DOI QR코드

DOI QR Code

Electrochemical Evaluation on Corrosion Resistance of Anti-corrosive Paints

  • Moon, Kyung-Man (Dept of Mechanical and Material Engineering, Korea Maritime Univ.) ;
  • Lee, Myung-Hoon (Dept. of Marine System Engineering, Korea, Maritime Univ.) ;
  • Kim, Yun-Hae (Dept of Mechanical and Material Engineering, Korea Maritime Univ.)
  • 발행 : 2009.05.31

초록

It has been observed that coated steel structures are rapidly deteriorated than designed lifetime due to acid rain caused by air pollution etc.. Therefore improvement of corrosion resistance of anti-corrosive paint is very important in terms of safety and economic point of view. In this study corrosion resistance for five kinds of anti-corrosive paints including acryl, fluorine and epoxy resin series were investigated with electrochemical methods such as corrosion potential, polarization curves, impedance and cyclic voltammogram measurements etc.. There were somewhat good relationships between values measured by electrochemical methods such as corrosion current density obtained by cathodic and anodic polarization curves, value of impedance estimated with AC impedance, and polarization resistance on the cyclic voltammogram, for example, corrosion current density was decreased with increasing of values of impedance and polarization resistance on the cyclic voltammogram. However their relationships between corrosion current density and corrosion potential were not well coincided each other. Consequently it is considered that although a corrosion potential of F101 of fuoric resin series shifted to negative direction than other anti-corrosive paints, its corrosion resistance, indicating on the cathodic and anodic polarization curves, AC impedance curves and cyclic voltammogram, was the most superior to other paints, whereas A100 containing arcylic resin showed a relatively poor corrosion resistance compared to other paints.

키워드

참고문헌

  1. P. Cicognami, "Application of the boundary-element method to offshore cathodic protection modeling", Journal of .Electrochem. Soc., Vol. 137, No. 6, pp. 1689-1695, 1990 https://doi.org/10.1149/1.2086771
  2. K.G. Compton, "Factor involved in corrosion of lead cable sheath", CORROSION, Vol. 17, pp. 115-118, 1961
  3. P.O. Gartland, E. Bardel, R.E. Andresen, and R. Johnson, "Effect of flow on the cathodic protection of a steel cylinder in sea water", CORROSION, Vol. 40, No. 3, pp. 127-133. 1984 https://doi.org/10.5006/1.3593927
  4. M. Hiramatsi, M. Hino and T. Omi. "Current trend in development of corrosion protective plating", Zairo-to-Kankyo, Vol. 45, No. 1, pp. 33-41, 1996 https://doi.org/10.3323/jcorr1991.45.33
  5. D.A. Jones and N.R. Nair. "Electrochemical corrosion studies on zinc-coated steel", CORROSION, Vol. 41, No. 6, pp. 357-362, 1985 https://doi.org/10.5006/1.3582017
  6. J. Newman, "Cathodic protection with parrel cylinders", Journal of Electrochem. Soc., Vol. 130, No. 12, pp. 3554-3559, 1991
  7. U. Steinsmo and E. Bardal. "Factors limiting the cathodic current on painted steel", Journal of Electrochem.Soc., Vol. 136, No. 12, pp. 3588-3594. 1989 https://doi.org/10.1149/1.2096514
  8. U. Steinsmo, J.I. Ska, and E. Bardal, "The effect of the dry film thickness, temperature and electrolyte on the cathodic current of painted steel", Journal of Electrochem.Soc., Vol. 136, No. 12, pp. 3383-3587, 1989
  9. Japan Society of Corrosion Control Technology, "Report of corrosion damage research", pp. 15, 1977
  10. The Overseas Coastal Area Development Institute of Japan, "Corrosion protection and repair manual for port and harbor steel structures", pp. 27-96, 1998
  11. J.D. Talati, G.A. Patel, and D.K. Gandhi, "Maximum utilization current density", CORROSION, Vol. 40, No. 2, pp. 88-91, 1984 https://doi.org/10.5006/1.3593921
  12. H.J. Sung, J.G. Kim, M.H. Lee, K.J. Kim, and K.M. Moon. "An electrochemical evaluation on corrosion resistance of anti-corrosive paint", Journal of Korean Society of Marine Engineering, Vol. 29, No. 5, pp. 519-525, 2005
  13. K.M. Moon, M.H. Lee, H.M. Kim, I.N. Lee, and H.H. Chun,. "The effect of additives to corrosion resistance of heavy anti-corrosive paint", J. of Ocean Eng. and Tec., Vol. 21, No. 3, pp. 65-70, 2007
  14. J.G. Jang, Y.G. Lee, H.J. Sung, "Painting industrial chemistry" Edited by Dong yui Industrial College, pp. 177-178, 2003