참고문헌
- H. Ito, H. Suzuki, 2009, Micro-features formation in injection compression molding, J. of Solid Mech. Mater. Eng. 63, Vol. 3, No 2, pp. 320-327. https://doi.org/10.1299/jmmp.3.320
- S. Bickerton, M. Z. Abdullah, 2003, Modeling and evaluation of the filling stage of injectioncompression moulding, Compos. Sci. Technol. 63, pp. 1359-1375. https://doi.org/10.1016/S0266-3538(03)00022-8
- Y. B. Lee, T. H. Kwon, K. H. Yoon, 2002, Numerical prediction of residual stresses and birefringence in injection-compression molded Center-Gated Disk. Part I: Basic Modeling and Results for Injection Molding, Polym. Eng. Sci., Vol. 42, No. 11, pp. 2246-2272. https://doi.org/10.1002/pen.11114
- Y. B. Lee, T. H. Kwon, K. H. Yoon, 2002, Numerical prediction of residual stresses and birefringence in injection-compression molded Center-Gated Disk. Part II: Effects of processing conditions, Polym. Eng. Sci., Vol. 42, No. 11, pp. 2273-2292. https://doi.org/10.1002/pen.11115
- W. B. Young, 2005, Effect of process parameters on injection compression molding of pickup lens, Appl. Math. Modell. 29, pp. 955-971. https://doi.org/10.1016/j.apm.2005.02.004
- H. X. Huang, K. Li, S. Li, 2009, Injectioncompression molded part shrinkage uniformity comparison between semicrystalline and amorphous plastics, Polym. Plast. Technol. Eng. 48, pp. 64-68. https://doi.org/10.1080/03602550802539742
- T. Lin, B. Chananda, 2003, Quality improvement of an injection-molded product using design of experiments: a case study, Qual. Eng., Vol. 16, No. 1, pp. 99-104. https://doi.org/10.1081/QEN-120020776
- D. Mathivanan, N. S. Parthasarathy, 2009, Prediction of sink depths using nonlinear modeling of injection molding variables, Int. J. Adv. Manuf. Technol. 43, pp. 654-663. https://doi.org/10.1007/s00170-008-1749-1
- W. C. Lo, K, M. Tsai, C. Y. Hsieh, 2009, Six sigma approach to improve surface precision of optical lenses in the injection-molding process, Int. J. Adv. Manuf. Technol., Vol. 41, pp. 885-896. https://doi.org/10.1007/s00170-008-1543-0
- A. Kramschuster, R. Cavitt, D. Ermer, Z. Chen, L. S. Turug, 2005, Quantitative study of shrinkage and warpage behavior for microcellular and conventional injection molding, Polym. Eng. Sci., DOI 10.1002/pen.20410, pp. 1408-1418.
피인용 문헌
- Optimization of process variables for improvement of seat-backboard peel strength using response surface design method vol.31, pp.12, 2017, https://doi.org/10.1007/s12206-017-1135-8