DOI QR코드

DOI QR Code

Simulation of corroded RC structures using a three-dimensional irregular lattice model

  • Kim, Kunhwi (Department of Civil & Environmental Engineering, Yonsei University) ;
  • Bolander, John E. (Department of Civil & Environmental Engineering, University of California) ;
  • Lim, Yun Mook (Department of Civil & Environmental Engineering, Yonsei University)
  • Received : 2011.09.22
  • Accepted : 2012.02.02
  • Published : 2012.03.10

Abstract

Deteriorative effects of steel corrosion on the structural response of reinforced concrete are simulated for varying degrees of corrosion. The simulation approach is based on a three-dimensional irregular lattice model of the bulk concrete, in which fracture is modeled using a crack band approach that conserves fracture energy. Frame elements and bond link elements represent the reinforcing steel and its interface with the concrete, respectively. Polylinear stress-slip properties of the link elements are determined, for several degrees of corrosion, through comparisons with direct pullout tests reported in the literature. The link properties are then used for the lattice modeling of reinforced concrete beams with similar degrees of corrosion of the main reinforcing steel. The model is successful in simulating several important effects of steel corrosion, including increased deflections, changes in flexural cracking behavior, and reduced yield load of the beam specimens.

Keywords

References

  1. Abrishami, H.H. and Mitchell, D. (1992), "Simulation of uniform bond stress", ACI Mater. J., 89(2), 161-168.
  2. Abrishami, H.H. and Mitchell, D. (1996), "Analysis of bond stress distributions in pullout specimens", J. Struct. Eng.-ASCE, 122(3), 255-261. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:3(255)
  3. Allampallewar, S.B. and Srividya, A. (2008), "Modeling cover cracking due to rebar corrosion in RC members", Struct. Eng. Mech., 30(6), 713-732. https://doi.org/10.12989/sem.2008.30.6.713
  4. Al-Sulaimani, G.J., Kaleemullah, M., Basunbul, I.A. and Rasheeduzzafar (1990), "Influence of corrosion and cracking on bond behavior and strength of reinforced concrete members", ACI Struct. J., 87(2), 220-231.
  5. Barzegar, F. and Maddipudi, S. (1994), "Generating reinforcement in FE modeling of concrete structures", J. Struct. Eng.-ASCE, 120(5), 1656-1662. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:5(1656)
  6. Barzegar, F. and Maddipudi, S. (1997), "Three-dimensional modeling of concrete structures. II: reinforced concrete", J. Struct. Eng.-ASCE, 123(10), 1347-1356. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:10(1347)
  7. Bazant, Z. (1979), "Physical model for steel corrosion in concrete sea structures - theory", J. Struct. Div.-ASCE, 105(6), 1137-1153.
  8. Bazant, Z.P. and Oh, B. (1983), "Crack band theory for fracture of concrete", RILEM Mater. Struct., 16, 155-176.
  9. Berton, S. and Bolander, J.E. (2006), "Crack band modeling of fracture in irregular lattices", Comput. Method Appl. M., 195, 7172-7181. https://doi.org/10.1016/j.cma.2005.04.020
  10. Bhargava, K., Ghosh, A.K., Mori, Y. and Ramanujam, S. (2008), "Suggested empirical models for corrosioninduced bond degradation in reinforced concrete", J. Struct. Eng.-ASCE, 134(2), 221-230. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:2(221)
  11. Biondini, F., Bontempi, F., Frangopol, D. and Malerba, P. (2006), "Probabilistic service life assessment and maintenance planning of concrete structures", J. Struct. Eng.-ASCE, 132(5), 810-825. https://doi.org/10.1061/(ASCE)0733-9445(2006)132:5(810)
  12. Bolander, J.E., Hong, G.S. and Yoshitake, K. (2000), "Structural concrete analysis using rigid-body-spring networks", Comput.-Aided Civ. Inf., 15, 102-133.
  13. Bolander, J.E. and Saito, S. (1998), "Fracture analyses using spring networks with random geometry", Eng. Fract. Mech., 61, 569-591. https://doi.org/10.1016/S0013-7944(98)00069-1
  14. Bolander, J.E. and Sukumar, N. (2005), "Irregular lattice model for quasistatic crack propagation", Phys. Rev. B, 71(9), 094106. https://doi.org/10.1103/PhysRevB.71.094106
  15. Cairns, J. and Abdullah, R.B. (1996), "Bond strength of black and epoxy-coated reinforcement - a theoretical approach", ACI Mater. J., 93(4), 362-369.
  16. Chung, L., Najm, H. and Balaguru, P. (2008), "Flexural behavior of concrete slabs with corroded bars", Cement Concrete Comp., 30(3), 184-193.
  17. Ciampi, V., Eligehausen, R., Bertero, V.V. and Popov, E.P. (1982), Analytical Model for Concrete Anchorages of Reinforcing Bars under Generalized Excitations, Tech. Rep. 82/23, University of California, Berkeley.
  18. Coronelli, D. (2002), "Corrosion cracking and bond strength modeling for corroded bars in reinforced concrete", ACI Struct. J., 99(3), 267-276.
  19. Davis, T.A. and Hager, W.W. (2001), "Multiple-rank modifications of a sparse Cholesky factorization", SIAM J. Matrix Anal. A., 22(4), 997-1013. https://doi.org/10.1137/S0895479899357346
  20. Eligehausen, R., Popov, E.P. and Bertero, V.V. (1983), Local Bond Stress-slip Relationships of Deformed Bars under Generalized Excitations, Tech. Rep. 82/23, University of California, Berkeley.
  21. Gill, P., Golub, G., Murray, W. and Saunders, M. (1974), "Methods for modifying matrix factorizations", Math. Comput., 28(126), 505-535. https://doi.org/10.1090/S0025-5718-1974-0343558-6
  22. Grassl, P. (2009), "A lattice approach to model flow in cracked concrete", Cement Concrete Comp., 31, 454-460. https://doi.org/10.1016/j.cemconcomp.2009.05.001
  23. Grassl, P. and Davies, T. (2011), "Lattice modelling of corrosion induced cracking and bond in reinforced concrete", Cement Concrete Comp., 33(9), 918-924. https://doi.org/10.1016/j.cemconcomp.2011.05.005
  24. Hansen, E. and Saouma, V. (1999), "Numerical simulation of reinforced concrete deterioration: Part II - steel corrosion and concrete cracking", ACI Mater. J., 96, 331-337.
  25. Hughes, T. (1987), The Finite Element Method - Linear Static and Dynamic Finite Element Analysis, Prentice-Hall.
  26. Kawai, T. (1978), "New discrete models and their application to seismic response analysis of structures", Nucl. Eng. Des., 48, 207-229. https://doi.org/10.1016/0029-5493(78)90217-0
  27. Lee, H. (1997), "Evaluation of structural performance and strengthening of corrosion deteriorated reinforced concrete members", Ph.D. thesis, Tokyo University, Japan.
  28. Li, C., Lawanwisut, W. and Zheng, J. (2005), "Time-dependent reliability method to assess the serviceability of corrosion-affected concrete structures", J. Struct. Eng.-ASCE, 131(11), 1674-1680. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:11(1674)
  29. Liu, Y. and Weyers, R. (1998), "Modeling the time-to-corrosion cracking in chloride contaminated reinforced concrete structures", ACI Mater. J., 95(6), 675-681.
  30. Mathey, R.G. and Watstein, D. (1961), "Investigation of bond in beam and pull-out specimens with high-yieldstrength deformed bars", J. Am. Concrete I., 57, 1071-1090.
  31. McGuire, W. and Gallagher, R.H. (1979), Matrix Structural Analysis, John Wiley and Sons.
  32. Mehta, P.K. and Monteiro, P.J.M. (1993), Concrete: Structure, Properties, and Materials, Prentice Hall.
  33. Nakamura, H., Srisoros, W., Yashiro, R. and Kunieda, M. (2006), "Time-dependent structural analysis considering mass transfer to evaluate deterioration process of RC structures", J. Adv. Concr. Technol., 4, 147-158. https://doi.org/10.3151/jact.4.147
  34. Nawy, E.G. (2003), Reinforced Concrete: A Fundamental Approach, Prentice Hall.
  35. Ngo, D. and Scordelis, A.C. (1967), "Finite element analysis of reinforced concrete beams", J. Am. Concrete I., 64(3), 152-163.
  36. Nukala, P., Simunovic, S. and Guddati, M. (2005), "An efficient algorithm for modeling progressive damage accumulation in disordered materials", Int. J. Numer. Meth. Eng., 62(14), 1982-2008. https://doi.org/10.1002/nme.1257
  37. Pantazopoulou, S. and Papoulia, K. (2001), "Modeling cover-cracking due to reinforcement corrosion in RC structures", J. Eng. Mech., 127(4), 342-351. https://doi.org/10.1061/(ASCE)0733-9399(2001)127:4(342)
  38. Preparata, F.P. and Shamos, M.I. (1985), Computational Geometry: An Introduction, Springer-Verlag, New York.
  39. Rokugo, K., Iwasa, M., Suzuki, T. and Koyanagi, W. (1989), "Testing method to determine tensile strain softening curve and fracture energy of concrete", Fracture Toughness and Fracture Energy, Balkema, 153-163.
  40. Rots, J., Belletti, B. and Invernizzi, S. (2008), "Robust modeling of RC structures with an "event-by-event" strategy", Eng. Fract. Mech., 75, 590-614. https://doi.org/10.1016/j.engfracmech.2007.03.027
  41. Stanish, K., Hooton, R.D. and Pantazopoulou, S.J. (1999), "Corrosion effects on bond strength in reinforced concrete", ACI Struct. J., 96(6), 915-921.
  42. Sukumar, N. and Bolander, J.E. (2008), "Voronoi-based interpolants for fracture modelling", Tessellations in the Sciences: Virtues, Techniques and Applications of Geometric Tilings, Springer-Verlag, 1-27.
  43. Tran, K.K., Nakamura, H., Kawamura, K. and Kunieda, M. (2011), "Analysis of crack propagation due to rebar corrosion using RBSM", Cement Concrete Comp., 33(9), 906-917. https://doi.org/10.1016/j.cemconcomp.2011.06.001
  44. Task Committee on Finite Element Analysis of Reinforced Concrete Structures (1982), State-of-the-art Report on Finite Element Analysis of Reinforced Concrete, Tech. Rep., ASCE.
  45. Tuutti, K. (1982), Corrosion of Steel in Concrete, Swedish Cement and Concrete Research Institute.
  46. Vorechovska, D., Podrouzek, J., Chroma, M., Rovnanikova, P. and Teply, B. (2009), "Modeling of chloride concentration effect on reinforcement corrosion", Comput.-Aided Civ. Inf., 24(6), 446-458. https://doi.org/10.1111/j.1467-8667.2009.00602.x
  47. Widom, B. (1966), "Random sequential addition of hard spheres to a volume", J. Chem. Phys., 44, 3888-3894. https://doi.org/10.1063/1.1726548
  48. Yip, M., Mohle, J. and Bolander, J.E. (2005), "Automated modeling of 3-D structural components using irregular lattices", Comput.-Aided Civ. Inf., 20(6), 393-407. https://doi.org/10.1111/j.1467-8667.2005.00407.x

Cited by

  1. Validation of three-dimensional irregular lattice model for concrete failure mode simulations under impact loads vol.169, 2017, https://doi.org/10.1016/j.engfracmech.2016.11.007
  2. Symptom-based reliability analyses and performance assessment of corroded reinforced concrete structures vol.53, pp.6, 2015, https://doi.org/10.12989/sem.2015.53.6.1183
  3. Modeling of fiber-reinforced cement composites: Discrete representation of fiber pullout vol.51, pp.10, 2014, https://doi.org/10.1016/j.ijsolstr.2014.02.006
  4. Estimation of internal corrosion degree from observed surface cracking of concrete using mesoscale simulation with Model Predictive Control vol.36, pp.5, 2012, https://doi.org/10.1111/mice.12620