DOI QR코드

DOI QR Code

Compressibility of Changi sand in K0 consolidation

  • Wanatowski, D. (Nottingham Centre for Geomechanics, Faculty of Engineering, University of Nottingham) ;
  • Chu, J. (School of Civil and Environmental Engineering, Nanyang Technological University) ;
  • Gan, C.L. (SPS Overlay Asia Pte Ltd., 1 Maritime Square, Harbour Front Centre)
  • 투고 : 2009.07.15
  • 심사 : 2009.08.28
  • 발행 : 2009.09.25

초록

The one-dimensional compressibility of sand is an important property for the estimation of settlement or deformation of sand deposits. The $K_0$ value of sand is also an important design parameter. Experimental results are presented in this paper to study the compressibility of sand in $K_0$ consolidation tests. The $K_0$ consolidation tests were carried out using a triaxial cell and a plane-strain apparatus. Specimens prepared using both the moist tamping and the water sedimentation methods were tested. The testing data demonstrate that the type of testing apparatus does not affect the $K_0$ measurement if proper boundary conditions are imposed in the tests. The data also show that the compressibility and the $K_0$ value of loose sand specimens prepared using the moist tamping method are very sensitive to the variation of void ratio. The $K_0$ values measured from these tests do not agree with the $K_0$ values calculated from Jaky's equation. The compressibility and $K_0$ values of sand obtained from tests on specimens prepared using different preparation methods are different which may reflect the influence of soil fabrics or structures on the one dimensional compression behavior of sand.

키워드

참고문헌

  1. Abdelhamid, M.S. and Krizek, R.J. (1976), "At-rest lateral earth pressure of a consolidating clay", J. Geotech. Eng. Div., ASCE, 102(7), 712-738.
  2. Alshibli, A.K., Batiste, S.N. and Sture, S. (2003), "Strain localization in sand: plane strain versus triaxial compression", J. Geotech. Geoenviron. Eng., 129(6), 483-494. https://doi.org/10.1061/(ASCE)1090-0241(2003)129:6(483)
  3. ASTM, Standard D2487, "Standard Practice for Classification of Soils for Engineering Purposes (Unified Soil Classification System)," Annual Book of ASTM Standards, 04.08, D420-D5876.
  4. ASTM, Standard D4253, "Standard Test Methods for Maximum Index Density and Unit Weight of Soils Using a Vibratory Table," Annual Book of ASTM Standards, 04.08, D420-D5876.
  5. ASTM, Standard D4254, "Standard Test Methods for Minimum Index Density and Unit Weight of Soils and Calculation of Relative Density," Annual Book of ASTM Standards, 04.08, D420-D5876.
  6. Bishop, A.W. (1966), "Strength of soil as engineering materials", Geotechnique, 16(2), 89-130.
  7. Cornforth, D.H. (1964), "Some experiments on the influence of strain conditions on the strength of sand", Geotechnique, 14(2), 143-167 https://doi.org/10.1680/geot.1964.14.2.143
  8. Chu, J. and Gan, C.L. (2004), "Effect of void ratio on K0 of loose sand", Geotechnique, 54(4), 285-288. https://doi.org/10.1680/geot.2004.54.4.285
  9. Chu, J. and Leong, W.K. (2001), "Pre-failure strain softening and pre-failure instability of sand: a comparative study", Geotechnique, 51(4), 311-321. https://doi.org/10.1680/geot.2001.51.4.311
  10. Chu, J. and Lo, S.C.R. (1991), "On the implementation of strain path testing", Proceedings of the 10th European Conference on Soil Mechanics and Foundation Engineering, Florence, May.
  11. Chu, J., Lo, S.C.R. and Lee, I.K. (1992), "Strain-softening behaviour of granular soil in strain path testing", J. Geotech. Eng., 118(2), 191-208. https://doi.org/10.1061/(ASCE)0733-9410(1992)118:2(191)
  12. Chu, J., Lo, S.C.R. and Lee, I.K. (1993), "Instability of granular soils under strain path testing", J. Geotech. Eng., 119(5), 874-892. https://doi.org/10.1061/(ASCE)0733-9410(1993)119:5(874)
  13. Coop, M.R. and Atkinson, J.H. (1993), "The mechanics of cemented carbonate sands", Geotechnique, 43(1), 53-67. https://doi.org/10.1680/geot.1993.43.1.53
  14. Daramola, O. (1980), "On estimating $K_{0}$ for overconsolidated granular soils", Geotechnique, 30(3), 310-313. https://doi.org/10.1680/geot.1980.30.3.310
  15. El-Sohby, M.A. (1969), "Deformation of sand under constant stress ratio". Proceedings of the 7th International Conference on Soil Mechanics and Foundation Engineering, Mexico.
  16. Frost, J.D. and Jang, D.J. (2000), "Evolution of sand microstructure during shear", J. Geotech. Geoenviron. Eng., 126(2), 116-130. https://doi.org/10.1061/(ASCE)1090-0241(2000)126:2(116)
  17. Frost, J.D. and Park, J.Y. (2003), "A critical assessment of the moist tamping technique", Geotech. Test. J., 26(1), 1-14.
  18. Fukagawa, R. and Ohta, H. (1988), "Effect of some factors on $K_{0}$-value of a sand", Soils Found., 28(4), 93-106. https://doi.org/10.3208/sandf1972.28.4_93
  19. Gan, C.L. (2002), Instability of granular soils under general stress conditions, M.Eng. thesis, Nanyang Technological University, Singapore.
  20. Jaky, J. (1944), "The coefficient of earth pressure at rest", J. Soc. Hung. Arch. Eng., 25, 355-358.
  21. Jardine, R.J. (1992), "Some observations on the kinematic nature of soil stiffness", Soils Found., 32(2), 111-124. https://doi.org/10.3208/sandf1972.32.2_111
  22. Kuo, C.Y. and Frost, J.D. (1996), "Uniformity evaluation of cohesionless specimens using digital image analysis", J. Geotech. Eng., 122(5), 390-396. https://doi.org/10.1061/(ASCE)0733-9410(1996)122:5(390)
  23. Ladd, R.S. (1974), "Specimen preparation and liquefaction of sand", J. Geotech. Eng. Div., ASCE, 100(10), 1180-1184.
  24. Ladd, R.S. (1978), "Preparing test specimens using undercompaction", Geotech. Test. J., 1(1), 16-23. https://doi.org/10.1520/GTJ10364J
  25. Leong, W.K., Chu, J. and Teh, C.I. (2000), "Liquefaction and instability of a granular fill material", Geotech. Test. J., 23(2), 178-192. https://doi.org/10.1520/GTJ11042J
  26. Leroueil, S. and Vaughan, P.R. (1990), "The general and congruent effects of structure in natural soils and weak rocks", Geotechnique, 40(3), 467-488. https://doi.org/10.1680/geot.1990.40.3.467
  27. Lo, S.C.R. and Chu, J. (1991), "The measurement of $K_{0}$ by triaxial strain path testing", Soils Found., 31(2), 181-187.
  28. Lo, S.C.R., Chu, J. and Lee, I.K. (1989), "A technique for reducing membrane penetration and bedding errors", Geotech. Test. J., 12(4), 311-316. https://doi.org/10.1520/GTJ10991J
  29. Mayne, P.W. and Kulhawy, F.H. (1982), "$K_{0}$-OCR relationships in soil", J. Geotech. Eng. Div., ASCE, 108(6), 851-872.
  30. Menzies, B.K. (1988), A computer controlled hydraulic testing system, Advanced Triaxial Testing of Soil and Rock, (Eds. Donaghe, R.T., Chaney, R.C. and Silver, M.L.), American Society for Testing and Materials, Philadelphia.
  31. Mesri, G. and Hayat, T.M. (1993), "The coefficient of earth pressure at rest", Can. Geotech. J., 30, 647-666. https://doi.org/10.1139/t93-056
  32. Michalowski, R.L. (2005), "Coefficient of earth pressure at rest", J. Geotech. Geoenviron. Eng., 131(11), 1429-1433. https://doi.org/10.1061/(ASCE)1090-0241(2005)131:11(1429)
  33. Okochi, K. and Tatsuoka, F. (1984), "Some factors affecting $K_{0}$-value of sand measured in triaxial cell", Soils Found., 24(3), 52-68. https://doi.org/10.3208/sandf1972.24.3_52
  34. Rowe, P.W. and Barden, L. (1964), "Importance of free ends in triaxial testing", J. Soil Mech. Found. Div., 90(1), 1-15.
  35. Vaid, Y.P., Sivathayalan, S. and Stedman, D. (1999), "Influence of specimen reconstituting method on the undrained response of sand", Geotech. Test. J., 22(3), 187-195. https://doi.org/10.1520/GTJ11110J
  36. Vatsala, A., Nova, R. and Srinivasa Murthy, B.R. (2001), "Elastoplastic model for cemented soils", J. Geotech. Geoenviron. Eng., 127(8), 679-687. https://doi.org/10.1061/(ASCE)1090-0241(2001)127:8(679)
  37. Wanatowski, D. (2005), Strain softening and instability of sand under plane-strain conditions, PhD thesis, Nanyang Technological University, Singapore.
  38. Wanatowski, D. and Chu, J. (2006), "Stress-strain behavior of a granular fill measured by a new plane-strain apparatus", Geotech. Test. J., 29(2), 149-157.
  39. Wanatowski, D. and Chu, J. (2007a), "$K_{0}$ of sand measured by a plane-strain apparatus", Can. Geotech. J., 44(8), 1006-1012. https://doi.org/10.1139/t07-038
  40. Wanatowski, D. and Chu, J. (2007b), "Drained behaviour of Changi sand in triaxial and plane-strain compression", Geomech. Geoeng., 2(1), 29-39. https://doi.org/10.1080/17486020601173193
  41. Wanatowski, D. and Chu, J. (2008), "Effect of specimen preparation method on the stress-strain behavior of sand in plane-strain compression tests", Geotech. Test. J., 31(4), 308-320.
  42. Wood, F.M., Yamamuro, J.A. and Lade, P.V. (2008), "Effect of depositional method on the undrained response of silty sand", Can. Geotech. J., 45(11), 1525-1537. https://doi.org/10.1139/T08-079
  43. Yamamuro, J.A. and Wood, F.M. (2004), "Effect of depositional method on the undrained behavior and microstructure of sand with silt", Soil Dyn. Earthq. Eng., 24(10), 751-760. https://doi.org/10.1016/j.soildyn.2004.06.004

피인용 문헌

  1. Evaluation of preconsolidation stress by shear wave velocity vol.7, pp.4, 2011, https://doi.org/10.12989/sss.2011.7.4.275
  2. The microscopic origin of K0 on granular soils: the role of particle shape vol.16, pp.7, 2009, https://doi.org/10.1007/s11440-021-01161-5