초록
지금까지 분포형 모형은 개념적 모형에 비해 운동역학적인 이론에 근거하여 물의 흐름을 수치해석으로 추적해 나가기 때문에 많은 컴퓨터 메모리용량이 요구되고 계산수행시간이 상대적으로 오래 걸리는 단점이 있었다. 그래서 분포형모형의 적용은 주로 소유역에 국한되어 적용되어왔으며, 대유역에 적용하기 위해서는 격자의 해상도를 낮추거나 소유역 적용과 동일한 해상도에서는 계산 시간이 많이 소요되어 실무적용을 어렵게 하는 요인이 되어왔다. 이에 대해 본 연구에서는 MPI (Message Passing Interface)기법을 적용하여 물리적이고 복잡한 수치계산을 하는 분포형모형의 단점 중 하나인 대유역 적용시의 계산소요 문제를 해결하고자 하였다. 또한 병렬화 기법의 적용효과를 분석하기 위하여 단일 영역에서 계산된 결과와 다수의 소영역으로 분할하여 수행되어진 계산 결과를 비교하였다. 용담댐 유역에 2006년 태풍 '에위니아' 사상을 대상으로 병렬화 계산을 수행한 결과 단일 프로세서에서 분포형모형을 수행하는 것보다 병렬코드에서 수행한 경우가 유출계산 값의 변동 없이 최고 10배에 해당되는 계산시간이 단축되었다.
Distributed Models have relative weak points due to the amount of computer memory and calculation time required for calculating water flow using a numerical analysis based on kinematic wave theory when compared to the conceptual models used so far. Typically, the distributed models have been mainly applied to small basins. It was necessary to decrease the resolution of the grid to make it applicable for large scale watersheds, and because it would take up too much time to calculate using a higher resolution. That has been one of the more difficult factors in applying the model for actual work. In this paper, MPI (Message Passing Interface) technique was applied to solve the problem of calculation time as it is one of the demerits of the distributed model for performing physical and complicated numerical calculations for large scale watersheds. The comparison studies were performed a single domain and a divided small domain in Yongdam Dam watershed in case of typoon 'Ewiniar' at 2006. They were compared to analyze the application effects of parallelization technique. As a result, a maximum of 10 times the amount of calculation time was saved but keeping the level of quality for discharge by using parallelization code rather than a single processor.