DOI QR코드

DOI QR Code

Modeling of air cushion vehicle's flexible seals under steady state conditions

  • Zalek, Steven F. (Department of Naval Architecture and Marine Engineering, University of Michigan) ;
  • Karr, Dale G. (Department of Naval Architecture and Marine Engineering, University of Michigan) ;
  • Jabbarizadeh, Sara (Department of Naval Architecture and Marine Engineering, University of Michigan) ;
  • Maki, Kevin J. (Department of Naval Architecture and Marine Engineering, University of Michigan)
  • Received : 2010.07.26
  • Accepted : 2011.02.10
  • Published : 2011.03.25

Abstract

The purpose of this paper is to demonstrate the efficacy of modeling a surface effect ship's air-cushion flexible seal utilizing a two-dimensional beam under steady state conditions. This effort is the initial phase of developing a more complex three-dimensional model of the air-seal-water fluid-structure interaction. The beam model incorporates the seal flexural rigidity and mass with large deformations while assuming linear elastic material response. The hydrodynamic pressure is derived utilizing the OpenFOAM computational fluid dynamic (CFD) solver for a given set of steady-state flow condition. The pressure distribution derived by the CFD solver is compared with the pressure required to deform the seal beam model. The air pressure, flow conditions and seal geometry are obtained from experimental analysis. The experimental data was derived from large-scale experimental tests utilizing a test apparatus of a canonical surface effect ship's flexible seal in a towing tank over a variety of test conditions.

Keywords

References

  1. Bresch, P.K. (1976), "Motions of bow seal fingers in a surface effect ship flexible seal," David W. Taylor, Naval Ship Research and Development Center Report No. 76-0026.
  2. Doctors, L.J. and McKesson, C.B. (2006), "The resistance components of a surface-effect ship", Proceedings of the 26th Symposium on Naval Hydrodynamics, Rome, Italy, September.
  3. Graham, T.A., Sullivan, P.A. and Hinchey, M.J. (1985), "Skirt material effects on air cushion dynamic stability", J. Aircraft, 22(2), 101-108. https://doi.org/10.2514/3.45092
  4. Graham, T.A. and Sullivan, P.A. (2002), "Pitch-heave dynamics of a segmented skirt air cushion", J. Ship Res., 46(2), 121-137
  5. Malakhoff, A. and Davis, S. (1981), "Dynamics of SES bow seal fingers", Proceedings of the American Institute of Aeronautics and Astronautics Sixth Marine Systems Conference, Seattle, Washington, September.
  6. Sullivan, P.A., Charest, P.A. and MA, T. (1994), "Heave stiffness of an air cushion vehicle bag-and-finger skirt", J. Ship Res., 38(4), 302-307.
  7. Ulstein, T. and O.D. Faltinsen (1998), "Cobblestone effect on SES", NATO Research and Technology Organisation", Proceedings of the AVT Symposium on Fluid Dynamics Problems of Vehicles Operating near or in the Air-Sea Interface, Amsterdam, The Netherlands, October .
  8. Wilson, R.A., Wells, S.M. and Heber, C.E. (1979), "Powering predictions for surface effect ships based on model results", J. Hydronautics, 13(4), 113-119. https://doi.org/10.2514/3.63157

Cited by

  1. Physical and numerical large-scale wave basin modeling of fluid-structure interaction and wave impact phenomena vol.9, pp.1, 2011, https://doi.org/10.1007/bf03449284