Structural Engineering and Mechanics

  • 제39권2호
  • /
  • Pages.241-266
  • /
  • 2011
  • /
  • 1225-4568(pISSN)
  • /
  • 1598-6217(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Theoretical and experimental serviceability performance of SCCs connections

  • Maghsoudi, Ali Akbar (Department of Civil Engineering, University of Kerman & International Center for Science, High Technology & Environmental Sciences)
  • 투고 : 2009.12.31
  • 심사 : 2011.04.06
  • 발행 : 2011.07.25
⟨ 이전 논문 다음 논문 ⟩

초록

The Self Compacting Concrete, SCC is the new generation type of concrete which is not needed to be compacted by vibrator and it will be compacted by its own weight. Since SCC is a new innovation and also the high strength self compacting concrete, HSSCC behavior is like a brittle material, therefore, understanding the strength effect on the serviceability performance of reinforced self compacting concretes is critical. For this aim, first the normal and high strength self compacting concrete, NSSCC and HSSCC was designed. Then, the serviceability performance of reinforced connections consisting of NSSCC and HSSCC were investigated. Twelve reinforced concrete connections (L = 3 m, b = 0.15 m, h = 0.3 m) were simulated, by this concretes, the maximum and minimum reinforcement ratios ${\rho}$ and ${\rho}^{\prime}$ (percentage of tensile and compressive steel reinforcement) are in accordance with the provision of the ACI-05 for conventional RC structures. This study was limited to the case of bending without axial load, utilizing simple connections loaded at mid span through a stub (b = 0.15 m, h = 0.3 m, L = 0.3 m) to simulate a beam-column connection. During the test, concrete and steel strains, deflections and crack widths were measured at different locations along each member. Based on the experimental readings and observations, the cracked moment of inertia ($I_{cr}$) of members was determined and the results were compared with some selective theoretical methods. Also, the flexural crack widths of the members were measured and the applicability for conventional vibrated concrete, as for ACI, BS and CSA code, was verified for SCCs members tested. A comparison between two Codes (ACI and CSA) for the theoretical values cracking moment is indicate that, irrespective of the concrete strength, for the specimens reported, the prediction values of two codes are almost equale. The experimental cracked moment of inertia $(I_{cr})_{\exp}$ is lower than its theoretical $(I_{cr})_{th}$ values, and therefore theoretically it is overestimated. Also, a general conclusion is that, by increasing the percentage of ${\rho}$, the value of $I_{cr}$ is increased.

키워드

참고문헌

  1. ACI Committee 363 (1992), Review of ACI Code for Possible Revisions for High-strength Concrete (ACI 362R- 92), American Concrete Institute, Detroit.
  2. Akbarzadeh Bengar, H. (2004), "Effect of tensile and compressive reinforcement ratio on ductility and behavior of high-strength concrete reinforced flexural members", M.Sc. Thesis, Department of Civil Engineering, University of Kerman, Iran.
  3. American Concrete Institute (ACI) (2005), Building Code Requirements for Structural Concrete and Commentary, ACI 318-05 and ACI 318R-05.
  4. Ashour, A.A. (2000), "Effect of compressive strength and tensile reinforcement ratio flexural behavior of highstrength concrete beams", Eng. Struct., 22(5), 413-423. https://doi.org/10.1016/S0141-0296(98)00135-7
  5. Bosco, C., Carpinteri, A. and Debernardi, P.G. (1990), "Minimum reinforement in high-strength concrete", J. Struct. Eng.-ASCE, 116, 427.
  6. British Standard (1985), Structural Use of Concrete, BS8110, part2, London, UK.
  7. Burns, N.H. and Siess, C.P. (1962), "Load-deformation characteristics of beam-column connections in reinforced concrete", Civil Engineering Studies, No.234.
  8. Carrasquillo, R.L., Nilson, A.H. and Slate, F.O. (1981), "Properties of high strength concrete subject to shortterm loads", J. Am. Concrete Institute, 3, 171-178.
  9. CSA 94 (1994), "CSA technical committee", Design of Concrete Structure for Building, CAN3-A23.3-M94, Canadian Standards Association, Rexdale, Ontario.
  10. Ernst, G.C. (1957), "Plastic hinging at the intersection of beams and columns", ACI J., 28, 1119-1144.
  11. Gatteh, H.F. (2006), "Experimental and theoretical investigation of reinforced self compacting concrete joints", M.Sc. Thesis, Department of Civil Engineering, University of Kerman, Kerman, Iran.
  12. Ghali, A. (1993), "Deflection of reinforced concrete members, a critical review", ACI Struct. J., 90, 364-373.
  13. Joint ACI-ASCE Committee 352 (2004), Recommendations for Design of Slab-column Connections in Monolithic Reinforced Concrete Structures (ACI 35. IR-89) (Reaproved 20004), American Conconcrete Institute, Farmington Hills, MI.
  14. Khayat, K.H. (1999), "Workability, testing, and performance of self- consolidating concrete", ACI Mater. J., 96(3), 349-353.
  15. Khayat, K.H., Paultre, P. and Tremblay, S. (2001), "Structural performance and in-place properties of selfconsolidating concrete used for casting highly reinforced columns", ACI Mater. J., 98, 371-378.
  16. Leslie, K.E., Rajagopalan, K.S. and Everard, N.J. (1976), "Flexural behavior of high-strength concrete beams", ACI Struct. J., 73, 517.
  17. MacGregor, J.G. and Wight, J.K. (2005), Reinforced Concrete Mechanics and Design, 4th Edition, Pearson Prentice Hall, Upper Saddle River, New Jersey.
  18. Maghsoudi, A.A. and Akbarzadeh Bengar, H. (2005), "Effect of ${\rho}$ on ductility of HSC members under bending", Proceedings of the 7th International Symposium on Utilization of High-Strength/High Performance Concrete, Washington, D.C., USA.
  19. Mansur, M.A., Wee, T.H. and Chin, M.S. (1994), "Some engineering properties of locally produced high-strength concrete", Proceedings of the 19th Conference on Our World in Concrete and Structures, CI-Premier Pte. Ltd., Singapore.
  20. Mohamadi, Y.M. (2007), "Behavior of high strength self compacting concrete joints under load", M.Sc. Thesis, Department of Civil Engineering, University of Kerman, Kerman, Iran.
  21. Mohammad, L., Khadaker, M., Hossain, K.M. and Vasilios, B.L. (2006), "Axial load behavior of selfconsolidating concrete-filed steel tube columns in construction and service stages", ACI Struct. J., 2, 57-65.
  22. Nilson, A.H. (1987), "Design implication of current research on high strength concrete", High-Strength Concrete, ACI SP-87, American Concrete Institute, Detroit.
  23. Okamura, H. (1997), "Self-compacting high-performance concrete", Concrete Int., 19(7), 50-54.
  24. Pateli, R., Hossain, K.M., Shehata, M., Bouzabaa, N. and Lachemi, M. (2004), "Development of statistical models for mixture design of high-volume fly ash self-compacting concrete", ACI Mater. J., 101, 294-302.
  25. Rashid, M.A., Mansur, M.A. and Paramasivam, P. (2002), "Correlations between mechanical properties of highstrength concrete", J. Mater. Civil Eng., 3, 230-238.
  26. Robertson, I.N., Kawai, T., Lee, J. and Enomoto, B. (2002), "Cyclic testing of slab-column connections with shear reinforcement", ACI Struct. J., 99(5), 605-613.
  27. Saria, M., Prat, E. and Labastire, J.F. (1998), "High-strength self-cmpacting concrete, original solutions associating organic and inorganic admixtures", Proceedings of the International Symposium on High- Performance and Reactive Powder Concretes, University of Sherbooke.
  28. Skarendahl, A. and Petersson, O. (2001), "State-of-the-art report of RILEM technical committee 174-SCC", Self- Compacting Concrete, Report No.23, 141.
  29. Sonebi, M. and Bortos, P.J.M. (2001), "Performance of reinforced columns with self-compacting concrete", Proceedings of the 5th CANMET/ACI International Conference, American Concrete Institute, Farmington Hills.
  30. Swamy, R.N. (1987), "High strength concrete-material properties and structural behavior", High-Strength Concrete, ACI SP-87, American Concrete Institute, Detroit.
  31. Yurugi, M. (1998), "Application of self-compacting concrete in japan", Proceedings of the 23rd OWICS Conference, Singapore.

피인용 문헌

  1. Experimental investigation of RCS connections performance using self-consolidated concrete vol.114, 2015, https://doi.org/10.1016/j.jcsr.2015.07.026