DOI QR코드

DOI QR Code

Touchpad for Force and Location Sensing

  • Received : 2010.03.11
  • Accepted : 2010.06.28
  • Published : 2010.10.31

Abstract

This paper presents the design and fabrication model of a touchpad based on a contact-resistance-type force sensor. The touchpad works as a touch input device, which can sense contact location and contact force simultaneously. The touchpad is 40 mm wide and 40 mm long. The touchpad is fabricated by using a simple screen printing technique. The contact location is evaluated by the calibration setup, which has a load cell and three-axis stages. The location error is approximately 4 mm with respect to x-axis and y-axis directions. The force response of the fabricated touchpad is obtained at three points by loading and unloading of the probe. The touchpad can detect loads from 0 N to 2 N. The touchpad shows a hysteresis error rate of about 11% and uniformity error rate of about 3%.

Keywords

References

  1. M.E.H. Eltaib and J.R. Hewit, "Tactile Sensing Technology for Minimal Access Surgery - A Review," Mechatronics: Mech., Electron., Contr., vol. 13, no. 10, 2003, pp.1163-1177.
  2. H. Liu, P. Meusel, and G. Hirzinger, "A Tactile Sensing System for the DLR Three-Finger Robot Hand," Int. Symp. Meas. Control Robot., 1995, pp. 91-96.
  3. H. Kawasaki and T. Komatsu, "Mechanism Design of Anthropomorphic Robot Hand: Gifu Hand," J. Robot. Mechatronics, vol. 11, no. 4, 1999, pp. 269-273. https://doi.org/10.20965/jrm.1999.p0269
  4. T. Mei et al., "An Integrated MEMS Three Dimensional Tactile Sensor with Large Force Range," Sensors Actuator: A, Physical, vol. 80, no. 2, 2000, pp. 155-162. https://doi.org/10.1016/S0924-4247(99)00261-7
  5. M.J. Yoon et al., "Development of a Distributed Flexible Tactile Sensor System," J. KSPE, vol. 19, no. 1, 2002, pp. 212-218.
  6. U. Paschen et al., "A Novel Tactile Sensor System for Heavy- Load Applications Based on an Integrated Capacitive Pressure Sensor," Sensors and Actuators: A, Physical, vol. 68, nos. 1-3, 1998, pp. 294-298. https://doi.org/10.1016/S0924-4247(98)00021-1
  7. J. Engel, J. Chen, and C. Liu, "Development of Polyimide Flexible Tactile Sensor Skin," J. Micromechanics Microeng., vol. 13, no. 3, 2003, pp. 359-366. https://doi.org/10.1088/0960-1317/13/3/302
  8. J.H. Kim et al., "Design of Flexible Tactile Sensor Based on Three-Component Force and Its Fabrication," Proc. IEEE Int. Conf. Robot. Autom., vol. 3, 2005, pp. 2578-2581.
  9. H.J. Kwon, Development of Contact Resistance Type Tactile Sensor and Foot Module for Biped Walking Robots, Doctoral Dissertation, Kyung Hee University, 2009.

Cited by

  1. Transparent and flexible force sensor array based on optical waveguide. vol.20, pp.13, 2010, https://doi.org/10.1364/oe.20.014486
  2. High-Resolution Touch Floor System Using Particle Swarm Optimization Neural Network vol.13, pp.6, 2010, https://doi.org/10.1109/jsen.2013.2248142
  3. A multi-component nanocomposite screen-printed ink with non-linear touch sensitive electrical conductivity vol.24, pp.16, 2010, https://doi.org/10.1088/0957-4484/24/16/165501
  4. A Layered 3D Touch Screen Using Capacitance Measurement vol.14, pp.9, 2014, https://doi.org/10.1109/jsen.2014.2322760
  5. A flexible tactile sensor calibration method based on an air-bearing six-dimensional force measurement platform vol.86, pp.7, 2010, https://doi.org/10.1063/1.4926344
  6. The Proximity Position Detection by Layered 3D Touch Screen vol.51, pp.10, 2010, https://doi.org/10.9746/sicetr.51.687
  7. 포스 터치 커버를 이용한 사용자 중심적 포스 터치 측정에 관한 연구 vol.18, pp.3, 2017, https://doi.org/10.7472/jksii.2017.18.3.37
  8. A Wearable Textile 2D Touchpad Sensor Based on Screen-Printing Technology vol.10, pp.12, 2017, https://doi.org/10.3390/ma10121450
  9. Force-touch measurement methodology based on user experience vol.14, pp.4, 2010, https://doi.org/10.1177/1550147718767794
  10. Textile Concentric Ring Electrodes for ECG Recording Based on Screen-Printing Technology vol.18, pp.1, 2010, https://doi.org/10.3390/s18010300
  11. 35‐4: High Sensitive Pen Writing Solution Based on Mechanical Sensing vol.51, pp.1, 2010, https://doi.org/10.1002/sdtp.13915