Effect of Boss Wall Thickness on Sink Mark in Injection Molding

보스 벽 두께가 사출성형의 싱크마크 발생에 미치는 영향

  • 김현필 (한국폴리텍VII대학 컴퓨터응용금형과) ;
  • 김용조 (경남대학교 기계자동화공학부)
  • Received : 2011.11.09
  • Accepted : 2012.04.13
  • Published : 2012.06.29

Abstract

The sink mark on boss parts is generated by the volumetric shrinkage that is caused by both the molding thickness and the boss wall thickness. The volumetric shrinkage is caused by packing pressure and its amount tends to decrease by increasing the packing pressure. The packing pressure can therefore increase the flow rate to a boss part and causes the depth of sink mark to increase. As the molding thickness and the boss wall thickness in the boss part can increase the part volume, these may yield bad solidifying and also extend the molding cycle. In this paper, both the injection molding test and the flow analysis were carried out to investigate the effect of sink mark that was generated in the boss wall thickness of injection molded products. The sink mark could also be caused by thickness ratio of boss part. For a given thickness ratio of boss, several molding process parameters such as packing pressure, packing time and melt temperature, affecting to generation of the sink mark were discussed.

Keywords