Radiolytic Preparation and Characterization of Poly(styrene sulfonic acic)-grafted ETFE Membranes

스타이렌 술폰산 고분자가 그래프트된 ETFE 막의 방사선 제조 방법 및 특성 분석

  • Ko, Beom-Seok (Radiation Research Division for Industry and Environment Advanced Radiation Technology Institute, Korea Atomic Energy Research Institute) ;
  • Kang, Sung-A (Radiation Research Division for Industry and Environment Advanced Radiation Technology Institute, Korea Atomic Energy Research Institute) ;
  • Fei, Geng (Radiation Research Division for Industry and Environment Advanced Radiation Technology Institute, Korea Atomic Energy Research Institute) ;
  • Jeun, Joon-Pyo (Radiation Research Division for Industry and Environment Advanced Radiation Technology Institute, Korea Atomic Energy Research Institute) ;
  • Nho, Young-Chang (Radiation Research Division for Industry and Environment Advanced Radiation Technology Institute, Korea Atomic Energy Research Institute) ;
  • Kang, Phil-Hyun (Radiation Research Division for Industry and Environment Advanced Radiation Technology Institute, Korea Atomic Energy Research Institute) ;
  • Kim, Chong-Yeal (Department of Radiation Science & Technology, Chonbuk National University) ;
  • Shin, Jun-Hwa (Radiation Research Division for Industry and Environment Advanced Radiation Technology Institute, Korea Atomic Energy Research Institute)
  • 고범석 (한국원자력 연구원 정읍방사선과학연구소 방사선공업환경연구부) ;
  • 강성아 (한국원자력 연구원 정읍방사선과학연구소 방사선공업환경연구부) ;
  • 경비 (한국원자력 연구원 정읍방사선과학연구소 방사선공업환경연구부) ;
  • 전준표 (한국원자력 연구원 정읍방사선과학연구소 방사선공업환경연구부) ;
  • 노영창 (한국원자력 연구원 정읍방사선과학연구소 방사선공업환경연구부) ;
  • 강필현 (한국원자력 연구원 정읍방사선과학연구소 방사선공업환경연구부) ;
  • 김종일 (전북대학교 방사선과학기술학과) ;
  • 신준화 (한국원자력 연구원 정읍방사선과학연구소 방사선공업환경연구부)
  • Published : 2010.01.25

Abstract

In this study, ETFE-g-PSSA membranes with various degrees of grafting (DOG) and thicknesses were prepared by a simultaneous irradiation method. SEM-EDX instrument was applied to measure the relative distribution of sulfur which is corresponding to that of a grafted polymer over the Cross-section of the ETFE-g-PSSA membranes prepared at various irradiation conditions. The results indicate that to obtain the evenly-grafted membranes, a styrene/dichloromethane ratio is needed to be under 60 (v/v%), and a higher DOG is required as the film thickness increases. The effects of DOG and thickness on the ion exchanging capacity (IEC) and water uptake (WU) were investigated by measuring the IEC and WU values of the membranes with various DOG and thicknesses.

본 연구에서는 방사선 동시조사법을 이용하여 다양한 그래프트율과 두께를 가진 ETFE-g-PSSA막을 제작하였다. 다양한 방사선 조사조건에서 제조된 ETFE-g-PSSA 막들은 SEM-EDX 기기를 이용하여 막 내부의 황(sulfur) 원소의 상대적 분포도를 측정하여 그래프트 고분자의 막 단면 분포경향을 연구하였다. 본 연구 결과 균일한 그래프트 고분자의 분포도를 갖는 ETFE-g-PSSA막을 제작하기 위해서는 스타이렌 단량체는 디클로로메탄 용액에서 60(v/v%) 이하여야 하고 두께가 두꺼울수록 높은 그래프트율을 얻어야 함을 확인하였다. 다양한 두께와 그래프트율을 가진 막들의 이온교환용량(IEC)과 함수율(water uptake)을 측정하여 막 두께와 그래프트율에 의한 영향을 평가하였다.

Keywords

References

  1. J. Shin, B. S. Ko, S. A. Kang, G. Fei, Y. C. Nho, and P. H. Kang, Nucl.lnstrum. Meth. B, 267, 791 (2009). https://doi.org/10.1016/j.nimb.2008.12.009
  2. B. S. Ko, J. Shin, J. Y. Sohn, Y. C. Nho, and P. H. Kang, Polymer(Korea), 33, 268 (2009).
  3. M. M. Nasef, Polym. lnt., 50, 338 (2001).
  4. J. A. Horsfall and K. V. Lovell, Eur. Polym. J., 38, 1671 (2002). https://doi.org/10.1016/S0014-3057(02)00031-9
  5. R. Rohani, M. M. Nasef, H. Saidi, and K. Z. M. Dahlan, Chem. Eng. J., 132, 27 (2007) https://doi.org/10.1016/j.cej.2007.01.011
  6. T. Hatanaka, N. Hasegawa, A. Kamiya, M. Kawasumi, Y Morimoto, and K. Kawahara, Fuel, 81, 2173 (2002). https://doi.org/10.1016/S0016-2361(02)00164-3
  7. H. P. Brack, H. G. Buhrer, L. Bonorand, and G. G. Scherer, J. Mater. Chem., 10, 1795 (2000) https://doi.org/10.1039/b001851l
  8. J. Chen, M. Asano, Y. Maekawa, and M. Yoshida, J. Membrane Sci., 277, 249 (2006). https://doi.org/10.1016/j.memsci.2005.10.036
  9. H. B. Youcef, S. A. Gursel, A. Wokaun, and G. G. Scherer, J. Membrane Sci, 311, 208 (2008). https://doi.org/10.1016/j.memsci.2007.12.015
  10. I. Guilmeau, S. Esnouf, N. Betz, and A. L. Moel, Nucl. lnstrum. Meth. B, 131, 270 (1997)
  11. Y. Kimura, J. Chen, M. Asano, Y. Maekawa, R. Katakai, and M. Yoshida, Nucl. lnstrum. Meth. B, 263, 463 (2007). https://doi.org/10.1016/j.nimb.2007.07.010
  12. L. Gubler, N. Prost, S. A. Gursel, and G. G. Scherer, Solid State lonics, 176, 2849 (2005). https://doi.org/10.1016/j.ssi.2005.09.045
  13. Y. Kimura, M. Asano, J. Chen, Y. Maekawa, R. Katakai, and M. Yoshida, Radiat. Phys. Chem., 77, 864 (2008). https://doi.org/10.1016/j.radphyschem.2007.12.012
  14. S. Takahashi, H. Okonogi, T. Hagiwara, and Y. Maekawa, J. Membrane Sci., 324, 173 (2008) https://doi.org/10.1016/j.memsci.2008.07.012
  15. T. Momose, H. Yoshioka, I. Ishigaki, and J. Okamoto, J. Appl. Polym. Sci., 37, 2817 (1989). https://doi.org/10.1002/app.1989.070371003
  16. M. M. Nasef, Prog. Polym., 29, 449 (2004).
  17. B. Gupta and G. G. Scherer, J. Appl. Polym. Sci., 50, 2129 (1993) . https://doi.org/10.1002/app.1993.070501212