DOI QR코드

DOI QR Code

Piezo-activated guided wave propagation and interaction with damage in tubular structures

  • Lu, Ye (State Key Laboratory of Mechanical System and Vibration, hanghai Jiao Tong University) ;
  • Ye, Lin (Laboratory of Smart Materials and Structures (LSMS), Centre for Advanced Materials Technology (CAMT), School of Aerospace, Mechanical and Mechatronic Engineering, The University of Sydney) ;
  • Wang, Dong (Laboratory of Smart Materials and Structures (LSMS), Centre for Advanced Materials Technology (CAMT), School of Aerospace, Mechanical and Mechatronic Engineering, The University of Sydney) ;
  • Zhou, Limin (Department of Mechanical Engineering, The Hong Kong Polytechnic University) ;
  • Cheng, Li (Department of Mechanical Engineering, The Hong Kong Polytechnic University)
  • 투고 : 2008.06.24
  • 심사 : 2009.11.17
  • 발행 : 2010.09.25

초록

This study investigated propagation characteristics of piezo-activated guided waves in an aluminium rectangular-section tube for the purpose of damage identification. Changes in propagating velocity and amplitude of the first wave packet in acquired signals were observed in the frequency range from 50 to 250 kHz. The difference in guided wave propagation between rectangular- and circular-section tubes was examined using finite element simulation, demonstrating a great challenge in interpretation of guided wave signals in rectangular-section tubes. An active sensor network, consisting of nine PZT elements bonded on different surfaces of the tube, was configured to collect the wave signals scattered from through-thickness holes of different diameters. It was found that guided waves were capable of propagating across the sharp tube curvatures while retaining sensitivity to damage, even that not located on the surfaces where actuators/sensors were attached. Signal correlation between the intact and damaged structures was evaluated with the assistance of a concept of digital damage fingerprints (DDFs). The probability of the presence of damage on the unfolded tube surface was thus obtained, by which means the position of damage was identified with good accuracy.

키워드

참고문헌

  1. Alleyne, D.N., Pavlakovic, B., Lowe, M.J.S. and Cawley, P. (2001), "Rapid long-range inspection of chemical plant pipework using guided waves", Insight, 43, 93-96.
  2. Castaings, M. and Hosten, B. (2001), "The propagation of guided waves in composite, sandwich-like structures and their use for NDT", Rev. Prog. Quant. Nondest. Eval., 20, 999-1006.
  3. Cawley, P. and Alleyne, D. (1996), "The use of Lamb waves for the long range inspection of large structures", Ultrasonics, 34(2-5), 287-290. https://doi.org/10.1016/0041-624X(96)00024-8
  4. Dalton, R.P., Cawley, P. and Lowe, M.J.S. (2001), "The potential of guided waves for monitoring large areas of metallic aircraft fuselage structure", J. Nondestruct. Eval., 20(1), 29-46. https://doi.org/10.1023/A:1010601829968
  5. Demma, A., Cawley, P., Lowe, M.J.S. and Roosenbrand, A.G. (2003), "The reflection of the fundamental torsional mode from cracks and notches in pipes", J. Acoust. Soc. Am., 114(2), 611-625. https://doi.org/10.1121/1.1582439
  6. Demma, A., Cawley, P., Lowe, M.J.S., Roosenbrand, A.G. and Pavlakovic, B. (2004), "The reflection of guided waves from notches in pipes: a guide for interpreting corrosion measurements", NDT&E Int., 37(3), 167-180. https://doi.org/10.1016/j.ndteint.2003.09.004
  7. Diligent, O., Grahn, T., Bostrom, A., Cawley, P. and Lowe, M.J.S. (2002), "The low-frequency reflection and scattering of the $S_0$ Lamb mode from a circular through-thickness hole in a plate: finite element, analytical and experimental studies", J. Acoust. Soc. Am., 112(6), 2589-2601. https://doi.org/10.1121/1.1512292
  8. Giurgiutiu, V., Zagrai, A.N., Bao, J.J., Redmond, J.M., Roach, D. and Rackow, K. (2003), "Active sensors for health monitoring of aging aerospace structures", Int. J. Condition Monit. Diagnostic Eng. Manag., 6, 3-21.
  9. Giurgiutiu, V. and Cuc, A. (2005), "Embedded non-destructive evaluation for structural health monitoring, damage detection, and failure prevention", Shock Vib. Digest, 37(2), 83-105. https://doi.org/10.1177/0583102405052561
  10. Grondel, S., Delebarre, C., Assaad, J., Dupuis, J.P. and Reithler, L. (2002), "Fatigue crack monitoring of riveted aluminium strap joins by Lamb wave analysis and acoustic emission measurement techniques", NDT&E Int., 35(3), 137-146. https://doi.org/10.1016/S0963-8695(01)00027-5
  11. Hay, T.R., Royer, R.L., Gao, H.D., Zhao, X. and Rose, J.L. (2006), "A comparison of embedded sensor Lamb wave ultrasonic tomography approaches for material loss detection", Smart Mater. Struct., 15(4), 946-951. https://doi.org/10.1088/0964-1726/15/4/007
  12. Hesse, D. and Cawley, P. (2006), "Surface wave modes in rails", J. Acoust. Soc. Am., 120(2), 733-740. https://doi.org/10.1121/1.2211587
  13. Lanza di Scalea, F., Matt, H. and Bartoli, I. (2007), "The response of rectangular piezoelectric sensors to Rayleigh and Lamb ultrasonic waves", J. Acoust. Soc. Am., 121(1), 175-187. https://doi.org/10.1121/1.2400668
  14. Leonard, K.R. and Hinders, M.K. (2003), "Guided wave helical ultrasonic tomography of pipes", J. Acoust. Soc. Am., 114(2), 767-774. https://doi.org/10.1121/1.1593068
  15. Lowe, M.J.S., Alleyne, D.N. and Cawley, P. (1998), "Defect detection in pipes using guided waves", Ultrasonics, 36(1-5), 147-154. https://doi.org/10.1016/S0041-624X(97)00038-3
  16. Lowe, M.J.S. (1998), "Characteristics of the reflection of Lamb waves from defects in plates and pipes", Rev. Prog. Quant. Nondest. Eval., 17, 113-120.
  17. Lu, Y., Ye, L., Su, Z. and Huang, N. (2007), "Quantitative evaluation of crack orientation in aluminium plates based on Lamb waves", Smart Mater. Struct., 16, 1907-1914. https://doi.org/10.1088/0964-1726/16/5/047
  18. Lu, Y., Ye, L., Su, Z. and Yang, C. (2008), "Quantitative assessment of through-thickness crack size based on Lamb wave scattering in aluminium plates", NDT&E Int., 41(1), 59-68. https://doi.org/10.1016/j.ndteint.2007.07.003
  19. Lu, Y., Ye, L., Wang, D. and Zhong, Z.R. (2009), "Time-domain analyses and correlations of Lamb wave signals for damage detection in a composite panel of multiple stiffeners", J. Compos. Mater., 43(26), 3211-3230. https://doi.org/10.1177/0021998309345332
  20. Monnier, T. (2006), "Lamb waves-based impact damage monitoring of a stiffened aircraft panel using piezoelectric transducers", J. Intel. Mat. Syst. Str., 17(5), 411-421. https://doi.org/10.1177/1045389X06058630
  21. Park, M.H., Kim, I.S. and Yoon, Y.K. (1996), "Ultrasonic inspection of long steel pipes using Lamb waves", NDT&E Int., 29(1), 13-20. https://doi.org/10.1016/0963-8695(95)00030-5
  22. Pei, J., Yousuf, M.I., Degertekin, F.L., Honein, B.V. and Khuri-Yakub, B.T. (1996), "Lamb wave tomography and its application in pipe erosion/corrosion monitoring", Res. Nondestruct. Eval., 8(4), 189-197. https://doi.org/10.1080/09349849609409599
  23. Pu, S.H., Cegla, F., Drozdz, M., Lowe, M.J.S., Cawley, P. and Buenfeld, N.R. (2004), "Monitoring the setting and early hardening of concrete using an ultrasonic waveguide", Insight, 46(6), 350-354. https://doi.org/10.1784/insi.46.6.350.56383
  24. Rizzo, P. and Lanza di Scalea, F. (2006), "Wavelet-based feature extraction for automatic defect classification in strands by ultrasonic structural monitoring", Smart Struct. Syst., 2(3), 253-274. https://doi.org/10.12989/sss.2006.2.3.253
  25. Rose, J.L. (1999), Ultrasonic Waves in Solid Media, Cambridge University Press, Cambridge, New York.
  26. Silk, M.G. and Bainton, K.F. (1979), "The propagation in metal tubing of ultrasonic wave modes equivalent to Lamb waves", Ultrasonics, 17(1), 11-19. https://doi.org/10.1016/0041-624X(79)90006-4
  27. Thwaites, S. and Clark, N.H. (1995), "Non-destructive testing of honeycomb sandwich structures using elastic waves", J. Sound Vib., 187(2), 253-269. https://doi.org/10.1006/jsvi.1995.0519
  28. Tua, P.S., Quek, S.T. and Wang, Q. (2005), "Detection of cracks in cylindrical pipes and plates using piezoactuated Lamb waves", Smart Mater. Struct., 14, 1325-1342. https://doi.org/10.1088/0964-1726/14/6/025
  29. Valle, C., Niethammer, M., Qu, J.M. and Jacobs, L.J. (2001), "Crack characterization using guided circumferential waves", J. Acoust. Soc. Am., 110(3), 1282-1290. https://doi.org/10.1121/1.1385899
  30. Wang, D., Ye, L. and Lu, Y. (2009), "A probabilistic diagnostic algorithm for identification of multiple notches using digital damage fingerprints (DDFs)", J. Intel. Mat. Syst. Str., 20(12), 1439-1450. https://doi.org/10.1177/1045389X09338323
  31. Zhang, L., Gavigan, B.J. and Rose, J.L. (2006), "High frequency guided wave natural focusing pipe inspection with frequency and angle tuning", J. Press. Vess.-T. ASCE, 128(3), 433-438. https://doi.org/10.1115/1.2218348
  32. Zhao, X., Gao, H.D., Zhang, G.F., Ayhan, B., Yan, F., Kwan, C. and Rose, J.L. (2007) "Active health monitoring of an aircraft wing with embedded piezoelectric sensor/actuator network: I. Defect detection, localization and growth monitoring", Smart Mater. Struct., 16(4), 1208-1217. https://doi.org/10.1088/0964-1726/16/4/032
  33. Zhou, L., Yuan, F.G. and Meng, W.J. (2007), "A pre-stack migration method for damage identification in composite structures", Smart Struct. Syst., 3(4), 439-454. https://doi.org/10.12989/sss.2007.3.4.439

피인용 문헌

  1. Monitoring of delamination onset and growth during Mode I and Mode II interlaminar fracture tests using guided waves vol.72, pp.2, 2012, https://doi.org/10.1016/j.compscitech.2011.10.004
  2. Ultrasonic characterization of exhumed cast iron water pipes vol.7, pp.4, 2010, https://doi.org/10.12989/sss.2011.7.4.241
  3. An experimental procedure for evaluating the consolidation state of marine clay deposits using shear wave velocity vol.7, pp.4, 2010, https://doi.org/10.12989/sss.2011.7.4.289
  4. A split spectrum processing of noise-contaminated wave signals for damage identification vol.10, pp.3, 2010, https://doi.org/10.12989/sss.2012.10.3.253
  5. On FEM modeling of piezoelectric actuators and sensors for thin-walled structures vol.9, pp.5, 2010, https://doi.org/10.12989/sss.2012.9.5.411
  6. The medium coupling effect on propagation of guided waves in engineering structures and human bone phantoms vol.1, pp.4, 2010, https://doi.org/10.12989/csm.2012.1.4.297
  7. Sparse reconstruction of guided wavefield from limited measurements using compressed sensing vol.25, pp.3, 2010, https://doi.org/10.12989/sss.2020.25.3.369