The Transactions of the Korean Institute of Power Electronics (전력전자학회논문지)

The Korean Institute of Power Electronics (전력전자학회)
권호 표지
DOI QR코드

DOI QR Code

Electronic Ballast Design Driven by Low Frequency Square Wave for High Power MHL

고출력 MHL용 구형저주파 구동 방식의 전자식 안정기 설계

  • Received : 2010.08.16
  • Accepted : 2010.08.30
  • Published : 2010.10.20
Download PDF
⟨ Previous Next ⟩

Abstract

In this paper, We proposed electronic ballast that applys Buck Converter operation principle to Full-Bridge inverter. The proposed ballast consists of an EMI Filter, a full-bridge rectifier, a passive power factor correction (PFC) circuit and a full-bridge inverter. The passive PFC is used and a Full-Bridge inverter operation by two frequency. High Side and Low Side switch was driven by high frequency and low frequency and realized buck Converter's operation. The lamp is driven by Low Frequency square wave to avoid Acoustic Resonance. Also, bulk of inductor is reduced by high frequency switching. Performance of the proposed ballast was validated through computer simulation using Pspice, experimentation and by applying it to an electronic ballast for a prototype 700W MHL.

본 논문에서는 Buck Converter 동작 원리를 Full -Bridge Inverter에 적용한 전자식 안정기를 제안하였다. 전자식안정기는 EMI 필터, 수동 PFC, Full-Bridge Inverter로 2-stage로 구성되어 있다. PFC는 신뢰성 확보를 위해 수동 PFC를 사용하였다. Full-Bridge Inverter는 High Side와 Low Side 스위치의 구동 주파수를 각각 고주파와 저주파로 구동하여 Buck Converter의 동작을 구현 하였다. 램프를 저주파수 구형파로 구동하여 음향공명현상을 피하게 되었으며, 고주파수 스위칭으로 인덕터의 부피를 줄였다. 제안한 방법은 시뮬레이션과 실험을 통해 증명하였다.

Keywords

References

  1. 박종연, 이봉진, 김기남, "음향 공명 현상을 제거한 MHL 용 고출력 전자식 안정기 설계", 대한전기학회, Vol. 57, pp. 1187-1194, 2008.
  2. Weiping Zhang, Yuanchao Liu, Xiaoqiang Zhang, Hongtao Li and Wenji Liu, "Low Frequency Model for the Metal Halide Lamp", IPEMC 2006, Vol. 2, pp. 14-16, 2006.
  3. Mangesh Borage, Sunil Tiwari and S.Kotaiah, "Passive Techniques for Compliance of Single-phase Rectifiers with IEC 1000-3-2 Norms", Processing of INCEMIC, 2003.
  4. Moo. C.S., Huang. C.K., Lee. K.H., Huang. D.J., "Two-stage electronic ballast for metal halide lamps with embedded buck-conversion and ignition circuit", ISIEA 2009, Vol. 2, pp. 895-899, 2009.
  5. K.N.Sakthivel, Sisir K.Das, K.R.Kini, "Importance of Quality AC Power Distribution and Understanding of EMC Standards IEC 61000-3-2, IEC 61000-3-3 & IEC 61000-3-11", Proceeding of INCEMIC, 2003.
  6. Mangesh Borage, Sunil Tiwari and S.Kotaiah, "Passive Techniques for Compliance of Single-phase Rectifiers with IEC 1000-3-2 Norms", Processing of INCEMIC, 2003.
  7. Donald Schelle, jorge Castorena, "Buck-Converter Design Demystified", Power Electronics Technology, 2006, June.
  8. 김기남, 박종연, 최영민, "음향 공명 제거 및 과도 상태 전류를 제한시킨 고출력 메탈 헬라이드 램프용 전자식 안정기 설계", 대한전기학회, Vol. 59, pp. 904-911, 2010.

Cited by

  1. Development of a metal-halide lamp's electronic ballast vol.49, pp.2, 2013, https://doi.org/10.3796/KSFT.2013.49.2.116