Geomechanics and Engineering

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Mechanics of the slaking of shales

  • Vallejo, Luis E. (Department of Civil and Environmental Engineering, 949 Benedum Hall, University of Pittsburgh)
  • Received : 2010.10.31
  • Accepted : 2011.08.22
  • Published : 2011.09.25
⟨ Previous Next ⟩

Abstract

Waste fills resulting from coal mining should consist of large, free-draining sedimentary rocks fragments. The successful performance of these fills is related to the strength and durability of the individual rock fragments. When fills are made of shale fragments, some fragments will be durable and some will degrade into soil particles resulting from slaking and inter-particle point loads. The degraded material fills the voids between the intact fragments, and results in settlement. A laboratory program with point load and slake durability tests as well as thin section examination of sixty-eight shale samples from the Appalachian region of the United States revealed that pore micro-geometry has a major influence on degradation. Under saturated and unsaturated conditions, the shales absorb water, and the air in their pores is compressed, breaking the shales. This breakage was more pronounced in shales with smooth pore boundaries and having a diameter equal to or smaller than 0.060 mm. If the pore walls were rough, the air-pressure breaking mechanism was not effective. However, pore roughness (measured by the fractal dimension) had a detrimental effect on point load resistance. This study indicated that the optimum shales to resist both slaking as well as point loads are those that have pores with a fractal dimension equal to 1.425 and a diameter equal to or smaller than 0.06 mm.

Keywords

References

  1. AUTOCAD (2007), Autodesk, Inc., New York.
  2. Bear, J. (1972), Dynamics of fluids in porous media, Dover Publications, Inc., New York.
  3. Broch, E. and Franklin, J.A. (1972), "The point load strength", Int. J. Rock Mech. Min. Sci., 9, 669-697. https://doi.org/10.1016/0148-9062(72)90030-7
  4. Cundall, P.A. and Strack, O.D.L. (1979), "A discrete numerical model for granular assemblies", Geotechnique, 29(1), 47-65. https://doi.org/10.1680/geot.1979.29.1.47
  5. Korvin, G. (1992), Fractal models in the earth sciences, Elsevier, Amsterdam.
  6. Hilpert, M. (2009), "Effects of dynamic contact angle on liquid infiltration into horizontal capillary tubes: semianalytical solutions", J. Colloid Interf. Sci., 337, 131-137. https://doi.org/10.1016/j.jcis.2009.04.013
  7. Humphries, D.W. (1992), The preparation of thin sections of rocks, minerals and ceramics, Royal Microscopical Society Microscopic Handbooks, Oxford Science Publications, Oxford.
  8. Hyslip, J.P. and Vallejo, L.E. (1997), "Fractal analysis of the roughness and size distribution of granular materials", Eng. Geology, 48(3-4), 231-244. https://doi.org/10.1016/S0013-7952(97)00046-X
  9. Indraratna, B. (1994), "The effect of normal stress-friction angle relationship on the stability analysis of a rockfill dam", Geotech. Geol. Eng., 12, 113-121. https://doi.org/10.1007/BF00429769
  10. Koliji, A., Laloui, L., Cusinier, O. and Vulliet, L. (2006), "Suction induced effects on the fabric of a structured soil", Transport Porous Med., 64, 261-278. https://doi.org/10.1007/s11242-005-3656-3
  11. Lutton, R.J. (1977), Design and construction of compacted shale embankments: slaking indices for design, Report FHWA-RD-1, Federal Highway Administration, Washington, D.C.
  12. Mandelbrot, B.B. (1977), Fractals: form, chance and dimension, W.H. Freeman, San Francisco.
  13. Means, R.E. and Parcher, J.V. (1963), Physical properties of soils, Charles E. Merrill Books Inc. Columbus, Ohio.
  14. Moriwaki, Y. (1974), Causes of slaking of argillaceous materials, Ph.D. Dissertation, Dept. of Civil Engineering, University of California at Berkeley.
  15. Oakland, M.W. and Lovell, C.W. (1982), "Classification and other standard tests of shale embankments", Joint Highway Research Project Report 82-4, Purdue University, West Lafayette, Indiana, 171 p.
  16. Oldecop, L.A. and Alonso, E.E. (2001), "A model for rockfill compressibility", Geotechnique, 51(2), 127-139. https://doi.org/10.1680/geot.2001.51.2.127
  17. Oldecop, L.A. and Alonso, E.E. (2003), "Suction effects on rockfill compressibility", Geotechnique, 53(2), 289- 292. https://doi.org/10.1680/geot.2003.53.2.289
  18. Ransoff, T.C. and Radke, C.J. (1988), "Laminar flow of a wetting liquid along corners of predominantly gas occupied non circular pores", J. Colloid Interf. Sci., 121(2), 391-401.
  19. Santi, P.M. (1995), "Assessing the strength and durability properties of shales", In: Landslides Under Static and Dynamic Conditions-Analysis, Monitoring, and Mitigation, Geotechnical Special Publication, No. 52, American Society of Civil Engineers, Keefer, D.K., and Ho, C.L., Editors, pp.37-55.
  20. Schmitt, L., Forsans, T. and Santarelli, F.J. (1994), "Shale testing and capillary phenomena", Int. J. Rock Mech. Min. Sci., 31(5), 411-427. https://doi.org/10.1016/0148-9062(94)90145-7
  21. Sowers, G.F., Williams, R.C. and Wallace, T.C. (1965), "Compressibility of broken rock and the settlement of rock fills", Proceedings of the 6th Int. Conf. on Soil Mechanics and Foundation Eng., Paris, II, 561-565.
  22. Strohm, W.E. (1978), "Design and construction of compacted shale embankments: field and laboratory investigations", Report FHWA-RD-78-140, Federal Highway Administration, Washington D.C., 146 p.
  23. Surendra, M., Lovell, C.W. and Wood, L.E. (1981), "Laboratory studies of the stabilization of non-durable shales", Transport. Res. Record, 79, 33-40.
  24. Terzaghi, K. and Peck, R.B. (1968), Soil mechanics in engineering practice, John Wiley and Sons, New York.
  25. Washburn, E.W. (1921), "The dynamics of capillary flow", Phys. Rev., 17(3), 273-283. https://doi.org/10.1103/PhysRev.17.273
  26. Welsh, R.A., Vallejo, L.E. and Robinson, M.K. (1987), "Evaluation of durability testing techniques for rock underdrain material used in Appalachian surface coal mining valley fills", Proceedings of the Int. Symposium on Flow Trough Rock Drains, Cranbrook, Canada, I, 83-93.
  27. Yoshida, N. and Hosokawa, K. (2004), J. Geotech. Environ. Eng., 130(5), 519-525. https://doi.org/10.1061/(ASCE)1090-0241(2004)130:5(519)

Cited by

  1. An Unconfined Swelling Test for Clayey Soils That Incorporates Digital Image Correlation vol.36, pp.6, 2013, https://doi.org/10.1520/GTJ20120220
  2. Relationship between fracture toughness and porosity of clay brick panels used in ventilated façades: Initial investigation vol.116, 2014, https://doi.org/10.1016/j.engfracmech.2013.12.003
  3. Fracability Estimation for Longmaxi Shale: Coupled Brittleness, Stress–Strain and Fracture vol.43, pp.11, 2018, https://doi.org/10.1007/s13369-018-3422-9