DOI QR코드

DOI QR Code

니켈기 용사코팅의 스플랫 형성에 관한 연구

Study on the Splat Formation of Ni-based Thermal Sprayed Coatings

  • Kim, K.T. (Department of Mechanical & Automotive Engineering, Pukyong National University) ;
  • Lee, S.S. (Department of Mechanical & Automotive Engineering, Pukyong National University) ;
  • Lee, D.H. (Department of Mechanical Engineering, Pukyong National University) ;
  • Kim, Y.S. (Department of Mechanical & Automotive Engineering, Pukyong National University)
  • 투고 : 2011.07.20
  • 심사 : 2011.11.24
  • 발행 : 2012.04.30

초록

Thermal spray coatings developed by deposition of splats, it formed by impacting molten droplets on substrates during thermal spray process. In this study, the Ni-based coatings were fabricated by thermal spray process with two different process parameters, oxygen gas flow and acetylene gas flow, with three different levels of each parameters. The morphology of splats and microstructure were observed by optical microscope. Hardness test were performed on the Ni-based coatings. It was confirmed that process parameters of thermal spray process have effect in morphology of splats. These effects also have important implications on the deposit microstructure and properties of Ni-based coatings.

키워드

참고문헌

  1. E. Celik et al., 2005, "Corrosion behavior of plasma spray coatings", Surface and Coatings Technology, Vol. 193, pp. 297-302. https://doi.org/10.1016/j.surfcoat.2004.08.143
  2. R. Gonzalez et al., 2006, "Wear behavior of flame sprayed NiCrBSi coatings remelted by flame or by laser", Wear, Vol. 262, pp. 301-307.
  3. Yasunari Ishikawa et al., 2006, "Sliding wear properties of HVOF sprayed WC-20% Cr3C2-7%Ni cermet coatings" Surface and Coatings Technology, Vol. 201, pp. 4718-4727.
  4. Rajeev Dhiman, Andre G. McDonald, Sanjeev Chandra, 2007, "Predicting splat morphology in a thermal spray process", Surface & Coatings Technology, Vol. 201, p. 7789-7801. https://doi.org/10.1016/j.surfcoat.2007.03.010
  5. K. T. Kim and Y. S. Kim, 2009, "Process Optimization for Thermal-sprayed Ni-based Hard Coating by Design of Experiments", Journal of Korea society for Power System Engineering, Vol, 13, No. 5, pp. 89-94.
  6. K. T. Kim, J. D. Kim and Y. S. Kim, 2011, "Effect of Process Parameters on the Hardness and Wear Rate of Thermal Sprayed Ni-based Coatings", Journal of Korea society for Power System Engineering, Vol, 15, No. 1, pp. 51-56. https://doi.org/10.9726/kspse.2011.15.1.051
  7. S. Sampath, X. Jiang, 2001, "Splat formation and microstructure development during plasma spraying: deposition temprature effects" Materials Science and Engineering A, Vol. 304-306, pp. 11.25-150.