (2001), Standard specification for chemical admixtures for concrete, 9.
  9. BRE Special Digest-1 (2005), Concrete in Aggressive Ground, Building Research Establishment (BRE), Watford, UK. Publisher: HIS Rapidoc, Willoughby, Bracknall, Berks, UK.
  10. BS-EN 197-1 (2000), "Cement: composition, specifications, and conformity criteria for common cements", British Standards, 52.
  11. BS 5328-1 (1997), "Concrete: guide to specifying concrete", British Standards, 32.
  12. BS 8500 (2002), "Concrete: complementary British standard to BS EN 206-1, Part 1: method of specifying and guidance for the specifier", 66.
  13. BS 8500 (2006), "Part 2: Specifications for constituent materials and concrete", British Standards, 46.
  14. Chan, K.D., Ong, K.C.G. and Tam, C.T. (2010), "Passing ability of SCC - improved method based on the PRing", Proceedings of the 35th Conference on Our World in Concrete and Structures, Singapore, August.
  15. Chan, Y.W., Chen, Y.S. and Liu, Y.S. (2003), "Development of bond strength of reinforcing steel in selfconsolidation concrete", ACI Struct. J., 100(4), 490-498.
  16. CSA A23.1 (2009), "Concrete materials and methods of concrete construction", Canadian Standards, 582.
  17. Daoud, A., Lorrain, M. and Laborderie, C. (2003), "Anchorage and cracking behavior of self-compacting concrete", Proceedings of Third RILEM International Symposium on Self-Compacting Concrete, Wallevik, O. and Nielsson, I. Editors, Reykjavik Iceland, RILEM Publications, PRO 33, Bagneux, France.
  18. De Almeida F.M., De Nardin, S. and El-Debs, A.L.H.C. (2005), "Evaluation of the bond strength of selfcompacting concrete in pull-out tests", Proceedings of the 2nd North American conference on the Design and Use of Self-Consolidating Concrete and 4th International RILEM Symposium on Self-Compacting Concrete. Chicago.
  19. Domone, P.L. (2007), "A review of the hardened mechanical properties of self-compacting concrete", Cem. Concr. Compos., 29, 1-12. https://doi.org/10.1016/j.cemconcomp.2006.07.010
  20. Dunster, A. (2009), Silica Fume in Concrete, BREPress, Watford, UK.
  21. ECP 203-2007 (2007), Egyptian code for the design and construction of reinforced concrete structures, National Building and Research Center, Cairo, Egypt.
  22. Eligehausen, R., Popov, E.P. and Bertero, V.V. (1983), Local Bond Dtress-Slip Relationships of Deformed Bars Under Generalized Excitations, Report No. UCB/EERC-83/23.
  23. FIB (2000), Bond of Reinforcement in Concrete, State-of-Art Report, FIB Bulletin 10, Switzerland.
  24. Foroughi-Asl A., Dilmaghani, S. and Famili, H. (2008), "Bond strength of reinforcement steel in selfcompacting concrete", Int.. J. Civ. Eng., 6(1), 24-33.
  25. Hooton, R.D., Nokken, M.R. and Thomas, M.D.A. (2007), ".Portland Limestone Cement: State-of-the-Art Report and Gap Analysis for CSA A3000", Cem. Association Can. Res. Dev., Report SN3053, 59
  26. Kamal, M.M., Safan, M.A. and Al-Gazzar, M.A. (2008), "Blended Portland cements for low-cost selfcompacting concrete", Proceedings of the 1st International Conference New Cements and their Effects on Concrete Performance National Housing and Building and Research Center (HBRC) and Helwan University, Cairo, Egypt.
  27. Khan, M.S., Reddy, A.R., Shariq, M. and Prasad, J. (2007), "Studies in bond strength in RC flexural members", Asian J. Civ. Eng., 8(1), 89-96.
  28. Lutz, L.A., and Gergely, P. (1967), "Mechanics of bond and slip of deformed bars in concrete", ACI J., 64(11), 711-721.
  29. Menezes, F., El Debs, M.K. and El Debs, A.L. (2008), "Bond-slip behavior of self-compacting concrete and vibrated concrete using pull-out and beam tests", Mater. Struct., 41, 1073-1089. https://doi.org/10.1617/s11527-007-9307-0
  30. Ozawa, K., Maekawa, K., Kunishima, M. and Okamura, H. (1989), "High performance concrete based on the durability design of concrete structures", Proceedings East Asia Pacific conference on Structural Engineering (EASEC 2), Chiang Mai, Thailand.
  31. Safan, M.A. (2011), "Shear strength of self-compacting concrete containing different fillers and coarse aggregates", Concr. Res. Lett, 2(4), 300-314.
  32. Safan, M.A. (2011), "Performance of beams cast with low-cost self-compacting concrete in aggressive environment", Acta Polytech., 51(5), 120-130.
  33. Sonebi, M. and Bartos, P.J.M. (1999), "Hardened SCC and its bond with reinforcement", Proceedings of the First International RILEM Symposium on Self-Compacting Concrete, Eds. Skarendahl, A . and Petersson, O., Stockholm, Sweden.
  34. Tepfers, R. (1979), "Cracking of concrete cover along anchored deformed reinforcing bars", Mag. Concr. Res., 31(106), 3-12. https://doi.org/10.1680/macr.1979.31.106.3
  35. Thomas, M., Hooton, D., Cail, K., Smith, B., Wal, J. and Kazanis, K. (2010), "Field trials of concretes produced with Portland limestone cement: New CSA cement type performs well in an aggressive environment", Concr. Internatl., 32(1), 35-41.
  36. Turk, K., Karatas, M. and Ulucan, Z. (2010), "Effect of the use of different types and dosages of mineral additions on the bond strength of lap-spliced bars in self-compacting concrete", Mater. Struct., 43, 557-570. https://doi.org/10.1617/s11527-009-9511-1
  37. Zhu, W., Gibbs, J.C. and Bartos, P.J.M. (2001), "Uniformity of in situ properties of self-compacting concrete in full-scale structural elements", Cem. Conc. Compos., 23(1), 57-64. https://doi.org/10.1016/S0958-9465(00)00053-6
  38. Zhu, W., Sonebi, M. and Bartos, P.J.M. (2004), "Bond and interfacial properties of reinforcement in selfcompacting concrete", Mater. Struct. 37, 442-448. https://doi.org/10.1007/BF02481580

피인용 문헌

  1. Energy absorption of fibrous self compacting reinforced concrete system vol.4, pp.1, 2016, https://doi.org/10.12989/acc.2016.4.1.037
  2. Investigation of bond-slip modeling methods used in FE analysis of RC members vol.56, pp.2, 2015, https://doi.org/10.12989/sem.2015.56.2.275
  3. Mechanical strengths of self compacting concrete containing sawdust-ash and naphthalene sulfonate vol.2, pp.4, 2014, https://doi.org/10.12989/acc.2014.2.4.301
  4. Experimental and analytical behaviour of cogged bars within concrete filled circular tubes vol.20, pp.5, 2016, https://doi.org/10.12989/scs.2016.20.5.1067
  5. Bond behavior of lightweight concretes containing coated pumice aggregate: hinged beam approach vol.16, pp.6, 2015, https://doi.org/10.12989/cac.2015.16.6.909